heating agent 中文意思是什麼

heating agent 解釋
熱媒
  • heating : adj. 1. 加熱的;供熱的。2. 刺激的。n. 1. 加熱;供暖;(建築物的)暖氣裝置。2. 白熾,灼熱。
  • agent : n 1 行為者,動作者;【語法】主動者。2 原因;動因;作用物,(作用)藥劑。3 代理人,代辦人;代理商...
  1. The dichroic agent is polymetric iodine formed by impregnating an initially transparent plastic sheet of polyvinyl alcohol with iodine and heating.

    其二向色劑是聚合磺,它是將透明的聚己烯醇塑料薄片在磺內浸漬后加熱製成的。
  2. Using material, which composition is basically same to substrates through grinding, and then dipping its slurry on substrate with heating 800 and then sintering at 1400. there was no crack on the surface of coating. distinguish between coating and substrate may use sem, from sem micrographs of cross section of coating, there is gradated pore structure, while pore - forming agent is no good for coating

    採用與基體成分相同的原料配製的料漿在經800燒成的素坯上成膜,燒成后發現,添加成孔劑的料漿成膜后表面易於開裂,而未加成孔劑的料漿成膜效果較好。
  3. Making granules from dry powder directly without any bonding agent and to carry out thr 2nd heating and drying

    乾粉直接制粒,無需任何粘結劑,無需二次乾燥。
  4. In - situ ticp / fe composites were prepared by reaction cast method with induction heating, crucible smelting and covering agent

    採用反應鑄造的方法,利用感應加熱、坩鍋熔煉及使用覆蓋劑保護,制備原位tic _ p fe復合材料。
  5. Take the technical reform on longitudinal finned tubular oil / heating agent heat exchanger operated in ( superscript # ) 2 platform of chengdao oilfield center as an example, this paper analyzes 3 failure modes of this kind of heater and presents relative improvement measures

    摘要以埕島油田中心二號平臺縱向翅片管式原油熱媒換熱器技術改造為例,分析了縱向翅向管式換熱器常見的3種失效形式,並指出了其相應的改進措施。
  6. Agent : yes, it is. it was just painted and it has all the modern conveniences, including the heating system

    代理:好。剛剛油漆過,現代化設備齊全,包括暖氣設備。
  7. The thermodynamic conditions of decomposition of the foaming agent tih2, homogeneous and heterogeneous nucleation in high - temperature solid and liquid, growth and movement were achieved to demonstrate the trend of pore evolvement in this paper. moreover, according to the characteristics of in - situ gas foaming, the equations of the height change of foaming samples with heating time were primarily established to study the behavior of foams and to guild the experiment processes

    另外,論文通過大量的熱力學分析,得出了發泡過程中發泡劑分解以及氣孔在固液態時的均勻形核和非均勻形核、氣孔的生長和運動等熱力學條件,揭示了氣孔演化的趨勢;論文還根據內生氣源發泡的特點,初步建立了高溫熔體中氣體發泡高度隨時間變化的方程,為進一步深入的研究發泡機理奠定了一定的基礎。
分享友人