flow profile 中文意思是什麼

flow profile 解釋
過流翼型
  • flow : vi 1 流,流動。2 (血液等)流通,循環。3 流過;川流不息;(時間)飛逝;(言語等)流暢。4 (衣服、...
  • profile : n 1 剖面,半面,(雕像等的)側面;側面像。2 外形,輪廓;外觀,形象;型;【航空】翼型,翼(剖)面...
  1. This paper adopts an adaptive learning algorithm based on hierarchy clustering to update user profile, which continuously abstract the cancroids of one class of optimum information from the feedback flow of system, which effectively shield the learning process from plenty of feedback noises produced by distorted threshold and sparseness of initial information, which also can imitate artificial feedback approximately to perfect the intelligence of adaptive learning mechanism

    摘要本文採用一種基於層次聚類的自適應學習策略,從系統反饋的信息流中,動態提取一類最優信息的質心更新用戶模型,有效屏蔽了閾值失真和初始信息稀疏造成的大量反饋噪聲,並且能夠近似模仿人工反饋,完善自適應學習機制的智能性。
  2. As we know, inverse techniques make blade ' s profile well compatible with its surface velocity distribution, however, they give designers big challenges that the ideal velocity distribution is hard to obtained and sometimes the non - physical solution, such as double covering of flow field or unclosed profiles, would come out. the proposed design procedure in the paper has avoided the disadvantage mentioned above. in this paper, a quasi - irrotational equation is used to describe the flow in cascade instead of the generally used irrotational equation

    眾所周知,一般的反問題和混合問題的最大特點,是在給定的壓力面和吸力面上的壓力分佈或速度分佈條件下,直接得到葉片的幾何形狀,它可以使葉型型面與表面氣流參數有機結起來;其不足之處在於,對設計者而言,很難給定理想的葉片表面壓力分佈或速度分佈,並且有時會得到一個非物理解,如:得出的初始葉型可能會出現前緣、尾緣不封閉的現象。
  3. Standard specification for 12 to 60 in. 300 to 1500 mm annular corrugated profile - wall polyethylene pipe and fittings for gravity - flow storm sewer and subsurface drainage applications

    自流式雨水管和地下排水裝置用12至60英寸300 to 1500 mm環形波紋狀異型壁聚乙烯管和配件的標準規范
  4. The mean velocity profile of sediment - laden flow can bet divided into two regions. the profiles for both regions follow the logarithmic law. only the von karman universal constants are different from each other

    渾水時勻流速分佈可分成兩個流區,兩個流區的分佈均遵循對數規律,只是相應的卡門常數有所不同。
  5. The effect of air distributor on the flow fields was studied with emphasis. the working conditions of the bubble column simulated in the numerical study were as same as in the experiments. the velocity profile at axial direction showed a peek in the center, and a backward flow near the wall when usl / usg < 19. 6

    鼓泡塔內軸向液相速度的徑向分佈呈塔中心峰值、壁面附近倒流形式,且與氣相折算速度大小有關,當液相折算速度一定時,隨氣相折算速度增大而愈加陡峭,返混也劇烈。
  6. During the " 10th 5 - year - project ", researches on the following techniques, new isotopic carrier, 5 parameters combination logging, oxygen activation logging, injection profile logging for polymer flooding, trace relative flow rate logging, and so on, have been carried out and some advanced and practical results have been obtained

    「十五」期間開展了新型同位素載體、五參數組合測井技術、氧活化測井技術、聚驅注入剖面測井技術、示蹤相關流量測井技術等課題的攻關,取得了一批先進實用的技術成果。
  7. Abstract : through a series of hydraulic model tests for researching actual power tunnel operation, a conclusion is reached that in order to get a better flow pattern the profile of the wate - carrying structure should be adapted to the variation of water streamline shrinkage, flow velocity and pressure intensity. the configuration and dimension of the kinetic energy dissipator should be selected carefully to make the water tunnel safe and reliable at different levels of diversion dischage

    文摘:針對實際工程中的發電引水隧洞運行的各種工況進行了水工模型試驗研究,指明要獲得良好的水流流態,過水建築物各部位結構輪廓的造型應適應水流流線的收縮、流速及壓強的變化;為使引水隧洞在各級引水流量下能安全可靠地運行,需慎重確定洞內消能工的體形和尺寸。
  8. The flume experiment with single spur dike is carried out. water surface profile and velocity field of flow in flume are measured by manometer tube and propeller current meter respectively

    首先進行了單丁壩水槽實驗,採用測壓管和旋漿流速儀對實驗水槽中水流的水位以及流速場進行了詳細的測量。
  9. According to the working modes of mr devices, combining the ohm ' s law of magnetic circuit and the design theory of non - steady magnetic circuit, magnetic structures of the automotive damper have been worked out. to emulate the performance of conventional shock absorber, two automotive mr dampers were designed and fabricated at chongqing university. an applied magnetic field increase the yield stress of mr fluids in flow annular passages, which alters the velocity profile of mr fluid in the passages and raise the pressure gradient between low cavity and high one at some given flow rates

    根據磁流變阻尼器工作模式,利用磁路中的歐姆定律和動態磁路設計原理,結合汽車懸架的技術要求和結構特點,提出了基於剪切模式和流動模式共同作用(混合工作模式)的汽車磁流變阻尼器設計原理,討論了阻尼器動態磁路設計中的若干技術問題;根據流體力學navier - stokes方程,分別利用newton流體特性和bingham流體特性,推導了基於平板模型和軸對稱模型的流變學方程,得出了阻尼器阻尼力的計算方法。
  10. Through flume experiment and numerical simulation, preliminary work on computation of water surface profile in regulation river reach, numerical simulation of flow with single spur dike in flume, and 3 - d numerical solution of flow around spur dikes group are carried out in this paper

    本文通過模型實驗和數值模擬相結合的研究方法,在整治河段一維水面曲線計算,單丁壩繞流數值模擬,紊流數學模型在航道整治工程中的應用以及丁壩群附近水流的三維流動特性等方面做了一些初步研究。
  11. So far as the aqueduct with large discharge and lower head is concerned, the non - uniform flow will occur in the aqueduct, when the discharge is enlarged after the water - carrying section being determined based on the design discharge and the given head ; for which the flow condition must be presumed, so as to determine the water surface profile

    摘要大流量低水頭渡槽根據設計流量和給定水頭確定過水斷面后,通過加大流量時,渡槽內就會發生非均勻流,需對這種水流情況進行推算,以確定渡槽在通過加大流量時的水面線。
  12. As the dangerous position needed to be verified has been identified with the known heat flux profile and the characteristics of flow rate distribution, the metal tube temperature of the position can be obtained

    此方法克服了目前常用的電廠鍋爐壁溫計算方法中校核點工質流量與熱負荷並不一定互相對應的缺點。
  13. The goal of this paper is to study fully developed turbulent pipe flow. with the aid of the tripping annulus at the inlet, based on the experimental investigation and numerical simulation, detailed researches on a few basic rules in pipe flow have been performed, such as mean velocity profile, relative intensity of turbulence, the log - law, von karman ' s constant and reattachment length, thus filling some gaps in the research work of predecessors and obtaining a far - reaching understanding

    本文的目的就是利用入口擋環進一步探索充分發展的圓管湍流,通過實驗和數值模擬對圓管湍流的若干基本規律,如平均速度分佈、相對湍流強度、對數定律、馮?卡門常數和再附著長度等進行詳細的研究,以填補前人研究中的一些空白,並獲得更深入的了解。
  14. By means of a detailed analysis to the interaction between droplet and its carrying fluid for horizontal stratified / atomization two - phase flow, a theoretical model is proposed to calculate the droplet axial velocity profile and the relative slip between dispersed phase and continuous phase

    摘要通過對水平分層霧化流中液滴和其攜帶流體間交互作用的分析,提出了一個預則水平分層霧化流中軸向液滴速度分佈以及彌散相和連續相之間相對滑移的理論模型,通過計算獲得了兩相速度參數及相對滑移參數。
  15. The variation of coarseness and fineness of the component particles in baijiaziu profile and mafangtan profile is caused by river impetus of weihe river, including runoff volume and velocity of flow, which is closely related with climatic factors in guanzhong basin, such as precipitation, temperature and rainfall

    白家嘴與馬坊灘河流沉積物剖面粒度變化與渭河水動力變化直接相關,而渭河水動力條件又與渭河流域區域氣候變化有關。因此,粒度在剖面上的變化實質上是氣候波動的結果,利用其變化可重建河流沉積物形成以來的水文、氣候環境的演化歷史。
  16. For both newtonian flow and non - newtonian flow, the vortices are generated when the waviness of the bottom profile is beyond a critical number. by increasing the waviness, a second vortex can be generated. with the increasing of reynolds number, the symmetry of the streamlines at re = 0 is destroyed and the vortices are sloped and become larger

    當波形板的波動度超出臨界值,波形板壁面上的流動出現流線分離,流動中有渦生成;增大波動度,流動中出現第二個渦; re = 0 ,流線在流場中對稱分佈;雷諾數增大,流線駐點在水平方向出現位置偏移,渦的范圍增大;對于非牛頓流體,隨著剪切變稀指數的減小,渦的作用范圍減小。
  17. The methods of studying flow profile of preparative chromatography were summarized

    摘要總結了研究制備色譜流型的4種方法。
  18. The factors affecting flow profile were reviewed and commented, including the technique of packing column, the design of column head, the shape of columns, temperature and sample viscosity

    綜述了影響制備色譜流型的各種因素,包括裝柱技術、柱頭設計、柱形、溫度、樣品粘度等。
  19. Annulus flow profile

    環空流前
  20. Cash flow profile

    現金流概況
分享友人