height ratio 中文意思是什麼

height ratio 解釋
高比
  • height : n 1 高，高度；身高；海拔。2 〈常 pl 〉高地，山丘。3 高貴，卓越。4 絕頂，頂點；【聖經】天。5 〈罕...
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度，撞擊塊高度、隔板位置等因素對氣相速度場、隔板兩側配風均勻性、顆粒濃度、濃淡分離比和燃燒器內阻力特性的影響。
  2. Three kinds of trapezoid, delta and airfoil shaped vortex generators are designed based on traditional, sub boundary layer and micro - vortex generators conceptual design, to study the influence of the shape, height, aspect ratio, chordwise position, spanwise position and direction angles of vortex generators on boundary layer separation control

    （ 5 ）綜合分析研究了渦流發生器的工作原理和設計原則。根據國內外資料，研究了渦流發生器形狀、高度、展弦比、尖削比、弦向位置、展向位置和方位角等因素對附面層分離控制效果的影響。
  3. The appropriate maximum stories and the appropriate maximum height of buildings are determined by using the various of control index, such as period, shear - compression ratio, allowable value of drift angle etc when earthquake fortification intensity is 8 degree

    用各項控制指標，如周期、剪壓比、軸壓比、層間位移角等進行對比分析，給出在8度區該結構的最大可建造層數和最大適用高度。
  4. The effect of exit back pressure and length / height ratio of isolator on forebody / inlet flow field is analyzed and discussed in the paper

    本文還研究了隔離段出口反壓及隔離段長高比對進氣道流場的影響。
  5. The ratio of span - height of an ordinary tie beam is always less 2. 5, so the resisting shear is difficult to achieve

    由於一般連梁跨高比小於2 . 5 ，使得受剪承載力很難滿足。
  6. Based on the experiment results, the damage form of abnormal exterior joint are summarized, characteristics of hysteresis curve are studied, the effect of stirrup ratio and height of column section and beam section on anti - shear property of abnormal joint are discussed, working mechanism of abnormal exterior joint is researched, the conclusion that the anti - crack and bearing capacity of abnormal joint are studied by analyzing the minor core of abnormal exterior joint is proposed, the basic data is provided for the design formula of abnormal joints

    根據試驗結果，總結了異型邊節點的破壞形態，研究了節點滯回曲線的特徵，討論了節點核芯配箍率、樑柱截面高度變化對異型邊節點抗剪性能的影響，分析了異型邊節點的受力機理，提出應以「小核芯」為分析單元來研究此類節點抗裂和承載力的建議，為異型節點設計公式的建立提供了基礎數據。
  7. Based on tests of nine 1 / 2 - scaled model slabs under vertical loads, the paper analyzed load - deformation curve and proposed limit value of height - width ratio under axial loads. 2. based on aseismic tests, the paper put forward a model of concrete frame, silica brick and a combination of the two, proposed that the silica brick works as a 45 compression bar, analyzed the factors which may influence bearing capacity of the slab and advised a formula including the numbers of bays and of storeys of the frame

    通過對墻板模型的抗震性能試驗研究，建立了由鋼筋混凝土框格、砌塊以及兩者協同作用三個部分組成的承載力極限狀態下的理論簡化計算模型；提出了墻板中填充塊等效斜壓桿寬度按45度計算的統一量化標準；分析了影響墻板承載力的主要影響因素，給出了表達墻板框格層數和跨數不同的斜截面承載力實用設計計算公式。
  8. The incident wave height h1 / 3 is in the range from 0. 1m to 0. 25m, and the peak period tp in the range from 1. 0s to 2. 0s. the ratio of s / h1 / 3, which refers to the subface level of wharf deck ( s ) to the incident wave height ( h1 / 3 ), is between - 0. 1 and 0. 7. three different shore connecting types : open - piled, permeable slope with armored 1ayer of dolosse b locks and impermeable slope with armored layer of concrete plate, are set in the experiment for the research on the effects of boundary condition with different shore connecting types on the wave impact

    本文的物理模型試驗在大連理工大學海岸和近海工程國家重點實驗室的大波流水槽中進行，試驗中選用的隨機波靶譜為改進的jonswap譜，入射波波高h _ （ 1 / 3 ）范圍為0 . 1m 0 . 25m ，譜峰周期t _ p范圍為1 . 0s 2 . 0s ，碼頭面板的相對凈空（碼頭面板底面距離靜水面的距離s與入射波波高h _ （ 1 / 3 ）的比值）范圍為- 0 . 1 0 . 7 ，其中s / h _ （ 1 / 3 ）為負值時表示碼頭面板底面位於靜水面以下。
  9. From the aspect of the coupling action of geological and engineering conditions, this paper analyzes their influences on high slope stability. the result shows that constructional surface, lithology, slope angle and height are the most influential factors. provided that a slope angle in a stepped slope is constant, the slope stability is very sensitive to the height / width ratios of steps, and the best design for the slope is to make the height of each step no more than one - third of the total height and the height / width ratio between 1 : 0. 2 - 0. 3

    從地質與工程耦合作用出發，分析了地質因素和工程條件對高邊坡穩定性的影響，指出結構面、巖性以及坡角和坡高是邊坡穩定性的重要影響因素，在邊坡角一定的前提下臺階狀邊坡的臺階高寬比對邊坡穩定性影響山十分明顯，一般以每級臺階的高度不超過總坡高的1 / 3 ，高寬比在1 ： 0 . 2 0 . 3之間為最佳設計。
  10. Generally, tidal bore is wave alignment moving upstream estuary, and its surface will break when the wave alignment is strong, which leads to water roll tracing the source. the velocity, which is between small - disturbed wave velocities before tidal bore happens and the one after tidal bore happens, increases with the ratio of tidal bore height to the water depth in wave front

    涌潮一般是向河口上游推進的波列，強度大時，表面破碎，進而發展成溯源推進的水滾，其傳播速度隨涌潮高度與波前水深比值增加，大小介於涌潮前後小擾動波波速之間。
  11. In particular, the concealed bracings have more evident effects in improving bearing and energy - dissipation capacity of the wall slabs in coupled shear walls with lintel beams of relative smaller span - height - ratio. 4

    特別是在連梁跨高比相對小的雙肢墻墻肢中增加暗支撐對雙肢墻承載力、耗能提高的作用更為明顯。
  12. The influences of different reinforcement style of the concealed bracings and different span - height ratio of lintel beams on bearing capacity, stiffness and deterioration process, ductility, hysteresity capacity, energy dissipation and failure features of coupled shear wall were studied through experiment of 7 specimens under low cyclic loading

    通過7個結構試件在低周反復荷載作用下的試驗，研究了不同暗支撐配筋形式、不同連梁跨高比對雙肢剪力墻的承載力、剛度及其衰減過程、延性、滯回特性、耗能、破壞特徵等方面的影響。
  13. A parametric analysis of the inviscid effects of leading edge sweep, sidewall compression, width - height ratio, cowl position and inflow mach number on spillage is finished. numerical simulations are completed for a series of inlets at various flight height and velocity. the research indicates that the area of spillage window, which is mainly determined by the position of the cowl, significantly influences the spillage characteristic of the scramjet inlet

    闡明了側板后掠的側壓進氣道設計參數對構型溢流影響;對不同側板配置方式的側壓式進氣道進行了數值模擬，通過對比分析，發現由唇口板的位置所決定的溢流窗面積的大小對進氣道溢流特性的影響顯著。
  14. A three - dimensional - acoustic doppler velocimeter is used to measure the velocity components of the flow field in all three coordinate directions for different discharge and measurement site. the influence of measurement site and the depth / vegetation height ratio on the measured velocity profile and turbulence intensity and the renolds stress is analyzed. the characteristics of the measured velocity distributions and the results of the previous investigators are used to select an analytical expression for the shape of the velocity profile

    利用三維超聲波多普勒流速儀（ adv ）量測不同位置、不同流量下的瞬時流場。分析了測點位置和水深與植被高度比對時均流速分佈的影響。本文還給出了種樹段紊動強度及雷諾應力的垂線分佈。
  15. At the end of this paper, two methods are given out to solve this problem : ( 1 ) to decrease the width to height ratio of the calculation model, make it not greater than 1 ; ( 2 ) to restrict horizontal displacement of lateral boundary / boundaries and to directly assign ground stress in the field of calculation model

    解決這一問題的方法有兩種： （ 1 ）使計算模型的寬高比盡量等於或小於1 ； （ 2 ）約束計算模型側面邊界的水平位移，在計算域內部給水平地應力直接賦值。
  16. The influence of packing height, ratio of water to entrainer and acetic acid initial concentration to separation effect of azeotropic distillation was studied in detail. simulation calculations of general distillation and azeotropic distillation were carried out. the influence of reflux ratio, theoretical plate, feed position, feed temperature and feed concentration to distillation process were discussed

    （ 3 ）與普通精餾比較，分離要求相同時，共沸精餾時所需要的理論板數要低於普通精餾所需要的理論板數，迴流比減小，可降低設備投資70萬元，塔釜加熱量減少36 % 。
  17. The results show the exit back pressure and length / height ratio of isolator have great impact on exit flow field and starting performance of inlet. high back pressure of inlet will result in unstart

    研究表明：隔離段長高比對進氣道出口參數影響較大；隔離段出口反壓不能太高，否則會引起進氣道不起動。
  18. However, it is found that there is a certain relationship between simulated result of non - uniform horizontal ground stress and geometrical shape of calculation model : the greater the width to height ratio of the calculation model is, the more unsatisfactory the simulation validity is and the greater the difference between practical ground stress and simulated stress is

    通過簡單模型的模擬試驗，發現採用這種應力邊界條件對水平地應力的模擬效果與計算模型的幾何形狀之間有一定的關系：計算模型的寬高比越大，模擬效果越不理想，與實際的地應力狀況相差越大。
  19. However, for vertical roof solar chimney or inclined roof solar chimney with both ends open, either a large optimum gap - to - height ratio or no optimum chimney gap was found in the range of chimney gaps investigated

    但是，對于帶有豎直集熱板或傾斜集熱板屋頂式太陽能煙囪（其特點是兩端完全開口） ，在研究范圍內，或者得到很大最佳的寬度與高度的比值，或者沒有找到最佳空氣通道寬度值。
  20. At last some further research proposals of strengthening concrete structures with hfrp were presented : besides the theoretical descriptions of the durability of hfrp and its successful applications, further experimental research should be carried out to study its feasibility in strengthening concrete ; in order to inspect and amend the practical effect of the reasonable matching, experimental study of concrete columns and beams ( the author have fabricated 30 hfrp strengthening concrete columns with a diameter to height ratio of 1 : 3 and 15 concret

    汕頭大學碩士學位論文摘要最後提出了今後hfrp加固混凝土結構的研究設想，主要是: hfrp的耐久性除進行合理的應用實例和理論分析外，還需通過試驗研究進一步論證其可行性。應將合理匹配用於樑柱加固試件（作者已製作30個直徑/高為1 : 3的hfrp加固柱試件和15根混凝土梁試件供后續實驗研究之用。 ） ，檢驗實際效果，並進行修正。
分享友人
分享到 Line

分享到臉書