high temperature compressive 中文意思是什麼

high temperature compressive 解釋
高溫結構組分
  • high : adj 1 高的〈指物，形容人的身高用 tall〉；高處的；高地的。2 高級的，高等的，高位的，重要的。3 高尚...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • compressive : adj. 有壓力的，壓縮的，壓榨的。adv. -ly ,-ness n.
  1. When the alumina fiber accounted for 10 %, the density of the composites was chiefly high and the fiber evulsion effect was reinforced ; when the alumina fiber accounted for 30 %, the fiber evulsion effect, fracture and bridge - connection effect were mainly strengthened, when the fiber proportion was 50 %, at the temperature of 1500 c, the bending strength reached 26. 11 mpa while the compressive strength was 79. 30 mpa

    氧化鋁纖維含量為10和30的試樣增強機理不同，含量為10時，復合材料以基質密實度高、纖維拔出效應增強為主；氧化鋁纖維含量為30時，復合材料以纖維拔出、斷裂、橋聯效應增強為主。當纖維含量為50時，在1500下燒成，其抗折強度達到26 . 11mpa ，耐壓強度達到79 . 30mpa ，該復合材料可用作輕質保溫材料。
  2. We must take account of crack resistance when doing mixture design. after systematic and scientific determination and analysis of temperature contraction property, aridity contraction property and strength index, the thesis have chosen the best grade limits in which crack resistance and compressive strength are high. this conclusion is based upon standard ? grade limits of cement stabilizing crushed stones subbase

    本課題在對水泥穩定類材料溫縮、干縮性能以及強度和模量等指標的測試分析前提下，以規范原有的水泥穩定碎石基層級配范圍為基礎，選擇出抗裂性和抗壓強度兩項指標俱佳的級配范圍。
  3. For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas, the separated combustion chamber provided with low heat radiation structure was designed, meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up

    摘要為實現單一燃料天然氣的壓燃著火，針對天然氣自燃溫度高的特點，設計了具有低散熱結構的分隔式燃燒室，同時設置了進氣管空氣加熱裝置和分隔室內陶瓷電熱塞加熱裝置。
  4. On the contrary, if temperature gradient is relatively low, combustor only undergo low compressive stress at high temperature. the combustor of engine has a longer life length. these results can provide some reference for maintain and design for gas turbine combustor

    分析也表明，若在起動過程中筒壁的溫度梯度較為平緩，火焰筒的氣膜唇邊在起動完成後始終受微小的壓應力作用，火焰筒的壽命可以大大延長。
  5. The traditional level measuring methods can n ' t meet our demand because the subjective investigated is in such a poor systemic condition that the temperature is a little high and there ' s so many mill dust and steam there. in this article we perform systemic discuss and research against the dynamic level measuring method under special working condition on the basis of analyzing kinds of level measuring technique in and abroad. first we establish the pressure distribution mathematic model in storage bin and then deduce the mathematic relation between level height and the uniform stress on the bottom of the bin and designed a resistance compressive stress sensor used for the special condition and put forward a resoivement according to its zero excursion existing in practical use

    由於本研究系統被測對象環境溫度較高且潮濕，同時料倉中有大量粉塵及蒸汽，因此傳統的料位檢測方法不能滿足本測試要求。本文在分析國內外各種物位檢測技術的基礎上，針對特殊工況下動態物料高度的檢測進行了系統的探討與研究。首先建立了料倉中的壓力分佈數學模型，推導出料位高度與倉底均布壓力間的數學關系式，並據此設計了中溫電阻應變式壓力傳感器，同時對它在實際應用中存在的零點漂移等問題提出了改進措施，提高了傳感器性能，解決了上述特殊工況下動態物料檢測的技術難題。
  6. Abstract : in experimental conditions, simulating reducing atmosphere in blast furnace, the samples of al2o3 - c brick is heated at high temperature. the microscopic structure of al2o3 - c brick is observed by scanning electric telescope before and after heating and compressive strength and rupture strength are measured. on the base of them, the reason resulting in the changes is analyzed

    文摘:在實驗室條件下模擬高爐還原氣氛高溫處理鋁碳磚試樣，觀察處理前、后鋁碳磚的顯微組織形貌的變化，並測定其抗壓、抗折強度，分析引起這種組織變化的原因
  7. If there are high temperature gradient between cool liner and hot liner, compressive plastic strain appear at that transient time, which lead to gas film wall bearing high tensile stress at high temperature. high tensile stress is one of main reasons which destroy combustor

    分析表明，起動過程中由於熱傳導滯后引發的溫度梯度可以導致火焰筒氣膜唇邊在起動瞬間發生較大的壓縮塑性應變，進而使得該區域在工作時承受較高水平的拉伸應力，高的拉應力會導致火焰筒萌生裂紋。
  8. The strength variation of pellets during oxidizing roast was studied with a high temperature compressive tester with adjustable atmosphere

    通過還原反應后的高溫抗壓強度研究估算了球團礦焙燒中必要的強度。
分享友人
分享到 Line

分享到臉書