gas spray 中文意思是什麼
gas spray
解釋
氣霧-
A more difficult problem is the quantitative description of the secondary breakup of the initial spray by high velocity combustion gas.
一個更困難的問題是關于高速燃氣使初始噴霧二次破裂的定量描述。 -
Police responded with tear gas, pepper spray and water cannon
警方發放催淚彈、胡椒噴霧和水炮。 -
Pulsating spray drying technique makes use of the unstable hot gas stream generated by a pulse combustor to atomi / e and dry a liquid material
脈動燃燒乾燥技術是近年來出現的一種新型乾燥技術，它利用脈動燃燒器產生的高溫，高頻脈動尾氣流直接霧化和乾燥液態物料。 -
With gelatin liquor as adhesive and wheat meal as granulation material, the effects on spray granule ' s strength of fluidizing gas velocity, bed temperature, nozzle air pressure and adhesive concentration were studied experimentally in a batch conical fluidized bed spray particle generator
本文在一間歇錐形流化床噴霧造粒器中，以食用小麥澱粉為原料，以明膠的水溶液為粘結劑，實驗研究了流化氣速、床層溫度、噴嘴霧化空氣壓力、粘結劑濃度對噴霧造粒顆粒強度的影響。 -
A differential fixed - bed reactor was employed to study the reaction between iron blast furnace slag ( bfs ) / hydrated lime ( hl ) sorbent and so2 under conditions similar to those in the bag filters of a spray - drying flue gas desulfurization system
摘要本研究以微分固定床反應器，在模擬噴霧乾燥除硫系統中的袋式過濾器的條件下，探討爐石/氫氧化鈣吸收劑與二氧化硫于低溫下之反應動力學模式。 -
As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations
數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。 -
Based on the induction phenomenon caused in gas hydrate formation, the influential rules of its gas entrance mode, temperature, pressure, water resources and nozzle on the induction time are analyzed by means of experimental study on the induction time of gas hydrate formation obtained by water spray and enhancement
摘要以氣體水合物形成過程中的誘導現象為基礎，通過對噴霧強化方式制取天然氣水合物的誘導時間進行試驗研究，考察分析了系統進氣方式、溫度、壓力、水源及噴嘴等因素對誘導時間的影響規律。 -
In this dissertation, we mainly report on a laser - produced plasma ( lpp ) source with liquid aerosol spray target. for sufficiently high backing pressure and low temperature, the valve reservoir gas of the light source can undergo a gas - to - liquid transition
液體微滴噴射靶激光等離子體（ lpp ）光源是一種具有較高的軟x射線轉換效率且能夠長期連續運行的低碎屑光源。 -
The impacts of different spray nozzle types and injecting pressures on temperature uniformity of the exhausted flow field of the gas generator were studied experimentally
實驗研究了彩不同酒精噴入形成和參數對氣體發生器排氣溫度均勻性的影響。 -
Three kinds of method is applied water spray with pump, water curtain without pump, and dry adsorption to tackle waste gas
並對有泵水霧、無泵水幕、乾式吸附三種治理工藝方法、吸收裝置結構及運行特點進行分析對比。 -
By studying characteristics, merits and solving problems of the different nozzle and new spray equipment in asphalt gas decontaminating for carbon calciner, the research provides a basis for the industrial design of swirl nozzle
摘要在闡述瀝青煙氣凈化系統中不同霧化設備及新型霧化設備特性的基礎上，分析了碳素焙燒爐瀝青煙氣凈化系統的霧化冷卻的技術現狀，並指出了存在的問題，為工程設計選擇霧化設備提供了參考。 -
Based on the analysis of regime of spray and heat transfer, the spray nozzles were redesigned to distribute liquid in the center area of th e tower and the gas inlet was enlarged to raise gas velocity
根據對順流式空塔的噴淋及傳熱模式的分析，重新設計了噴嘴，使噴淋液在設備中心附近集中；縮小了進氣管直徑，以提高進口氣體的流速。 -
When the alarm detects that the concentration of the gas reaches or excesses the preset alarming scale, the alarm will give out sound and light alarm immediately to warn the users to take measures for safety, start the exhaust and the spray systems, and cut off the gas flow for preventing explosion, fire disaster and poisoning to guarantee the safety of production
當環境中探測氣體濃度達成或超過預置報警值時，報警器立即發出聲光報警，以提醒用戶採取安全措施，並驅動排風、噴淋系統、切斷，切斷氣流防止發生爆炸、火災、中毒事件，從而保障安全生產。 -
Recovery solvent can be added to the spray water to remove gas pollutants
將氣態污染物冷凝到其露點以下，變成粒狀，可進行充 -
In this work, the macroscopical characteristics of diesel and diesel / lpg sprays are studied through using a digital camera with a high spatial resolution. based on processing technique for digital image, the droplets photographed, which are at the spray edge, are studied. after a comparison of the characteristics of sprays for different fuels, such as diesel, blend fuels of diesel and lpg with different weight fractions, it is shown that flash - boiling injection ( fuel containing dissolved gas ) is good for the atomization of fuel
本文對柴油和柴油lpg混合燃油的噴霧的宏觀特性採用高解析度數碼相機進行測量，並運用數字圖像技術處理了數碼相機捕捉到的處于霧束外沿的粒子，通過比較純柴油和不同lpg比例混合油的霧化性能，表明溶氣噴射（閃急沸騰）有利於噴射油滴的霧化。 -
A kind of two - equation turbulent model of charged fluid flow is constructed, in which the interaction between electric field and flow field is considered. based on analyzing the properties of forces on the charged droplets in the spray, pseudo - fluid of charged droplets phase method is adopted to develop a kind of charged two - phase turbulent model. this model takes account of the interaction between charged droplets phase and electric field, the inter - phase action between droplets and gas, convection and diffusion of droplets " turbulent energy
考慮電場與流場的耦合作用，建立了荷電流體的湍流模型，在荷電顆粒受力分析的基礎上，採用顆粒擬流體的方法建立了荷電氣液兩相湍流理論模型，該模型考慮了荷電顆粒相流場與電場的耦合作用，氣相與顆粒相的相間作用以及顆粒相自身湍能的對流與擴散。 -
( 4 ) the influence of pulsation frequency on the drying process two special cases, in which the selected pulsation frequencies were 0 h /, and 83 h / respectively, were simulated and their simulation results indicated that the pulsating frequency of gas stream could improve the intensities of the heat and mass transfer during a pulse combustion spray drying process
（ 4 ）揭示了氣流脈動對乾燥過程的影響本文模擬脈動頻率為83hz的脈動氣流和非脈動氣流的兩種乾燥過程，比較兩種乾燥過程的顆粒蒸發速率和濕含量變化。模擬結果表明氣流脈動對噴霧乾燥過程有一定增強作用。 -
Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上 -
The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上 -
Experiment shows that when the gas hydrate is obtained by spray, its induction time is generally shorter, its phenomenon is not obvious, setting of initial temperature and pressure with an autoclave has certain influence on induction time, but not obvious, water resources and spray nozzle have bigger influence on the induction time
試驗表明，噴霧方式制取天然氣水合物時，誘導時間普遍較短，誘導現象不明顯；反應釜設定初始溫度和壓力對誘導時間有一定影響，但不是很明顯；水源和霧化噴嘴對誘導時間的影響較大。
分享友人