gauss beam 中文意思是什麼

And it is also found that the polarized incident gauss beam become depolarized after emitting from the bottom of solid immersion lens. the beam dimension of the emitting optical field at the near - field bottom of solid immersion lens is " broadened "

在固體浸沒透鏡底面的近場區域，出射光場發生了退極化，使得出射總場的光斑有了一定程度的「增寬」現象。

The optical near - field distribution and propagation properties of solid immersion lens system are analyzed in detail when illuminated by linearly polarized focusing gauss beam. the change of the optical intensity and beam dimension at the bottom of solid immersion lens with different refractive index and different distance are discussed. the simulated results reveal that the higher the refractive index is, the stronger the optical intensity and the smaller the beam dimension at the bottom of the solid immersion lens will be

編制了對固體浸沒透鏡近場超高密度光存儲系統進行模擬的二維時域有限差分程序，實現了對固體浸沒透鏡光存儲系統的數值模擬；著重研究了線偏振的高斯光束通過固體浸沒透鏡的光傳輸和近場光場分佈特性；分析了固體浸沒透鏡底面出射光強、光斑直徑隨固體浸沒透鏡折射率的變化、光透過固體浸沒透鏡后的強度、光斑直徑隨離開固體浸沒透鏡底面距離的變化。

On one hand, is the product of beam waist radius and half divergence angle, wavelength is not involved. so there is possibility to compare the acutal focusing ability among laser beams with different wavelength. on the other hand, is a calculated result by measuring experiment, and it is more brief and persuadable than m 2factor, since the latter one is a ratio with basic mode gauss beam

論文研究論證了用值評價激光光束質量的實際意義在於兩個方面，一方面它僅僅包含了光束束寬和發散角，不涉及波長的因素，使不同波長激光束的可加工能力具有可比性;另一方面，值是根據對光束傳輸路徑上不同位置處束寬實際測量結果的計算值，比其在與基模高斯光束進行比值計算得到的m2因子更簡潔、更有說服力。

On the basis of this, we selected rms as feedback variable and constructed the controller g : add this controller to the right of ion radial self - edlctric force equation like equation ( 1 ). we simulated the motion of ion beam by using muti - paticle code ( partice - in - cell ( pic ) code ). the results demonstrated that the beam halo of five different initial distribution is eliminated well under the same controller. the halo intensity of k - v distribution, water - bag distribution and parabolic distribution and be reduced to zero. in the case of 3 - sigma distribution and full gauss distribution, the result is agree with minimum limitation ( 10 " ) of halo intensity of factual high intensity accelerator

在此基礎上，選擇a為控制變量，構造延遲反饋控制器g ： g （ s glrrms （ s ）一rms （ s ） （ 2 ）同（ l ）式一致，將此控制器函數加在粒子徑向所受束自生場力方程的右邊。利用多粒子數值模擬程序（ pic ）進行了控制試驗。模擬結果表明，用同一個控制器和同一個控制參數即可實現五種不同初始分佈情況下的束運一混飩的有效控制。

The propagation characteristics of the diffraction field by a circular aperture of bessel - gauss beam

高斯光束圓孔衍射場的傳播特性

Under the condition that the beam is chirped, demands for soliton formation from gauss beam and the evolution equations of the beam chirp in the propagation are obtained

我們得到了在光束具有線性空間啁啾的條件下高斯光束形成孤子的條件以及傳輸過程中光束啁啾的演化方程。

The propagation and control of soliton in nonlinear kerr optical lattice with harmonic modulation of refractive index are investigated analytically and numerically in this paper. and some innovative research results have been worked out. the forming conditions of lattice soliton from gauss beam and the two modes of its stable propagation are obtained for the first time

本文利用解析和數值方法研究了在具有橫向折射率周期性調制的克爾型非線性光學格子中孤子的傳輸和控制，做出了一些創新性的研究結果:首次得出了高斯光束形成格子孤子的條件和兩種穩定傳輸形式。

According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。

Besides, the electromagnetic field distribution promotes effective interaction between electron beam and the electromagnetic wave, and only thousands of gauss of guide magnetic field are needed

同軸波導內場分佈也有利於實現高效率的注波互作用，聚束磁場僅需要數千高斯。

But the complex analytical signal ( cas ) theory can erase this spatial sigu - larity. in this section, gauss, hyperbolic and lorentz pulsed gaussian beam have been derived and compared svea and cas solution by numerical simulatio n. in section 3, by using fourier transform technique and applying the paraxial approximation in frequency domain, we derive an integral solution for the transverse and longitudinal components of the light field propagating in free space

接著，考慮了幾種特殊的脈沖gauss光束（ pulsedgaussianbeam ） ，結果顯示，在此情況下緩變包絡近似（ slowly - varyingenvelopeapproximation ）理論已不再有效，其失效的原因是，該理論導致了脈沖光束解的空間奇異性，並使脈沖光束不再具有符合物理意義的光束行為，而通過復解析信號的分析方法可以消除這種空間奇異性。

In order to reduce the effect of line - structured laser source on the m easuring accuracy, a unidirectional expanding optical path for the nonlinear sou rce is presented, which can accomplish shaping and intensity correction of gauss ian beam

為了減小線結構光傳感器光源對測量精度的影響，設計了一種集整形和能量校正為一體的非線性光源單向擴展光路。