flange gasket 中文意思是什麼

flange gasket 解釋
法蘭襯墊
  • flange : n. 1. 【機械工程】法蘭（盤）；凸緣；邊凸緣製造機。2. （鐵路軌的）寬底。3. 【建築】（梁）翼緣。vt. 在…上安裝凸緣。 a flanged wheel 凸緣輪。
  • gasket : n. 1. 【航海】束帆索。2. 【機械工程】墊圈，墊片。
  1. Blind flange gasket

    法蘭盲板墊片
  2. The gasket cavity should face out to the adjoining flange

    墊圈的空穴應該面向臨近法蘭的外面。
  3. Flanges and their joints - design rules for gasketed circular flange connections - part 2 : gasket parameters ; german version env 1591 - 2 : 2001

    法蘭及其接頭.帶襯墊的圓形法蘭接頭設計規則.第2部分
  4. Power take - off, squared shaft drive. two stud flange without oil seal gasket

    動力啟動方軸傳動裝置.銷法蘭.無油密封墊圈
  5. Apply silicon sealer / lubricant to the inner and outer diameters of the flange kit gasket, and press the gasket onto the valve body end

    將硅密封/潤滑劑施加在法蘭組件墊圈的內徑和外徑上，將墊圈壓在閥體埠上。
  6. In view of the high demand on the coaxial tolerance of linear induction accelerator in centering assembling and considering the interaction among flange, bolts and gasket, finite element analysis was adopted and a 3 - d finite element model of accelerator in centering assembling with bolted - flange connection was built

    摘要針對直線感應加速器對中裝配同軸度要求高的特點，考慮法蘭、螺栓和密封墊相互作用，建立了加速器對中裝配法蘭螺栓聯接的三維有限元模型，分析了螺栓預緊力對加速器對中裝配時同軸度的影響作用。
  7. Power take - off, squared shaft drive. four stud flange without oil seal gasket

    動力啟動方軸傳動裝置.孔法蘭.無油密封墊圈
  8. Flange connections with lens shaped gasket

    帶透鏡形墊片的法蘭連接
  9. The flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping

    在安裝期間，閘閥上的法蘭墊圈螺栓應該重新緊固，因為在庫存和運輸時螺栓可能會鬆懈。
  10. Note : the flange gasket bolts for the gate valves should be retightened during installation as the bolts may have loosened due to storage and shipping

    注意：閘閥的法蘭墊圈螺栓在安裝期間應該重新緊固，因為在庫存和運輸時這些螺栓可能會鬆懈。
  11. Analysis of pre - tightened stress has been made on pre - stress of low - pressure flange ' s spiral wound gasket, and through changing structure and controlling the manufacture process of gasket, some experiment studies have been made to let mechanical performance meet the needs of bolt load and let flange joint meet the needs of seal behavior

    摘要分析了低壓管法蘭用纏繞式墊片的預緊應力，對通過墊片工藝結構的調整使其力學性能與緊固件的要求一致，從而使法蘭接頭符合操作的密封性要求進行了試驗研究。
  12. The gasket face of the flange should squarely contact the face of the mating flange

    法蘭墊圈面應該與配套法蘭面均勻接觸。
  13. Involving interaction of gasket, bolts and flange rings, the load - deformation and the structural fuzzy reliability of each component are analyzed in the case of ideality, external loads and creep - relaxation respectively. and then, the sealing fuzzy reliability of the flanged connection system is researched. the function of each part of genetic algorithm is analyzed in application to nonlinear unconstrained and constrained optimization

    本文將墊片、螺栓和法蘭作為一個相互作用的整體，比較深入地分析了理想情況下、有外載作用及蠕變-鬆弛影響下，平墊片和0形圈這兩種典型的火箭發動機法蘭連接系統各元件的載荷與變形、元件的結構可靠度和火箭發動機法蘭系統的密封可靠度。
分享友人
分享到 Line

分享到臉書