heat transfer arrangement 中文意思是什麼

heat transfer arrangement 解釋
熱傳遞裝置
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • transfer : n 1 移轉，轉送；調職；調任[轉學]證書；變換。2 （財產；權利等的）轉讓，讓與（證書），移轉，授受；...
  • arrangement : n. 1. 整頓，整理；排列，布置，分類。2. 〈pl. 〉安排，料理，籌備，預備。3. 商定，約定。4. 調解，和解。5. 改作，改編；改編的樂曲。
  1. The experimental results of air heat transfer show that the relative fin height, relative fin width, relative fin pitch and density of 3 - d ift with staggered arrangement fins all have an effect on heat transfer and flow friction. especially, the effect of fin density is bigger

    空氣換熱實驗的結果表明：肋叉排三維內肋管的相對肋高、相對肋寬、相對肋間距以及肋密度均對其對流換熱特性有影響，其中肋密度的影響較大。
  2. The effects of various structure parameters and fins arrangement of the three dimensional extended surface on heat transfer performance in the 3 - d ift have not been studied systematically

    特別是在三維內肋管肋形結構尺寸，肋排列形式等影響管內對流換熱特性因素的系統研究工作還有待于進一步的完善。
  3. 3 - d ift have three fin arrangements : staggered arrangement fins, in - line arrangement fins and spiral arrangement fins. the former experimental study regressed the experimental data of all three fin arrangements and obtained the heat transfer criterion equation of 3 - d ift, while the paper sets apart the three mixed fin arrangements and applies othorgonal testing method to the 3 - d ift with staggered arrangement fins which is wide used in the engineering

    原有的研究是將三種肋排列形式三維內肋管的實驗數據混雜在一起進行回歸得到三維內肋管的換熱準則式，而本文則將原有研究中混雜不清的肋排列的三種形式區分開來，並對其中在工程中應用最廣泛的肋叉排三維內肋管進行了詳細的正交試驗研究。
  4. The highest heat transfer coefficient for air flowing in the nine 3 - d ift with staggered arrangement fins is no9 tube

    過渡流區和層流區的熱力性能系數分別為2 . 74和1 . 06 。
  5. Firstly, for jet array impingement cooling, the effects of the distance of adjacent holes, the impinging distance and jet reynolds number on heat transfer characteristic at the target wall are summarized under staggered holes arrangement and the same hole diameter. and then, the numerical simulation of inclined multi - hole film cooling has been studied. the influence factors examined in this case include blowing ratio and the distance of adjacent holes

    首先通過對射流沖擊冷卻方式的研究，分析了相鄰孔間距、沖擊間距以及射流入口雷諾數對沖擊靶面換熱系數的影響情況，然後對多斜孔冷卻方式進行了數值模擬，重點探討了吹風比和相鄰孔間距對絕熱溫比與壁面換熱系數的影響規律，最後，針對沖擊-發散復合冷卻流場的計算物理模型，研究吹風比、相鄰孔間距的變化對沖擊-發散復合冷卻流動與傳熱特性的影響。
  6. In this paper, the working fluid is air. experimental study of the nine different structure parameters of 3 - d ift with staggered arrangement fins in the reynolds number range of 250 to 30000 is performed to investigate the characteristics of heat transfer and flow friction behavior. analyses and reduces the experimental data by the least square method, obtains the nusselt and fanning friction fitting criterion equations

    本文以空氣為工質，在re 250 30000范圍內對九根具有不同肋形結構尺寸的肋叉排三維內肋管的換熱及流動特性進行了研究，並運用最小二乘法分析和處理實驗數據，獲得努謝爾特數，范寧摩擦系數與雷諾數，肋幾何參數的準則方程式。
分享友人
分享到 Line

分享到臉書