forced-circulation 中文意思是什麼

forced-circulation 解釋
強制循環
  • forced : adj. 1. 強迫的,強制的。2. 用力的。3. 勉強的,不自然的。adv. -ly
  • circulation : n. 1. 循環;運行。2. 傳播;環流(量),流通(量)。3. (雜志等的)發行(額),銷數,銷路。4. 通貨,貨幣;流通證券。5. 【航空】環量,環流。
  1. Forced - feed water circulation system

    強制循環式化冷系統
  2. The extruders drived by d. c motor with a thyristro to stepless regulate. it also equipped with the over - load prtection and stoppage alsrmingsystem. the screws core and the outside of barrels are cooled by the circulation of oil, ther fuctions include vacuum venting and forced feeding

    本機採用直流電機,可近期硅無級調速,沒有過載保護和故障報警、螺桿芯部油循環恆溫、機筒油冷卻,並裝有真空排氣管裝置和定量喂料裝置。
  3. Heat exchangers. forced circulation air - cooling and air - heating coils. test procedures for establishing the performance

    熱交換器.強制循環空氣冷卻和空氣加熱盤管.確定性能的試驗程序
  4. Heat exchangers - forced circulation air - cooling and air - heating coils - test procedures for establishing the performance

    熱交換器.強制循環空氣冷卻和空氣加熱盤管.性能確定的試驗規程
  5. Household frost - free refrigerating appliances. refreigerators, refrigerator - freezers, frozen food storage cabinets and food freezers cooled by internal forced air circulation. characteristics and test methods

    家用無霜製冷設備.製冷機製冷機冷藏櫃冷凍食品儲藏櫃和用內壓力空氣循環冷卻的食品冷藏櫃特性和試驗方法
  6. Gravity - convection and forced - circulation water baths

    重力對流和強制循環水浴鍋
  7. Forced air circulation oven type thermal accelerated aging testers

    強迫空氣循環箱式熱加速老化試驗機
  8. Lnovation of bearing seal structure of zw - style forced circulation pump

    重油催化裂化裝置循環熱水泵機械密封系統改造
  9. Varations of drum level with starting up of boiler circulating pump in the forced circulation boiler

    強制循環鍋爐爐水循環泵啟動對汽包水位的影響
  10. In this dissertation, the experimental study of rolling condition on two - phase flow instabilities of the forced - single - tube circulation system was carried out. furthermore, based on the d - partition method and the hypothesis of drift flow model, given some conservative equation, using the perturbation method the response of the pressure drop of the tube to the inlet flow rate perturbation was analyzed both in rolling condition and in normal upright position

    本文主要通過實驗對搖擺條件對單管強迫循環中汽液兩相流動不穩定性的影響,同時在d分區法的前提下,在兩相區基於漂移流模型,一定的守恆條件下,在搖擺和不搖擺工況中用線性小擾動法對實驗段的壓降對入口流速的擾動的響應進行了分析。
  11. Methods of testing forced circulation air cooling and air heating coils

    強制循環空冷卻和空氣加熱盤管的試驗方法
  12. The article introduced the using and characteristics of atmosphere forced circulation outside a pallet car heat - treatment oven, provided the ways to get high uniformity and heat - transfer efficiency inside the furnace, and confirmed main parameters of this furnace through calculation

    摘要介紹了爐外強制循環臺車式熱處理爐的用途及特點,闡述了確保爐溫均勻度和提高熱效率必須達到的要求,並通過計算對該爐的主要參數加以確定。
  13. Testing of cooling equipment for insulated means of transportation - part 1 : transport refrigerating systems with or without forced air circulation evaporator

    絕熱運輸工具的製冷設備的試驗.第1部分:帶和不帶強制
  14. When the cooling fan is adopted, the forced air circulation of the low - noise fan will reduce the operating temperature of the winding so as to increase the output capacity up to 150 % of the rating capacity

    當採用風冷系統時,低噪聲風機通過強迫空氣循環,可降低線圈的運行溫度,即可增大容量輸出至額定的150 %左右。
  15. His account, last referred to by chateaubriand in 1826, contradicted another version in circulation at the time that described louis as having to be forced to mount the scaffold at pistol point, crying out : " i am lost, i am lost.

    據悉,法國作家夏多布里昂於1826年最後提到過這封信,之後在近200年的時間里它一直被一個秘密的家庭收藏,直到不久前才被公之於眾。
  16. Experimental investigation on overall heat transfer coefficient of forced circulation air coolers during frost condition

    結霜工況冷風機傳熱系數實驗研究
  17. Investigation of testing for overall coefficient of heat - transfer concerning forced circulation air coolers during frost condition

    結霜工況冷風機傳熱系數實驗研究
  18. The safety analysis of the transient between natural circulation and forced circulation was made using the real - time simulation. it is the preparation for natural circulation research deeply

    利用冷卻劑系統的模擬計算程序,對自然循環與強迫循環之間的轉換過程做了安全分析計算,為進一步開展自然循環研究打下基礎。
  19. Quenching hot oil is forced cooling by outer circulation of oil - pump and heat exchanger, so oil - cooling rate is high

    配置高效的外部淬火油冷卻循環系統,淬火能力強,能夠得到更小的零件變形量。
分享友人