gas thermodynamic 中文意思是什麼

gas thermodynamic 解釋
氣體熱力的
  • gas : n (pl gases )1 氣,氣體,氣態 〈cf fluid; solid〉 2 可燃氣,煤氣,沼氣;【礦物】瓦斯。3 【軍事...
  • thermodynamic : adj. 熱力的。a thermodynamic cycle 熱力循環。n. -s 熱力學。
  1. Study on the thermodynamic parameters for adducts of lewis a - b by gas liquid chromatography

    酸堿加合反應的熱力學參數
  2. 2. recuperative gas turbine cogeneration with water injection and its thermodynamic analysis recuperative gas turbine cogeneration can reduce exhaust temperature, make use of waste heat and increase efficiency

    二、功熱並供回熱注水燃氣輪機及其熱力分析採取回熱和功熱並供可以減小熱機循環的當量排氣溫度或有效利用余熱。
  3. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定,確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒,增設煙氣含氧量分析,可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下,極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果,從而降低排煙溫度45 ,減少加熱爐排煙損失,節約了煤氣量6 %以上。
  4. Ceramic fuel cells are electrochemical devices that directly convert fuels such as gasified coal or natural gas into electricity without the limitation of the carnot cycle ( an ideal thermodynamic cycle in which heat is taken onto a working fluid at a constant upper temperature and rejected at a constant lower temperature )

    陶瓷燃料電池是一種電氣化學裝置,能直接將煤氣、天然氣等燃料直接轉化為電能而不會受到卡諾循環(一種理想的熱力循環,熱量在恆定高溫下轉化成工作流體,在恆定低溫下被釋放)的限制。
  5. By virtue of the experiments carried out on the modified pilot - scale biomass gasification system, the temperature field in the gasifier is made explicit. and also some principles about how the temperature, feedstock and extraction mode exert influences on heat value and production rate of gas are attained. in addition, some tentative tests of tar cracking and thermodynamic characteristics of biomass gas burner have been performed, which are that indispensable to design and operation of biomass gasification demonstration project

    接著,通過對生物質中熱值氣化中試試驗系統的多次改造和反復試驗,了解了氣化爐內溫度場分佈,得出了溫度、物料、抽氣方式等因素對生物質熱解氣的成分、熱值和產氣率影響的一些基本規律,並進行了初步的焦油催化裂解試驗和煤氣燃燒器的熱力特性、燃燒特性試驗,為面向工程應用的集中供氣示範項目提供了必要的設計和運行依據。
  6. These deviations are not acceptable for typical calculations in hat. similar problems occur for caes plants. in order to meet the demands of engineering design, the humid air must be regarded as a kind of real gas and more accurate thermodynamic properties of the humid air are acquired at high temperature and high pressure

    本文針對新型熱力循環中對高溫高壓濕空氣熱力學性質參數的需求,以濕空氣透平和壓縮空氣蓄能系統中的工質為研究對象,在維里狀態方程的框架下,運用對應態原理,提出一個適合計算高溫高壓濕空氣熱力學性質的對應態維里方程,並利用兩種方法對濕空氣的汽液相平衡進行計算。
  7. Conservation law of mass, the state equation for ideal gasthermodynamic equation and flow rate equation are used to establish first order differential mathematic model, and a special investigation on mass flow rate coefficient for different components are carried out to make the model more accuarate

    從模擬和實驗兩個方面進行研究,著重於把ameset和客戶化定製兩種方法結合起來使用,利用質量守恆定律、理想氣體狀態方程、熱力學方程、流量方程等建立一階微分數學模型,並配以amesim平臺對所建立的模型進行進一步的系統模擬驗證。
  8. The precise measurement of thermodynamic temperatures, for example with a gas thermometer, is very difficult. practical temperature scales were therefore introduced to make use of instruments such as platinum resistance thermometers which are much easier to use and give much higher precision measurements

    要準確測量熱力學溫度(如使用氣體溫度計來進行測量)是十分困難的,因此利用鉑電阻溫度計等作測量器的實用溫標便被採用,令使用更為容易及測量更為精確。
  9. The thermodynamic analysis of a stirling power cycle working with ideal bose gas

    以理想玻色氣體為工質的斯特林熱機的性能分析
  10. A general solution of the thermodynamic energy of systems of gas, magnetic dielectric, dielectric, and of battery was found by working from thermodynamics first law ' s different forms in different matter systems, by using equation of state and thermal capacity in different thermodynamics system and by solving thermodynamic energy differential equation, thus provide a method of studying other qualities in thermodynamics system

    摘要通過熱力學第一定律在不同物質系統中的不同形式,利用不同熱力學系統相應的物態方程及熱容量,以及通過求解熱力學能微分方程,一般性地求解了氣體系統、磁介質系統、電介質系統、電池系統的熱力學能,為研究其他熱力學系統的特性提供了一種方法。
  11. Some novel results are obtained, which will not only provide some theoretical bases for the optimal design and performance improvement of real thermodynamic cyclic equipments such as ferroelectric refrigerators, magnetic refrigerators and gas heat engines but also promote the development of new fields such as gas refrigerators for ultra - low temperature applications, molecule refrigerators and laser refrigeration technologies

    這些結論將對鐵電製冷機、磁製冷機、氣體熱機等實際的熱力學循環裝置的優化設計或性能改善提供理論指導,對極低溫下的氣體製冷機、分子製冷機和激光製冷技術等新領域也將所啟發和促進。
  12. The result of experiment showed that the reaction between ti and c is a thermodynamic course, when 2 wt % mg is added to melt, it can restrain the formation of fragility phase al3ti, and gained al matrix composite which contained tic reinforced particles only. because mg reacts with the forms a micro - high temperature field around the oxide around the graphite particles and the oxygen gas which is brought by the immersion bell, and the reaction gives out a lot of heat energy, thus forms many high micro - fields in melt, which prompt the reaction between the al and ti

    加入適量的mg ( 2wt )可以抑制tic al復合材料中的脆性相al _ 3ti的產生,生成僅含tic的鋁基復合材料;由於活化劑鎂在體系中與石墨顆粒周圍的氧化物、以及外來的氧反應放熱,在熔體中形成微高溫區,促進al - ti反應,同時, al - ti反應也是放熱反應,因此體系中的內能急劇增大,促使al _ 3ti分解以及ti朝c顆粒擴散,縮短反應的孕育時間。
  13. The results show that the thermodynamic properties of propellant combustion gas products have an important effect on its expanding power, and the correlation between conventional energy parameters such as impetus, potential energy and its power capability is not identical

    結果表明,發射藥燃氣產物的熱力學性質對其膨脹做功具有較大的影響,傳統的火藥力或潛能能量參數與做功能力之間的關系並非完全一致。
  14. The calculated results are in agreement with the measured ones, indicating that according to the flow rate and composition of the exhaust gas and the mass and the carbon content of the liquid iron, the carbon content of steel bath can be dynamically determined ; with the aid of thermodynamic equilibrium analysis, the dynamic variation of temperature of the steel bath can be forecasted from the dynamic carbon content and the data from the exhaust gas analysis system

    該模型計算結果與檢測結果吻合較好,這表明:通過煙氣流量、成分及鐵水質量和初始碳含量可動態地確定熔池中的碳含量;以動態確定的碳含量為基礎,結合爐氣分析數據,再經熱力學平衡分析,可預測熔池溫度的動態變化。
  15. Analysis of the thermodynamic featurs of gas - steam combined cycle generating unit and the thermodynamic economy of gas turbine

    蒸汽聯合循環發電裝置的熱力特性及燃氣輪機熱經濟性分析
  16. At the same time, gas turbine total energy system has drawn more attention and gotten wider application in recent years, so it deserves a comprehensive analysis concerning its thermodynamic performance

    另外,以燃氣輪機為核心的總能系統獲得廣泛應用,應對其熱力性能作出分析。
  17. Based on the experimental results, this paper puts forward a thermodynamic model for prediction of was precipitation in gas condensate mixtures

    摘要根據實驗研究結果,提出了一個可以預測凝析油氣體系蠟沉積的熱力學模型。
  18. Considered the current researching situation, this paper proposes to set up a theoretical model to describe the thermodynamic properties of gas mixture ngh based on researching results for single composition

    針對目前的研究現狀,提出了在已知水合物氣體組成情況下,如何建立分析組分不同的天然氣水合物的熱物理性質的理論模型問題。
  19. The proportion of natural gas in consumption of energy is constantly rising. gas turbine and engine cogeneration is one of the rational ways in utilization of natural gas. using index system evaluating thermodynamic performance of energy utilization systems on the basis of electricity, the allocation models of the fuel consumption for the gas turbine and engine chp plant were deduced

    本文根據以電量為基準的熱力性能評價思想,研究燃機熱電聯產煤耗分攤問題,並給出了燃機燃氣蒸汽聯合循環熱電聯產、燃機簡單循環熱電聯產系統的電、熱兩種產品生產的煤耗分攤模型。
  20. The research about gas hydrates phase equilibrium, thermodynamic properties, methods of predicting their formation and structures has been fairly fruitful, yet it was later to study about the process of their decomposition

    目前,關於水合物的相平衡理論、熱力學性質、生成預測方法及其結構的研究已經相當深入;而關于其分解過程的研究相對來說起步較晚。
分享友人