flow chamber 中文意思是什麼
flow chamber
解釋
流式小室-
This paper summarizes the diuresis therapy in synopsis of the golden chamber, including activating qi, tonifying qi, warming yang, promoting defecation and urination, inducing diaphoresis, clearing heat, nourishing yin, promoting blood flow, lubricating the bladder, and so on, to promote diuresis, each with a representative prescription to elucidate the main points of the syndrome differentiation and treatment
摘要總結《金匱要略》利水法的特點為：化氣利水、益氣利水、溫陽利水、通下利水、發汗利水、清熱利水、滋陰利水、活血利水、滑竅利水等，並逐一列舉代表性方劑，分析證治要領。 -
A perturbation in pressure at the upstream end of the feed system could result in sizable oscillations in flow rate and chamber pressure.
供應系統上游端的壓力擾動可導致相當的流量和室壓振蕩。 -
4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity
結果表明，預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果，局部努謝爾數隨預旋角的增大而有所減小；隨旋轉雷諾數的增加，不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低：當軸向中心進氣質量流量不變時，隨預旋進氣的質量流量增加，內轉靜腔室的轉盤盤面上的換熱基本沒有變化，而預旋腔室的轉盤盤面上的換熱效果增強；當預旋進氣質量流量不變時，軸向中心進氣的質量流量的改變對整個盤腔都有影響。 -
Influence of ktb place on gas flow field in rh vacuum chamber
真空室氣體流動的影響 -
Straight - through type : one - way seal and eccentric structure, 90 rotation of ball on opening hidden in the valve body chamber, and straight - through flow channel without any locking and jamming
直通式：單向密封和偏心式結構，開啟時球體旋轉90 。 、球體藏在閥體球室，流道直通，不會出現卡、堵現象。 -
It is concluded that the combustion chamber passage area, passage direction, passage shape and passage position have a strong effect on in - cylinder current motion and flow speed
計算結果表明，燃燒室通道截面積、通道傾角、通道形狀、通道布置對氣流運動的形式及氣流速度均有較大的影響。 -
Contrast study on cold - flow mixing effect and combustion efficiency of afterburning chamber of solid rocket ramjet
固沖發動機補燃室冷流摻混效果與燃燒效率對比研究 -
It is possible for small equipment to carry our large - scale production ; 5. there are rotational flow pieces inside the drying chamber. it is used to control the moisture and granule of raw material to the needed level
乾燥室上部加裝淘析環及旋流片可以控制出口物料的粒度及濕度，以達到不同物料的終水份粒度的要求。 -
As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations
數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。 -
The result on research is as fellow : ( 1 ) the way to rebuild gas channels in combustion chamber of pb column has been researched in order to decrease the flow resistance. the aim, which is less resistance than that at present construction, has been gained
本論文首次通過系統狽賦，藉助伍顫桔葫榨釀斕閣塔的燃腕室翩翱劃稚殲涸浙，對鋅睬蟎辨轉以孰艙澆室內煤氣道、煙氣道的緯淋撾矯孔劃b研究。 -
The main work is done with the help of model experiment. in the flood - relief experiment, the flood carrying capacity of spillway tunnel is checked. in the hydraulic experiment of the diversion power conduit system, the followings are studied : the flow condition and fluctuation in the surge chamber, the distribution of flow velocity before the rack in the surge shaft, the amplitude of stage in the quick gate bay etc. the test step, content and results of different proposals are introduced in details
本項優化試驗研究的目的主要在於，通過泄洪系統整體水力學試驗，校核泄洪洞的泄流能力；通過發電引水系統整體水力學試驗，研究調壓井內水流流態和水位波動情況、調壓井內攔污柵前流速分佈情況；確定快速閘門井內水位波動幅度；試驗確定壓力管道水擊壓力穿井系數以及泄洪洞弧形門處的水壓力。 -
When the governing valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod increased, meanwhile, it ' s time of rise, time to peak and the governing time all increased. at the same time, the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased
當出口節流調速系統的回油路上串接調速閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是增加的，上升時間、峰值時間以及調整時間也是增加的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。 -
Results show that all the geometric parameters have remarkable effects on combustion performance ; the swirl of intake air generated by skew intake holes enhances fuel - air mixing, minimizes dead zone and stabilizes the flame with reverse flow, but the excessive reverse flow can cause overheat in combustion chamber and exhaust ; the consistency of flow resistance in intake and exhaust system is conducive to the stability of heater performance
研究表明，燃燒室進氣孔的孔徑、孔數、孔的分佈及方向等均對燃燒性能影響很大；斜孔所產生的旋轉進氣，雖具有強化燃氣混合、消除死區和迴流穩焰的作用，但迴流過度會使燃燒室及排溫過高；保證進排氣系統流動阻力（壓力）的一致性，有助於保證加熱器性能穩定。 -
When pump is applied force downward and moves, the lower check valve is closed, the fluid in the pump is extruded and charges upward out of upper check valve, then flows into upper pump chamber, because that the piston has volume, some fluid flow out of outlet due to the reduce of spatial fluid volume in upper pump chamber
當泵的柱塞受力向下移動時，下止回閥關閉，泵中的液體受擠壓而向上沖開上止回閥而流入上泵室中，由於柱塞本身佔有體積，部分的流體因上泵室內空間流體積的減少而自出口端流出。 -
This inhibiting of flow oscillations adds stability to the combustion chamber.
對流動振蕩的這種抑制作用提高了燃燒室的穩定性。 -
Material is ejected into the crushing chamber by means of high speed ejection flow formed by high - pressure air through charging ejector, and the crushing nozzles outside ejects high - speed airflow into the crushing chamber at certain direction, making the materials severely collided and fractionated, and thus crushed
該機是靠高壓氣體通過加料噴射器所形成的高速射流，使粉碎原料被射入料碎室，粉碎室外圍的粉碎噴嘴，有方向性的向粉碎室噴射高速氣流，使物料間產生激烈的碰撞，磨擦而獲得粉碎。 -
In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction
在研究過程中，採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷，具體結果包括如下： （ 1 ）完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試，結果發現：鉛塔燃燒室內水平方向的煙氣溫度並非均勻，而且其溫差比上下方向的溫差更大，以及鉛塔燃燒室尾部存在co未燃燼問題； （ 2 ）為了保證鉛塔煙氣系統的正常工作，對煙道系統的阻力進行了理論計算及測試分析，結果發現：鋅精餾鉛塔煙氣系統中煙囪抽力不夠，這主要是煙道結構不合理所造成的。 -
By analyzing the characteristic of the flow field in overloading srm and comparing several existing experiment techniques, a convergence - fold tube facility was developed. the flow field in chamber of srm with high acceleration was simulated. some inhibitor ablation experiments were carried out in this test facility
通過分析過載條件下流場的特點，提出並比較了現有過載地面模擬試驗技術的優缺點，最終確定了收斂?折管的模擬試驗方法，模擬了高過載條件下發動機燃燒室內的高濃度粒子流，利用該方法開展了高過載模擬沖刷條件下的絕熱層燒蝕特性研究及絕熱層抗沖刷能力的篩選試驗。 -
On this condition, we exert two different levels of fluid shear stress ( 4 dyns / cm2and 15 dyns / cm2 ) to them by a parallel plate flow chamber and observe the change of apoptosis of endothelial cells by tunel. we demonstrate that high level shear stress can inhibit the apoptosis induced by lps, whereas low level shear stress was less effective
在此基礎上，將兩種不同大小剪切力與lps共同作用於細胞，發現高水平剪切力（ 15dyn cm ~ 2 ）可以抑制lps誘導的凋亡，而低水平剪切力（ 4dyn cm ~ 2 ）的效果則不明顯。 -
From the view of cellular rheology, we examined the influence of fluid shear stress on the metabolism, morphology, structure and function of endothelia cells in our previous research. it is first time for us to develop the research between shear stress and apoptosis. in this study, we stimulate the human umbilical venous endothelial cells ( huvec ) by lps and apply different levels of fluid shear stress to them by a parallel plate flow chamber, then observe the change of apoptosis of endothelial cells by terminal deoxynucleotidyl transferase mediated dutp nick end labeling ( tunel )
我們從細胞力學的角度，曾對血管內皮細胞在剪切力作用下的代謝、形態、結構及功能等進行過系統研究，但剪切力與內皮細胞凋亡的相關研究尚屬首次，我們希望通過探討細胞凋亡與剪切力大小及作用時間的關系，為探索剪切力對血管內皮細胞信號轉導的影響及作用機理提供有價值的參考數據和實驗資料。
分享友人