flux recovery 中文意思是什麼

flux recovery 解釋
通量恢復
  • flux : n 1 流,流出;流動。2 漲潮。3 不斷的變動,波動。4 【物理學】流量,通量,電通量,磁通量。5 熔解,...
  • recovery : n. 1. 重獲;復得;恢復,收回,回收。2. 還原,復原;痊癒;蘇生;矯正。3. 回縮。4. 填地。5. 【法律】勝訴。
  1. With the aqueous phase velocity increasing, the mass transfer flux increased, but the recovery extraction decreased

    由回收率的大小可以看出,電泳萃取分離技術是一種很好的處理染料水的方法。
  2. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件,以水為工質,對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究,實驗壓力為0 . 02 0 . 8mpa ,實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式,彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  3. At last, on the basis of above experiments, the five - factor - three - level orthogonal experiments on the relative flux recovery ratio after na2edta and na4edta cleaning pvdf microfiltration membrane that was fouled by caso4 were done

    最後,在前面實驗的基礎上,作出na _ 4edta和na _ 2edta對硫酸鈣垢污染的pvdf微濾膜清洗后,相對通量恢復率的五因素三水平正交實驗。
  4. 5 have a better recovery. the flux - transmembrane pressure curves of several kinds of pu composite hollow fiber membranes differed completely from non - deformation membranes, deviated from the linear relation obviously. this strongly indicated that, due to pu characteristics, such as good elasticity and strong recovery, pu - sio2 composite hollow fiber membranes have a comparatively good pressure - responsivity

    通過調整紡絲液濃度、 sio _ 2含量、中空芯液流量、紡絲溫度、凝固浴溫度等參數,紡制出5種較為理想的壓力響應性pu復合中空纖維膜,其中,含有20和25 sio _ 2的pu復合中空纖維膜孔徑增加和孔徑回復最為理想。
分享友人