heat regenerator 中文意思是什麼
heat regenerator
解釋
回熱器- heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
- regenerator : n. 1. （使）新生的人[物]。2. 更新者；改革者。3. 【機械工程】交流換熱器，蓄熱器；回熱器；【電學】再生器；再發器。
-
Abstract : large time delay exists in complicated practical processes. for example, in fccu ( fluidized catalytic cracker unit ) reactor - regenerator, the feed is preheated through heat exchanging from fractional column slurry, thus results in large time delay. a predictive control system is designed for such processes, where the kernal algorithm is dynamic matrix control. application results show that the control behavior is improved than original pid control
文摘:實際的復雜工業過程，往往具有大的時滯，例如：煉油廠催化裂化裝置的反應再生系統，其原料油預熱通過油漿換熱實現，因此時滯特別大.本文針對這一類大的時滯過程，設計了以動態矩陣控制為核心演算法的預測控制系統，運行實踐表明：這一控制方案比原pid控制在控制質量上有較大提高 -
Cooling coils are introduced into the regenerator to control the temperature and remove the excess heat.
在再生器中放進冷卻盤管能控制溫度，也能除去過多的熱量。 -
Parallel flow heat exchanger or regenerator
併流熱交換器 -
This paper analyzed the heat exchange between ceramic honeycomb regenerator and gas, and established a heat transfer process mathematical model for ceramic honeycomb regenerator
摘要分析了高風溫燃燒系統中陶瓷蜂窩蓄熱體和氣體間的熱量交換，建立了陶瓷蜂窩蓄熱體傳熱過程數學模型。 -
Theoretical analysis and experimental results showed that the high emissivity coating speeds up the heat - absorption and heat release process, strengthens heat transfer by radiation and heat conduction in the regenerator, improves heat transfer efficiency and the blast temperature
理論分析和實驗結果表明，熱風爐蓄熱體表面高發射率塗層可以提高蓄熱體的蓄熱和放熱能力，強化爐內輻射傳熱和蓄熱體的導熱，從而提高熱風溫度。 -
Using lithium bromide aqueous solution as liquid desiccant, adopting the total heat transfer rate and enthalpy efficiency to describe the combined heat and mass transfer performance and the moisture removal rate and regenerative efficiency to describe the mass transfer performance of the regenerator, explores the effect of air and desiccant inlet parameters on the regenerator performance by experiment, and compares the result obtained with those of other counter - flow configurations previously published
以溴化鋰溶液為除濕劑，採用總換熱量、全熱效率描述再生器的熱質交換總體效果，採用再生量、再生效率描述傳質效果，實驗測試了溶液和空氣的進口參數對再生器性能的影響，並與逆流再生器的實驗結果進行了比較。 -
It can be concluded that preparation of coating on heat regenerator surface provides a new practical and operable technology for energy saving in steel industry
高發射率塗層技術為鋼鐵企業節能降耗提供實用且可行的新技術。 -
Both the viscous friction and axial heat conduction are included in this model. the analysis presented the optimal regenerator structure parameters of a coaxial traveling - wave thermoacoustic prime mover
熱聲熱機的優化設計在熱聲網路模型的基礎上，設計和優化系統，調節系統中的聲場相位，提高熱聲熱機的效率。 -
Development on simulation system of periodical heat transfer for thin - walled regenerator
薄壁蓄熱器周期傳熱模擬系統的開發
分享友人