flow control pump 中文意思是什麼
flow control pump
解釋
計量泵-
The main products of our company : series of mining emulsion pump station, series of electric haulage shearer, sparying pump station, series of mining flame - proof vacuum / air electromagnetic starter, series of mining vacuum / air feeding switch, series of mining fame - proof and natural - safe. type ac soft starter, series of hydraulic stand valve and pipe system, high flow rate quick - moving valve, the new product nearing into market - the hydraulic support electric - control system, mining electric drill, hydraulic valve test table, electric performance test table
公司主導產品為：系列電牽引採煤機、系列礦用乳化液泵站、噴霧泵站、礦用隔爆兼本質安全型交流軟起動器、系列礦用隔爆真空、空氣電磁起動器、系列礦用真空、空氣饋電開關、系列液壓支架閥類及管路系統、大流量快速移架閥、即將投入市場的新產品? ?液壓支架電液控制系統、煤電鉆系列、液壓閥試驗臺、電性能試驗臺等。 -
Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。 -
Takes several energy saving measures for air conditioning system, nick a large capacity centrifugal chillers working with variable frequency nil capacity chillers, variable frequency and variable flow control on secondary pump water systems, cooling tower for four - pipe water system in winter, fan - coil unit for commercial peripheral zones aid all - air systems for interior zones, variable frequency control on supply and exhaust air fain, enthalpy control on fresh air cooling in winter and intermediate season
採用了多項空調節能措施：大冷量離心冷水機組搭配變頻小冷量機組，二次泵變頻變流量空調水系統，四管制風機盤管冬季用冷卻塔換冷供冷設計，商業外區風機盤管、內區全空氣空調系統，送風機、排風機變頻控制，過渡季、冬季利用室外新風通風降溫的焓值控制設計。 -
The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method
本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。 -
Analysed the power matching principle of a hydraulic excavator, advanced saving energy control planning which could obtain stable rotating speed of the engine by controlling the flow of every running of pump, the aim was for attaining saving energy
摘要分析了液壓挖掘機功率匹配原則，提出了通過控制泵的排量穩定發動機轉速，以實現以節能為目的的模糊控制策略。 -
In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards
論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。 -
Based on the review of recent advances in surveying and controlling techniques of river models, described in this paper is a new controlling technique, which makes use of a two - way axial - flow pump and a immersion pump to control the up - boundary condition of discharge and the down - boundary condition of water level respectively, with the tidal model of the huangpu river estuary as an example
在對河工模型量測與控制技術進行回顧的基礎上，以黃浦江河口潮汐河工物理模型為例，介紹了潮流河段上邊界採用軸流泵進行雙向流量控制、下邊界採用潛水泵進行水位控制的新技術。 -
Each chemical has a station consisting of a feed pump, inductive flow meter and control valve. this ensures the reproducibility of chemical quantities
每一種化學助劑都有一個工作站，包括有輸液泵、電感式流量計、以及控制閥，這就保證了助劑用量的再現性。 -
Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system. special analysis about simultaneously operating multi - actuators with different inertia loads is made. finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient
第三章介紹了基於執行器進油側流量反饋的分流控制的原理，並針對大小慣性執行器同時起動時採用該分流控制方法進行了具體分析；最後通過模擬說明該分流控制方法能在大小慣性執行器同時起動並在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，並能實現優先級和分流比混合控制。 -
In power decentralized system, there are not pump / fan installed in main pipe, but also in branches, using the variable speed control to regulating the flow, valve energy consumption can be reduced or avoided, but the investment is higher and control is complicated
動力分散系統不但在系統的母管上，而且在各支路上設泵（或風機） ，並實行變速控制以調節流量，可以減少乃至消除調節閥能耗，但投資增大，控制復雜。 -
Introduces the structure of the multi - actuators control system based on pressure decrease sensing. then a multi - actuators control system model is developed for the constant pump discharge pressure hydraulic system. also the factors that affect the static accuracy of actuators " speed and flow rate and the dynamic characteristic are analyzed in this chapter
第二章簡單敘述了基於壓差傳感的計算流量反饋流量控制原理及其實現；介紹了基於壓差傳感的多執行器復合控制系統的構成；之後主要針對定壓系統多執行器復合控制建立了數學模型，並分析了影響執行器速度及流量穩態控制精度和動態特性的一些因素。 -
When the water head and the flow are given, we can regulate the pump ' s blade mounting angle to control the discharge of pump in this pumping station that contains only one type of pump. we also can determine the number of running machines with machine ' s optimal combination. so we can reduce its energy consumption, and make it run optimally and economically
當水頭和抽水流量給定時，這類泵型單一的泵站，可以通過調節水泵的葉片角度，控制水泵的流量，併合理確定開機臺數，通過機組間的優化組合，使整個泵站的能耗最少，達到整體最優、經濟運行的目的。 -
Taking advantage of the good points of the fuzzy control adjusting the flow rate of the pump according to the variation of the external load by fuzzy inference, the energy saving of the excavator is accomplished without the help of the modelling of its whole complex system
此方案利用模糊控制的優點，繞過對挖掘機復雜來系統模型的建立，通過模糊推理演算法，根據外負載的變化動態調整泵的流量，達到節能的目的。
分享友人