governor valve 中文意思是什麼

governor valve 解釋
蒂閥
  • governor : n 1 統治者，管轄者。2 地方長官，總督，縣長，市長（等）；〈美國〉州長，（要塞等的）司令官；〈英國...
  • valve : n 1 【機械工程】閥，活門，舌門；汽門。2 【解剖學；動物學】瓣，瓣膜；（貝）殼瓣；【植物；植物學】...
  1. Pressure governor valve is composed by governing valve, oil, water separation devices and a combination of one - way valves, etc

    調壓閥是由調壓閥、油水分離器及單向閥等構成的一個組合閥總成。
  2. Used the metering - out control system in which the hydraulic cylinder was the executive element as research object in this thesis, the experimental research about the effect on the pressure p1, p2 of the hydraulic cylinder chambers when series - connecting throttle valve or governor valve on the return oil - line under the step load changing have made

    本文以單出桿液壓缸為執行元件的出口節流調速系統為研究對象，在其迴路上分別串接節流閥和調速閥，當負載發生階躍變化時，對液壓缸兩腔壓力p _ 1 、 p _ 2的影響進行了試驗研究。
  3. Because the output pressure signal of the manoeuvring valve ( pos. no. 01 - ) corresponding to the regulating handle position determines the output rate of the p. g. governor through the 3 - way valve ( pos. no. 29, lower frame )

    因為操縱閥01 -相應調節手柄位置的輸出壓力信號決定調速器輸出比率通過三通閥29 ，下位。
  4. Air pressure governor valve

    風壓調壓閥
  5. According to the present problems and developing tendency of hydraulic turbine governor, four main issues of this field are studied in this paper. the content include hydraulic control system, frequency measurement unit, stability of the discrete control system, optimization of control parameters and self - adjusting pid control strategy based on fuzzy logic. several main achievement and results are obtained and shown as follows : the electric - hydraulic pilot valve driven by step - motor is firstly proposed, which solves the problem that the electric - hydraulic converter of hydraulic turbine governor hydraulic servo is prone to be stuck and blocked and improves the systemic stability greatly

    本文根據水輪機調節領域存在的問題和發展趨勢，對水輪機調速器的液壓控制系統、頻率測量環節、離散調節系統穩定性與調節參數最優整定以及適應式參數自調整pid控制策略進行了研究，得到以下主要成果和結論：首次提出了採用步進電機驅動的步進式電液引導閥，從根本上解決了水輪機調速器電液隨動系統中存在的電液轉換元件發卡、堵塞問題，使電液隨動系統的可靠性大大提高。
  6. Then the 3 - way magnet valve ( pos. no. 73 ) is deenergized and the speed setting signal raised by the manoeuvring valve ( pos. no. 01 - ) is transmitted to the p. g. governor again

    三通電磁閥73決不會斷電，但通電的原因被消除而且主機安保系統電氣迴路被復位。 [是否有誤？
  7. The control air is supplied to the p. g. governor at the proper rate reduced by the pressure reducing valve ( pos. no. 35 )

    如果你打開此開關，三通電磁閥34動作，控制空氣通過三通電磁閥被傳送到p 。 g 。調速器代替掃氣空氣。
分享友人
分享到 Line

分享到臉書