first differential parameter 中文意思是什麼

first differential parameter 解釋
第一微分參數
  • first : adj 1 最初的，最早的。2 最上等的，第一流的。3 基本的，概要的。4 高音（調）的。n 1 最初，第一；第...
  • differential : adj 1 差別的，區別的；特定的。2 【數學】微分的。3 【物、機】差動的，差速的，差示的。n 1 （鐵路不...
  • parameter : n. 1. 【數學】參數，變數；參詞；參項。2. 【物理學】參量；（結晶體的）標軸。3. 〈廢語〉【天文學】通徑。vt. -ize 使參數化。
  1. Collisonal quantum interference ( cqi ) was observed in the intramolecular rotational energy transfer in the experiment of the static cell, and the integral interference angles were measured. to observe more precise information, the experiment in the molecular beam should be taken, from which the differential interference angle can be obtained precisely. in this paper, the theoretical model of cqi is described in an atom - diatom system in the condition of the molecular beam, based on the first - born approximation of time dependent perturbation theory, taking into accounts the anisotropic lennard - jones interaction potentials. the method of observing and measuring correctly the differential interference angle is presented. the changing tendencies of the differential interference angle with the impact parameter, velocity, and et al. are discussed

    分子內部轉動傳能的靜態池實驗觀察到了碰撞量子干涉效應（ cqi ） ，並且測得積分干涉角，為了獲得更加精確的分子內部轉動傳能的碰撞量子干涉效應信息，實驗就必須要採用分子束實驗進行.本文理論上採用各項異性相互作用勢，應用含時微擾理論的一級波恩近似，假想在分子束實驗的條件下，建立在原子-雙原子分子體系中碰撞量子干涉的理論模型.理論上推導出微分干涉角具體表達式，通過計算定性地討論了微分干涉角隨著碰撞參數、速率等的變化趨勢，同時初步探討了實驗的正確觀測途徑，得出了採用分子束進行實驗觀測的實驗方法，為進一步進行分子束實驗提供了理論基礎，對實驗的進行起到了一定的借鑒作用
  2. The optimal performance state ' s parameter of thermoelectric refrigerator under different work conditions was obtained on the assumption that the temperature in the cold side is invariable. and, the optimal performance state ' s parameter of thermoelectric refrigerator under the third kind boundary conditions was also obtained. the transmission of heat differential equation for the heat conduction process of thermoelectric module was derived and the solution with the first kind boundary conditions under the influence of thomson effect and the solution with the third kind boundary conditions without the influence of thomson effect was obtained

    在假設熱電製冷的熱端溫度固定的條件下，得出熱電製冷器在不同工況下的最佳工作參數並進一步求得在三類邊界條件下的最佳工作參數;導出了電偶臂在電與熱的偶合作用下傳熱微分方程，並對其進行解析求解:在考慮湯姆遜效應的影響下得出一類跟三類邊界條件下傳熱方程的解析解，在忽略湯姆遜效應的影響下得出二類跟三類相的邊界條件下傳熱方程的解析解。
  3. Abstract : in order to solve the double parameters enveloped in the geartooth flank generating, the complicated double parameter envelope is simplified to the generating process between work - piece and imaginary crown generating gear by means of mathematical transformation. the equation of the imaginary crown generating surface and the partial derivatives are deduced, so the differential geometric parameters of the generating surface can be obtained. by analyzing the generating motion between the imaginary crown generating gear and the work - piece, all the first to third order geometric parameters of the generated tooth flank at any given point can be calculated

    文摘:為了解決直接求解展成法加工中存在的復雜雙參數包絡問題時的困難，提出通過數學變換，將此包絡問題轉化為假想平面產形輪與工件之間的展成問題來進行研究.推導了假想產形面的方程和各階偏導矢，於是可獲得產形面的微分幾何參數.通過分析假想平面產形輪與工件之間的展成運動，即可得到被展成齒面上任意指定點的全部一至三階微分幾何參數
  4. When impact applies on a discrete system in which one of constraints is a constant with coulomb friction, the phenomenon of slip - stick at the point can cause the change of friction and the integration for frictional force during infinitesimal impulsive interval becomes impossible according to traditional impulsive dynamics of discrete systems. by introducing a new dimensional time parameter, first - order momentum - impulse differential equations are obtained and the discussion over infinitesimal impulsive interval is transformed into a piece - wise study on the finite region of impulse

    在引入新的無量綱的時間參數后，通過建立相應的動量-沖量的一階微分方程，在趨近於零的沖擊區間的討論變為在有限區間中來分段研究含滑動-黏滯的沖擊過程，得到了受到多點打擊的離散系統考慮庫侖摩擦時的動力學的求解方法，即根據沖擊前的初始狀態無需回到繁瑣的微分方程的求解便可以得到沖擊后系統的動力學響應。
  5. By the first integral method and properties of integral depending on a parameter, the necessary and sufficient condition on the existence of dead core solution for the boundary value of a class of nonlinear ordinary differential equations has been specifically constructed

    應用首次積分法並結合含參變量積分的性質，具體構造了一類二階非線性常微分方程邊值問題存在非負死角解的充分必要條件
  6. Abstract : by the first integral method and properties of integral depending on a parameter, the necessary and sufficient condition on the existence of dead core solution for the boundary value of a class of nonlinear ordinary differential equations has been specifically constructed

    文摘:應用首次積分法並結合含參變量積分的性質，具體構造了一類二階非線性常微分方程邊值問題存在非負死角解的充分必要條件
  7. Factors that affect two - phase flow pressure drop are discussed in details at first. polynomial is used to fit the relation between property of differential pressure signal and lockhart - martinelli parameter x. based on the relation, a dual - parameter identification scheme using only differential pressure signal is given

    討論了影響兩相流壓降的因素，用多項式擬合的方法研究了不同流型下差壓信號方差與lockhart ? martinelli參數x之間的函數關系。
分享友人
分享到 Line

分享到臉書