gate stem 中文意思是什麼

gate stem 解釋
導葉臂
  • gate : n 1 大門，扉，籬笆門，門扇。2 閘門；城門；洞門；隘口，峽道。3 【冶金】澆注道，澆口，切口；【無線...
  • stem : STEM ＝Scanning transmission electron microscope 掃描透射式電子顯微鏡。n 1 （草木的）莖，干，梗；...
  1. The corrosion resistant plate penstock is in the frame of obvious - stem, which mainly consists of lifting device, frame, gate plate, seal, wedge block compressing set, rod and rod joint, rod guide tube, install accessory and etc

    不銹鋼閘門為明桿式結構，主要由啟閉裝置、閘框、閘板、密封件、楔塊壓緊裝置、門桿和桿接頭、桿導架、安裝附件等組成。
  2. Shipbuilding - bronze 5k rising stem type gate valves

    造船.青銅制5k提升桿式閘閥
  3. Shipbuilding - bronze 10k rising stem type gate valves

    造船.青銅制10k提升桿式閘閥
  4. After closing a gate valve with sufficient force to develop shutoff, the stem should be backed off slightly ( 1 / 8 to 1 / 4 turn ) to relieve stem load

    在以足夠的力量關閉閘閥后，閥桿應該稍微回轉（ 1 / 8至1 / 4圈） ，以釋放閥桿負載。
  5. Note that stem load is applicable to gate valves only as this force is included in the seating force of globe and stop - check valves

    注意，閥桿負載只適用於閘閥，因為截止閥和截止止回閥的閥座力包含了閥桿負載。
  6. Gate valves are normally installed in horizontal pipe runs with the stem vertical

    閘閥通常安裝在水平管道上，閥桿垂直向上。
  7. Gate valves are normally installed in horizontal pipe runs with the valve stem vertically up

    閘閥通常安裝在水平管道上，其閥桿垂直向上。
分享友人
分享到 Line

分享到臉書