fraction analysis 中文意思是什麼
fraction analysis
解釋
餾分分析-
Application of continued fraction approximation method to slope probabilistic analysis
函數連分式漸近法在斜坡穩定性概率評價中的應用 -
In the first trial, combination of enzymatic digestion was used to prepare suspensions of spermatogenic cells from adult mouse testis, and then a modified discontinuous percoll gradient centrifugation method ( 15 %, 22 %, 30 %, 40 %, 50 %, 60 % ) was introduced to isolate spermatids from the cellular suspensions. the content of spermatids in each isolated fraction by percoll method was determined by morphology ( wright - giemsa stain ) and flow cytometry analysis, and the viability of spermatogenic cells was assessed by using eosin y exclusion test
在第一部分試驗中，首先利用連續3次組合酶消化成年小鼠睪丸制備睪丸細胞懸液，然後經6層非連續percoll梯度離心法（ 15 、 22 、 30 、 40 、 50和60 ）分離，通過形態學和流式細胞術鑒定南京醫科大學碩士學位論文各個percoll組分中精子細胞的含量，並以伊紅y排斥試驗測定細胞的存活率。 -
Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )
本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。 -
According to the topological analysis of the unit cells, the relationship between the braiding parameters is established, such as braiding angle, braiding pitch, fiber volume fraction, dimension of composites etc.
經過對三維編織細觀結構的拓撲分析，建立了編織工藝參數之間的關系，如編織角、編織花節長、纖維體積含量、復合材料的尺寸等。 -
Then, analytical work was carried out as follows : the ultimate analysis and physi - chemical analysis of the pyrolytic oil comprised a sketch of the fuel properties of the oil ; then, through the distillation analysis of the oil, the fraction composition of the " unrefined " oil was known. after that, a general knowledge of the aromaticity and saturation of the hydrocarbons in the oil was provided by the outcome of the ft - ir functional group analysis. also, from the analysis, the form of the polar functional groups and their distribution in different fractions of the oil were learned
文中首先對不同熱解溫度下熱解油產率進行分析討論，然後，針對熱解油品質進行了一系列分析：通過元素組成和理化特性的分析，對熱解油作為燃料特性有了一個大致了解；通過實沸點蒸餾分析，得到熱解油作為一種未提煉油的餾分分佈，並為后續熱解油餾分的細入分析提供了前提；通過對熱解全油和各窄餾分的ft - ir官能團分析，對熱解油的芳香性、不飽和性有了整體的了解，並且清楚了熱解油中的極性官能團存在型式及其在熱解油不同餾分中的分佈。 -
By sds - page and immuno - blotting, the monoclonal antibody of anti - chick brain cytoplasmic dynein intermediate chain could recognize the 67 kda protein in purified golgi apparatus fraction from lily pollen. subsequently by immuno - gold labeling and transmission electron microscopy, we found that the dynein intermediate chain - like protein bound mainly to the membranes of golgi - associated vesicles. statistics analysis of dynein intermediate chain - like protein on golgi - associated vesciles showed the nearly equal chance of distribution on either cis - or trans - golgi - associated vesciles
對分離純化的百合花粉及花粉管中高爾基體組分進行sds -聚丙烯酰胺凝膠電泳和免疫印跡發現，抗雞腦細胞質力蛋白中間鏈單克隆抗體在67kda處有較強的免疫交叉反應；進而通過免疫金標結合電子顯微鏡觀察發現，大多數類細胞質力蛋白中間鏈存在於高爾基體附近的囊泡膜上；統計結果表明，類細胞質力蛋白中間鏈在順面和反面高爾基體附近囊泡膜上的分佈機率大致相等。 -
Horizontal road marking. markings applied on the roads. inventory of methods for organic fraction analysis
路面水平標記.馬路標記.有機餾分析方法一覽 -
Mean, stddev, heterogeneity coefficient and fraction dimension are the indices for evaluating the scaling method in object - oriented image analysis. the change trend of these indices corresponding to segmentation scales is used to judge the validity. in this thesis, object - oriented image analysis is introduced fully
6 .提出可以用影像對象的均值、標準差、異質性系數與分形維數作為評價面向對象尺度轉換的指標，根據這四個指標隨尺度的變化趨勢分析尺度轉換方法的合理性。 -
Furthermore, the fiber volume fraction of each inclined and horizontal unidirectional " lamina was assumed to be the same as that of the composites. three - dimensional stress - strain analysis was applied to each unidirectional lamina that was assumed to be transversely isotropical under on - axis coordinate system. carrying out the integration and averaging of stiffness yielded the effective elastic moduli of 3 - d braided structural composites
採用三維應力?應變分析，在單胞的長度方向積分和平均，在給定的應變邊界條件下，採用剛度體積平均的方法，預測三維編織結構復合材料的有效彈性模量；在空間多向應力的基礎上，通過對三維編織結構復合材料破壞機理的探討，摘要提出了適用於三維編織復合材料細觀強度失效準則，預測三維編織結構復合材料的強度性能。 -
This paper discuss that we analysis and deal with examine data by means of computer assist, estimate the difficulty, degree of differentiate, believe degree of examination paper, efficiency degree so on, deal with examine data. it give statistical distributing about examine result person percentage, standard fraction plenty give play to strong point of assess and diagnosis, feed back and inspirit function
利用計算機輔助手段，對考試成績進行處理和分析，在試題難度、區分度、試卷信度、效度等方面給出定量的估計，並對考試原始分數進行加工，在此基礎上，得到班級成績的統計分佈，個人的百分等級和標準分數，以充分發揮考試的評定與診斷，反饋與激勵功能。 -
Abstract : this paper discuss that we analysis and deal with examine data by means of computer assist, estimate the difficulty, degree of differentiate, believe degree of examination paper, efficiency degree so on, deal with examine data. it give statistical distributing about examine result person percentage, standard fraction plenty give play to strong point of assess and diagnosis, feed back and inspirit function
文摘:利用計算機輔助手段，對考試成績進行處理和分析，在試題難度、區分度、試卷信度、效度等方面給出定量的估計，並對考試原始分數進行加工，在此基礎上，得到班級成績的統計分佈，個人的百分等級和標準分數，以充分發揮考試的評定與診斷，反饋與激勵功能。 -
On the basis of geometric correction for remote sensing images data, detailed character analysis was conducted for the tm images. several image transformations which are linear scale transformation, ratio processing, principal components transformation, tasseled - cap transformation and minimum noise fraction rotation ( mnf transformation ) were then implemented
在對研究區數據進行幾何精校正的基礎上，對tm數據進行了詳細的特徵分析，並對其進行了有利於植被信息提取的幾種圖像變換：線性拉伸、比值增強、主成分變換、纓帽變換以及最低噪聲分離變換（ mnf變換） 。 -
Method for hydrocarbon types analysis of gas - oil saturates fraction by mass spectrometry
重餾份石油飽和烴族組成質譜分析方法 -
Secondly, the finite - element analysis on the typical slope section is performed with establishment of geology model, definition of boundary condition and proper selection of mechanical parameters. the result shows that the slope is of integral stability, and the failure mode mainly comprises infrequent block drop and wedge body breakage. considering the two failure modes of plane failure and wedge body breakage, and stability calculation under different work conditions, the slope stability is discussed and the sensibility ana lysis on its fraction angel and cohesion force is made
然後通過建立地質模型、確定邊界條件、選擇合理的力學參數，取典型斷面對邊坡進行數值分析，分析結果表明斜坡整體是穩定的，破壞類型以零星掉塊和楔體失穩下滑為主；為了定量計算邊坡的穩定性，對邊坡兩種破壞類型：單滑面下滑和雙滑面楔形體下滑，考慮不同工況進行穩定性計算，並對摩擦角和粘聚力進行穩定的敏感性分析。 -
With the increase of volume fraction of sic particles, the flow stress of composites increases. from the compare of the experiment result and the analysis result, the constitute equation of mmcs is given. the penetration experimental equipments and technologies are also introduced
隨著sic顆粒的體積分數的增加，復合材料流動應力相應增加，並將實驗結果與理論計算結果進行了比較分析，得到反映顆粒增強金屬基復合材料性能的本構方程。 -
Three models are proposed as follows by applying the model of " mixed flow " : the stress of increasing fluid on fouling, collision between solid particles and fouling, and solid particles movement velocity ; the effects of operating parameters, properties of particles, and the volume fraction of particles on stress in solid - liquid two phase flow, collision stress between solid particles and fouling, maximal contacting area between solid particles and fouling and maximal contacting time between solid particles and fouling are investigated systematically by calculating and theoretical analysis
利用「混流」模型，建立了兩相流體的剪應力模型、固體顆粒與垢層的碰撞模型和固體顆粒的運動速度模型；通過計算和理論分析，系統地考察了操作參數、顆粒物性、顆粒體積分率等對固液兩相流剪應力、顆粒對垢層的碰撞力、顆粒與垢層的最大接觸時間和最大接觸面積的影響。 -
4. a formula for calculating receiving buffer length was proposed, based on the analysis and research on network parameters, such as jitter, average speed and packet loss fraction
4 .在分析研究延時抖動、平均速率和丟包率等網路參數的基礎上，給出客戶端接收緩沖區長度估算公式。 -
Comparative immunoregulatory property analysis of genomic dna and polysaccharide nucleic acid fraction from mycobacterium bovis bacillus calmette - gu 233 ; rin
和卡介菌多糖核酸免疫調控活性的比較 -
Organic geochemical measurements of geological samples - method for hydrocarbon types analysis of gas - oil saturates fraction by mass spectrometry
地質樣品有機地化測試重餾分石油飽和烴族組成質譜分析方法 -
Abstract : the fraction compositions, group compositions and structure compositions of seve n catalytic stocks were determined by means of vacuum distillation, mass spectrum, element analysis and molecular mass measurement
文摘:採用減壓蒸餾、質譜分析、元素分析和分子質量測定對遼河原油的7種催化原料油進行了餾分組成、族組成和結構族組成的分析。
分享友人