growth in thickness 中文意思是什麼
growth in thickness
解釋
加厚生長-
In this paper, the course of isothermal crystallization kinetics of polymer in limited volume unit is simulated by use of the method of monte carlo. four factors influenting on the course of polymer in the limited volume unite isothermal crystallization are analyzed under the given conditions. the four factors are sample volume shrinkage, the change of the linear growth rate of entities g, the change of sample thickness and the change of the number of nuclei
本文採用montecarlo方法研究了高聚物在有限體積元中的等溫結晶動力學過程，分析了在一定條件下，樣品體積收縮、晶體線生長速率變化、樣品厚度變化和晶核數目變化這四種因素對高聚物在有限體積元中的等溫結晶過程的影響。 -
The studies of in - layer heterogeneity are as follows : the text depicts the characteristics of heterogeneity by calculating the coefficient of variability, kmax / k and k. max / k. min of sand layers of different sedimentous microfacies ; divides interlayer into two types, and counts their numbers, thickness, frequency and density of a single sand layer according to the characteristics of lithology and logging, finally summarizes the characteristics of interlayer distributing ; sets up five in - layer heterogeneity models and points out that the primary models are model a and c. the studies of between - layer heterogeneity are as follows : the text depicts sand layers " growth and distributing conditions by calculating the lamination factor, sandstone density and overlap coefficient ; makes certain the lithology and thickness of interlayer by the method of contrasting the typical curves
層內非均質性研究，通過計算不同沉積微相砂體滲透率的變異系數、突進系數以及級差來說明主要儲集微相的非均質特徵；據巖性及電性特徵，將層內夾層分為兩類，統計單砂層段內夾層的個數、累積夾層厚度、夾層頻率及夾層密度，並且根據夾層頻率及密度平面分布圖統計出每層的頻率相對高值區和低值區，總結夾層分佈特徵；根據物性參數隨深度的變化趨勢建立了五種儲層層內物性非均質模式，指出研究區內以a型和c型模式為主。 -
Tianjin is located at north part of northern china plain, where is rich in thermal water in sedimentary basin. the main reservoir is carbonate rocks of the paleozoic and upper and middle proterozoic group, which contain thermal waters with temperature of more than 90. the cap rock is cenozoic sedimentary rocks with thickness of more than 1000m, which contains thermal water with temperature from 25 to 70 in 13 sandstone layers. the temperature of thermal water is steady growth along with the deepen of basin. all thermal waters in different aquifers are medical mineral waters, which is conducive to good health
天津位於華北平原的北部，那裡的沉積盆地含有豐富的地下熱水。主要的熱儲層為古生界和上中元古界的碳酸鹽巖層，所含熱水的溫度略高於90蓋巖層為新生界沉積層，在13個砂巖含水層中含有2570的熱水。熱水的溫度隨盆地深度的增加而增加。 -
Theoretical analysis of thickness effect of normal grain growth in thin films
薄膜中正常晶粒生長膜厚效應的理論分析 -
The convergent infrared optical monitor and controller were designed to monitor and control the film thickness in multilayer growth in fabricating immediate and far infrared band - pass filters
摘要針對平行光紅外光學系統存在光斑大、能量損失大等不足，設計了主要用於中遠紅外帶通濾光片膜厚監控的會聚光紅外光學系統及其光控系統。 -
7 within the range of 0 - 200mm nacl concentration, the ratio between cortical thickness and root got lower ; the growth of stele was stimulated ; vessel dm decreased evidently. in stele, conducting tissue was reduced while the growth of pith was stimulated
隨鹽濃度升高，在0億00inmnaci范圍內根皮層半徑的比重降低，維管束在根中的比重逐漸增加，但輸導組織的比重呈下降趨勢，具貯存功能的髓的發育得到促進，導管口徑變小。 -
In the results of eight 2d simulation cases with convective mach number ranged from 0. 2 to 1. 0 the mean velocities and the thickness growth rates are in good agreement with experimental results, but the turbulent fluctuation intensities are larger
對對流馬赫數從0 . 2到1 . 0的混合層的二維數值研究表明，平均速度分佈和擴張率與實驗結果相符合，但湍流脈動強度偏大。 -
The main research findings were as follows : nickel had a higher catalysis than iron in the growth of cnts, and the thickness of catalyst affected the diameter of cnts. compared graphite and iron, when monocrystalline silicon was used as the substrate, cnts had a higher purity
通過sem和tem分析了不同條件下產物的形貌和結構，取得以下主要結果：在兩種單金屬催化劑中，鎳的催化活性高於鐵的催化活性，催化劑薄膜的厚度決定著生長納米碳管的直徑。 -
This paper, regarding the asphalt pavement in the zhoukou region as the study object, according to the prevalent norms ( specifications for design of highway asphalt pavement ), with the beginning of the pavement performance and the transportation investigation, totally and systematically analyzes the traffic parameters and the destroying reason of pavement at the early stage in the point of fatigue property and limit strength, gives the concepts and methods of the growth rate of equivalent axle load action time, seasonal modification factor and overload factor, proposes the method of axle load conversion on the condition of heavy loading. on this basis, it proposes the design method adapting to asphalt pavement construction, explains the steps of thickness computation of construction with the combination of engineering example, finally verifies thedesign method in the paper by test road. theory and practice both prove that the reasonability of pavement structure style and the reliability of design method in the paper can adapt to the present heavy loading and overloading traffic conditions, have highly theoretical and practical value
本文以周口地區瀝青路面為研究對象，以現行《公路瀝青路面設計規范》為依據，從路面使用性能和交通特徵的調查入手，從疲勞特性和極限強度出發分析了路面早期破損的原因，全面系統地進行了交通參數的分析，提出了當量軸次增長率、季節修正系數和超載系數的概念和方法，並提出了重載交通的軸載換算方法。在此基礎上，針對超載、重載交通從結構組合設計、結構厚度計算（包括疲勞強度標準和極限強度標準）等方面提出了適宜的瀝青路面結構設計方法，並結合工程實測，說明了結構層厚度計算的具體步驟，最後通過試驗路驗證本文提出的設計方法。理論與實踐均表明，本文提出的路面結構型式合理、設計方法可靠，能適應目前重載、超載交通的狀況，具有較高理論與實用價值。 -
By means of quantitative analysis, we accessed growth rate and film thickness of gan epilayer, and even determined in real time the thickness of buffer layer from in situ measurements of normal incidence reflectance
通過對在位監測曲線的分析，確定gan生長速率以及外延層的厚度，並利用監測曲線實時標定緩沖層的厚度。 -
In experiments carried out under small reactant source flux, it was found that parameters such as v / ratio, growth pressure, thickness of buffer layer, ammonia flux during annealing and ramping rate have strong influence on the growth of buffer layer, while the influence of tmga flux and pressure during annealing can be omitted
在小反應源氣流下，發現對緩沖層生長影響顯著的條件包括生長比，生長壓力，緩沖層厚度，退火時氨氣流量及退火速率。而ga源流量，退火壓力及的影響相對較小。 -
An attempt is made to use the filled function as the modified function approach to apply global optimization to optical thin film problems. it is proved successful when applied to problems such as antireflection coatings and beam spliters. meanwhile, it is also found that when the number of layers is fixed those local minima with less total optical thickness appear to be better. in the realization. needle method are made to explore the impact of local optimization methods used, parameter of these methods, the starting design, the search accuracy of function and the methods of thickness growth
從理論分析來看，由於光學薄膜的特性是由在入射介質那一側的等效導納所確定的， needle方法把等效導納作為狀態變量，把每一層的折射率作為控制變量，運用最優控制的原理計算出在薄膜內部每一個厚度對應的點上折射率改變所引起的評價函數的改變，由此選取改變折射率后評價函數變化最大（評價函數變小）的那一點進行插入。 -
Prior to the growth, the critical thickness, which plays a vital role in the formation process of qd, is numerically calculated in terms of the strain relaxation, and the growth is carried out under the guidance of the calculated results
在stranski - krastanow （ s - k ）模式下制備了zncdse量子點，在生長量子點之前，先數值計算了系統的臨界厚度，然後在該臨界厚度值的指導下進行了量子點的制備。
分享友人