general circular 中文意思是什麼

general circular 解釋
總務通告
  • general : adj （opp special）1 一般的，綜合的，通用的。2 普通的，廣泛的，通常的。3 全體的，總的；全面的，普...
  • circular : adj 1 圓的，圓[環]形的。2 循環的；巡迴的。3 通告的，環游的；供傳閱的。4 夥伴的，團體的。5 【邏輯...
  1. So far, the main frame of the conjugation of betrand are established, on the basis of which, it is given that the primary condition the directrix line must be satisfied, the relative curvature of the conjugating surfaces, the relations between non - interventional condition and curvature axle of the directrix line, and so on. the transmission of normal circular - arc gear is a typical bertrand conjugation. in order to promote the transformation from theory to technology, the general principle of this kind of transmission is studied

    為了使研究更加貼近於工程，便於解析處理，提出準面的概念，並確立由準面到準線的研究路線，給出了各種傳動形式下準面與準線的具體特徵，證明了共軛準面上兩準線的誘導測地曲率等於零的這一不干涉條件，進而指出，當準面為平行軸和相交軸傳動的節曲面時，不干涉條件自然滿足。
  2. On this base, it is studied that the general principle of normal circular - arc gear transmission, and with the instruction of which, the principle and technology of the loxodrome normal circular - arc spiral bevel gear transmission is studied

    在這一原理指導下，論文從解析研究與實驗研究結合上，研究了斜航式法向圓弧螺旋錐齒輪傳動技術。
  3. In this thesis, studies are focused on as follows : ( 1 ) based on analyzing the general transfer - matrix, the conception of the generalized double layer soil model is proposed, and the transfer - matrix ( r ) of half - infinite elastic mass is introduce - d to the analytic expressions of stress and settlement under the uniform circular, rectangular and strip vertical loads in multi - layered soil ; ( 2 ) according to the analytic expressions of the additional stress and settlement under unifo - rm circular in multi - layered soil, rectangular and strip vertical loads, the programs are develop - ed to resolve and debugged. the results show that the programs are correct ; ( 3 ) through calculating the coefficient of additional stress on the central axis of uniform circ - ular vertical loads, under the corner point of the uniform rectangular vertical loads, and on the central axis of uniform strip vertical loads, and the settlement on the center of uniform circular vertical loads and uniform rectangular loads in double - layered soil, the characters of stress and settlement are discussed ; ( 4 ) a case, as an example, is studied with different calculation methods, such as traditional theory, fem. the results obtained are compared

    本文在已有研究成果的基礎上進一步開展了以下幾方面的研究： （ 1 ）在對層狀地基傳遞矩陣法中的總傳遞矩陣分析的基礎上，提出了廣義雙層地基模型的概念，並把半無限體的傳遞矩陣r引入到多層地基在圓形垂直均布荷載、矩形垂直均布荷載及條形垂直均布荷載作用下附加應力與沉降的解析式中； （ 2 ）根據多層地基在圓形荷載、矩形垂直均布荷載及條形垂直均布荷載作用下附加應力與沉降的解析式，編制了程序，調試通過並驗證了其正確性； （ 3 ）通過對雙層地基圓形垂直均布荷載中心軸線上的附加應力系數和荷載中心沉降，矩形垂直均布荷載角點下的附加應力系數和荷載角點沉降及條形垂直均布荷載中心軸線上的附加應力系數進行的計算，探討了雙層地基中的附加應力與沉降特性； （ 4 ）應用本文的層狀地基體系理論對一個工程實例進行了計算分析，並與傳統的計算方法的計算結果和有限單元方法的計算結果進行了對比分析，結果表明利用層狀地基理論計算更能反映地基中附加應力分佈的實際情況。
  4. According to biot - savart law, the general expression of magnetic field distribution generated by circular current in space has been calculated in this paper, which further discusses the magnetic field in the plane, the central axis and the far space

    摘要直接由畢奧薩伐爾定律的計算公式，在更為普遍的情況下，計算出了圓形線電流在全空間的磁場分佈，並進一步討論了其在中心軸線上、平面內及遠區的磁感應強度。
  5. The general technical specifications of hobs for double - circular - arc gear

    雙圓弧齒輪滾刀技術條件
  6. Circular of the general office of the state council concerning matters relating to students studying abroad

    國務院辦公廳關于在外留學人員有關問題的通知
  7. We urge the postmaster general to review the post office s system of controlling and monitoring the overtime work of delivery postmen to ensure that the guidelines laid down in the relevant civil service bureau circular are fully complied with

    委員會促請郵政署署長檢討郵政署管制及監察派遞郵差逾時工作的制度，以確保其制度完全符合公務員事務局發出的有關通告所載各項指引。
  8. Measurement of fluid flow by means of pressure differential devices inserted in circular cross - section conduits running full - general principles and requirements

    用插入圓截面管道中的壓差裝置測量流體流量.一般原理和要求
  9. Circular of the general office of the state council on theapproval and

    國務院辦公廳轉發勞動部人事部關于進一步落實外商投資企業用人自主權意見的通知
  10. Circular of the general office of the state council concerning port supply to foreign and chinese oceangoing vessels

    國務院辦公廳關于做好外輪和遠洋國輪港口供應工作的通知
  11. Circular of the general office of the state council on related matters concerning the establishment of duty - free stores markets

    國務院辦公廳關于設立外幣免稅商店場有關問題的通知
  12. Circular of the general office of the state council on adjustment of the provisions concerning personnel sent abroad on official duty

    國務院辦公廳關于調整因公出國人員有關規定的通知
  13. Circular of the general office of the state council concerning the completion of formalities concerning ratification and approval of international treaties and agreements

    國務院辦公廳關于辦理國際條約協定批準手續或者核準手續問題的通知
  14. A general stack equation of mobile robot based on analyzing the motion of planar motion object and the mathematical models of four different kinds of common wheels is developed, accordingly, the mobility of mobile robot is addressed and the forward and inverse solutions to speed for specific configuration driven by differential speed are derived. utilizing the muir and newman convention, the description of the posture transformation matrices between different coordinate frames and the solution for the speed of point located on these frames are introduced. according to posture estimation, a more accurate method, dead reckoning algorithm, is developed for a specified configuration characterized by differential speed motorization, and simulations of this algorithm and other traditional methods are carried out using matlab while traversing a circular path

    本文對兩輪差速驅動移動機器人的運動學及其本體緩沖設計進行了探討，在對平面運動物體運動分析的基礎上結合四種常用車輪的數學模型，推導出了一個通用的移動機器人堆積方程，在此基礎上分析了移動機器人的移動能力、並針對兩輪差速構型推導了速度正解與逆解；使用muir和newman的運動學建模方法，推導了移動機器人上點及連桿坐標系位姿、速度變換關系矩陣及求解方法；在移動機器人位姿識別方法中結合差速驅動構型對航位推演算法進行了分析：推導了一種理論精度較高的航位推算演算法，並使用matlab對其與傳統的推算演算法在跟蹤圓弧軌跡情況下進行了模擬；最後針對本文所研究的機器人給出了一種比較系統、可靠的緩沖結構設計思路，較好地解決了移動機器人作業過程中外界因素及本身設計中引入的各種不確定誤差問題；本論文研究成果已在本實驗室所開發的樣機上得到實現，經過應用與考核證明其中的分析與設計是切實可行的。
  15. Notice, general circular and circular memo

    -公告、一般通告及通函
  16. The sat issued a circular on 24 march 2005 ( guoshuihan [ 2005 ] no. 248 ) relating to vat refunds on general invoices

    國家稅務總局於2005年3月24日發布國稅函[ 2005 ] 248號，就調整出口企業出口貨物憑普通發票辦理退（免）稅的規定作出通知。
  17. The postmaster general, mr. allan chiang, announced today ( 30 june ) that, as from today, the counter network for accepting postings under the services of bulk air mail, hongkong post circular, permit mail and postage prepayment in money will be increased from 24 to 25 post offices to include the yuen long post office located at shop b, gf, 8 yuen long pau cheung square, yuen long

    香港郵政署長蔣任宏今日宣布（六月三十日） ，由今日開始，提供大量投寄空郵服務、香港郵政通函郵件、特許郵遞服務以及現金預付郵費櫃位服務的郵政局數目將由二十四間增至二十五間。新加入上述櫃位服務的郵政局是位於元朗炮仗坊8號地下b鋪的元朗郵政局。
  18. The postmaster general, mr luk ping - chuen, announced today ( august 19 ) that, with effect from august 26, 2002, the counter network for accepting postings of bulk airmail, hongkong post circular, permit mail and postage prepayment in money will be extended from 20 to 24 post offices

    香港郵政署長陸炳泉今日（八月十九日）宣布，由八月二十六日起，提供大量投寄航空郵件、香港郵政通函郵件、特許郵遞以及現金預付郵費櫃位服務的郵政局數目將由二十間增至二十四間。
  19. Ventilation for buildings - ductwork - dimensions of circular flanges for general ventilation ; german version en 12220 : 1998

    建築物內通風.空氣管道.一般通風用圓形法蘭尺寸
  20. In general, circular references are considered undesirable because they introduce complexity and tight coupling

    通常，都不希望出現循環引用，因為它們引入了復雜性和強耦合性。
分享友人
分享到 Line

分享到臉書