gas transfer 中文意思是什麼

gas transfer 解釋
氣體遷移
  • gas : n （pl gases ）1 氣，氣體，氣態 〈cf fluid; solid〉 2 可燃氣，煤氣，沼氣；【礦物】瓦斯。3 【軍事...
  • transfer : n 1 移轉，轉送；調職；調任[轉學]證書；變換。2 （財產；權利等的）轉讓，讓與（證書），移轉，授受；...
  1. Transfer rule of water - gas two phase flow in coal bed

    氣兩相流在煤層中運移規律
  2. The following are the large projects undertaking by haifeng company : crude oil electricity plant project of north china oil field hydroelectricity factory, apartment ( 22 stories ) of yuanda real estate company of dalian shipping group, helios hotel of helios group in dalian development zone, tilt aqueduct bridge of shanxi hongqi reservoir ( total span : 267m ), supply and sale building and city construction building ( both are antique architectures ) of shanxi heyang city, sea drainage pipe of hainan fudao fertilizer factory ( 1520 ), 8 oilgas docks of hainan haiyan oilgas company, basha condensable gas transfer station of haiyan company, 10, 000m3 oilgas storage tank of arco company ( usa ) in hainan nanshan, gas pipe and fuel gas installation project of hainan nanshan electricity co., ltd, base and accessory project of hainan gas company, bei da huang cereal and oil market in harerbin, hainan cross island pipe, changhuajiang river pipe crossing project, taihangshan mountain earthwork project ( the 19th section of west - to - east gas transmission project )

    海南海峰公司承建大的工程項目：華北油田水電廠原油發電站工程；大連船泊集團遠達地產公司的遠達公寓（ 22層） ；大連開發區香港太陽神集團的太陽神大酒店；陜西紅旗水庫斜拉渡槽工程（全跨267m ） ；陜西合陽供銷大樓及城建大樓（均為仿古） ；海南富島化肥廠排海管線（ 1520 ） ；海南海燕油氣公司八所油氣碼頭；海燕公司白沙液化氣中轉站；海南南山美國阿科公司儲油氣萬立米大罐工程；海南南山電力股份有限公司天然氣管線及燃氣安裝工程；海南南海天然氣有限公司基地及配套工程；哈爾濱北大荒糧油批發市場；海南環島管線；昌化江穿越工程；西氣東輸十九標段，太行山土石方工程。
  3. The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump

    文中探討了低溫泵性能參數的確定；大抽速低溫抽氣面的熱負載的確定及合理分配；冷凝面上豎直圓管內受熱建立穩定流動的條件；冷凝面與杜瓦間的連接管道內氣液「雙相流動」的平衡條件；低溫泵系統運行的安全問題。
  4. Gas - liquid mass transfer of oxygen - decane - sodium sulfite system in a stirred autoclave reactor

    硝酸反萃體系中表面活性劑對傳質的影響
  5. In the model the film thickness in the passage was obtained at first using two phase flow theory ; then, similar analysis solution of concentration distribution of the pollutant in liquid phase and biofilm was obtained through mass component equation of pollutant in gas - liquid phases combined with the biochemical kinetic equation of mass transfer in biofilm and dismission of oxygen limited ; at last, the distribution of pollutant along the filter height and the waste gas purification efficiency were obtained

    該模型首先運用兩相流理論獲得了通道內液膜厚度，然後通過污染物在氣相、液相的質量組分方程，結合生物膜內的傳質與不?慮氧限制的生化反應動力學方程，獲得了污染物在液相和生物膜中濃度分佈的近似分析解，最終得到污染物在氣相中沿塔高的濃度分佈及廢氣凈化效率。
  6. By comparing the dry plate pressures drop and distributions of velocities simulated on single valve with those of double valves, it was found that there was intense turbulence in the flow fields around fixed - valve, there were eddy areas between valve side orifices and tray wall, there were eddies above the valves too, these led to the complex behaviors of gas perforating valve, these had a great effect on the gas - liquid mass transfer process. at the same time, in order to prevent the disadvantageous effect of gas between one valve with another on the gas - liquid mass transfer, it was very effective to change the fields of gas perforating valve by folding the edges of valve

    通過對數值模擬得出的單閥和雙閥塔板的干板壓降及流場速度分佈分析對比后發現，固定閥周圍流場存在較強的湍動，閥側孔與塔板壁面區域以及閥體的上方空間存在明顯的渦流區，使氣體穿閥后的行為變得復雜，並對氣液傳質過程產生重大影響；模擬結果表明，為防止和削弱固定閥間的對沖造成的「死區」對傳質帶來的不利影響，通過折邊來改變氣體的氣路是非常有效的，模擬值與實驗值基本得到吻合。
  7. All investigators in mass transfer assumed plug flow of gas in packed beds.

    所有傳遞問題的研究者都假定在填充床層中的氣體為活塞流。
  8. In the third, this paper makes a survey on components of the exhausted flue gas and waste heat resource, and discusses the possibility and methods of steam generation and air preheating with the waste heat. and then, the analysis on the advantages and disadvantages of heat recovery plants with conventional steel - water heat pipes and inorganic heat - transfer heat pipes is carried out. the paper also gives a valuation about the plan and features of the design of heat recovery

    對余熱源排煙的成分和余熱資源量進行標定，討論余熱回收產生蒸汽或加熱燃燒用空氣的可行性和方法，分析常規余熱回收技術設計、採用普通鋼-水熱管和無機傳熱熱管等傳熱元件的設計余熱回收裝置的優缺點，並對余熱回收設計方案及其特點進行總體評價。
  9. 417 the transfer medium in this pipeline is liquid ammonia ( process air, soft water, alkali liquor, acidic gas )

    這條管線的輸送介質為液氨（工藝空氣、軟水、堿液、酸性氣體） 。
  10. The core of the gas flow can be considered to be remote from viscous or heat transfer effects.

    氣流的中心部份可以認為是與粘性或傳熱效應關系不大。
  11. The hydrodynamic parameters and mass transfer coefficient are studied in the internal loop airlift bioreactor used in treating wastewater. the hydrodynamic parameters consist of gas holdup, liquid velocity and axial dispersion coefficient

    本文從流體動力學和傳質動力學兩個方面考察了用氣升式內環流生物反應器應用於廢水處理的性能。
  12. Aiming at the existence of coal dust and gas in the coalmine environment and the special requirements of mine case explosion - proof surface process, the error conversion model, shape precision characteristics, transfer drawings, descriptive equation and error transfer structure chart in the production technological process of case accessories adopting the information flowchart of control theory are discussed, which simplify the traditional block diagram of technological process and represent the relationship of working procedure ( variable ) by information flowchart instead of miscellaneous block diagram

    針對煤礦井下煤塵和瓦斯存在的環境特性、煤礦井用箱體防爆面加工的特殊要求，採用控制理論的信息流圖，對工藝過程中傳統方塊圖進行簡化，使繁雜的方塊圖解採用信息流圖表示工藝過程的工序（變量）之間關系。
  13. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。
  14. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  15. Submerged combustion with high efficiency and less pollution using in gas boiler has the characteristics of high heat transfer efficiency and saving energy

    浸沒燃燒法作為一種高效無污染的傳熱方法用於小型燃氣鍋爐，具有傳熱效率高、節約燃料的特點。
  16. Numerical simulation of mass transfer in the cathode of a proton exchange membrane fuel cell with interdigitated gas distributors

    交指型電極的質子交換膜燃料電池陰極內傳質過程的數值模擬
  17. The analysis on condensation heat transfer of flue gas

    煙氣冷凝換熱過程分析
  18. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  19. Gas transfer by bubbles between ocean and atmosphere q

    海洋大氣間氣泡的氣體輸運
  20. Suggestions on ecological rehabilitation along pipeline of gas transfer project from west to east in ningxia section

    西氣東輸寧夏段管道沿線生態修復建議
分享友人
分享到 Line

分享到臉書