heated pressure 中文意思是什麼

heated pressure 解釋
加溫抗壓服
  • heated : adj. 1. 熱的;加熱的。2. 激昂的,興奮的。adv. -ly ,-ness n.
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  1. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時,通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣,改變空氣流速,測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數,並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  2. Electrically heated hot water high - pressure cleaner with k ? rcher power nozzle. triple - chamber boiler system. continuous running - resistant long - life pump with three stainless steel pistons. facility for integrated storage of spray lance

    電加熱冷、熱水高壓清洗機。三箱鍋爐加熱系統,非常友好的操做界面,底盤集成油箱,高壓管及附件存儲槽。
  3. Conventionally the power capacitors were manufactured the way their wound cores should be heated and dried in a vacuum drying vessel first, and the cores should be pressed into capacitor shells, then all the unfinished capacitors were put into a vacuum pressure tank for inpregnation

    摘要傳統的電力電容器的生產工藝是將芯體元件卷繞后,先在真空乾燥罐內進行加熱和真空乾燥,然後將芯體元件壓裝到電容器殼內,再在另一臺真空壓力浸漬罐內進行真空壓力浸漬。
  4. Specification for electrically - heated pitot and pitotstatic pressure heads

    電加熱皮託管和皮托靜壓管規范
  5. Rclying on the abundant technical strength of zhejiang university chemical machinery research instiute, it is specially engaged in the production of all kinds of the medical instruments such as the steam modular cylinder, modular dyeing tube, bactcricidal cylinder, gas storage cylinder, fermentation cylinder, heat exchanger, desk type, verticaltype, portable, horizontal electrically - hcated pressure steam sterilizer, carbon dioxide, biochemical, mycetes, illumination, water - sealcd, clectrically - heatedpressure steam sterilizer, dry heating sterilizer, carbon dioxide, bibiochemical, mycetes, illumination, water - sealcd, clectrically - heated, clectrically - heated constant temperature type culture box, fixed temperature and humidity box, climate cabinet exc. meanwhile it offers a full set of the stainless steel utensil serial products to the pharmaceuticals, health - care products, food, drink, cosmetics, uncontaminated workshops and so on. it can design and manufacture various non - standard equipments according to the consumer is requirements. welcome to make inquiry into this company. we are looking forward to cooperating with you

    本公司依託浙江大學化機研究所專業開發,製造各類:蒸汽定型罐、定型染色缸、殺菌罐、儲氣缸和發酵罐、熱交換器、臺式、立式、手提式、臥式電熱壓力蒸汽滅菌器、乾熱滅菌器、二氧化碳、生化、黴菌、光照、隔水式、電熱恆溫培氧箱、恆溫恆濕箱、人工氣候箱等醫療儀器,同時提供製藥、保健品、食品、飲料、化妝品、潔凈車間成套不銹鋼器具系列產品,還可根據用戶要求設計、製造各種非標設備,歡迎您的垂詢,期待您的合作!
  6. If this liquid were heated to a high enough temperature to boil it under normal atmospheric pressure many of the hydrocarbons in it would decompose

    如果這些液體在通常的大氣壓下加熱到足夠的溫度而沸騰,其中許多碳氫化合物會分解。
  7. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗,得出分離式熱管有一最佳充液率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分,通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  8. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗,得出分離式熱管有一最佳充液率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分,通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  9. The specimens of uranium flat were heated in air, oxygen or low pressure, to investigate the formation of uo2 + x and u3o8 on the surface layer of specimens. the processes of oxidation to uo2 + x and u3o8 were analyzed by xrd to determine the extent of surface layer oxidation and the structure of oxidations. the xrd patterns were fitted by rietveld method to refine the structure of different phases and to calculate quantificationally

    對金屬鈾表層在大氣環境中的氧化情況進行分析研究,結果表明:所有溫度條件下,金屬鈾的氧化都是在表層形成一定厚度的uo _ ( 2 + x ) ,只有在較高的溫度條件下(如300 )氧化物才會進一步轉化為u _ 3o _ 8 。
  10. It is a symmetrically heated system, achieving pressure ratios of 1. 10 and 1. 06 with nitrogen and helium as the working fluids, respectively

    在以氮氣和氦氣為工質,加熱溫度為400的情況下分別獲得1 . 12和1 . 06的最大壓比。
分享友人