high-low temperature chamber 中文意思是什麼

high-low temperature chamber 解釋
高低溫箱
  • high : adj 1 高的〈指物，形容人的身高用 tall〉；高處的；高地的。2 高級的，高等的，高位的，重要的。3 高尚...
  • low : adj 1 低的；淺的，矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • chamber : n 1 〈古、詩〉室，房間；寢室，臥室；〈pl 〉套房；〈pl 〉律師[法官]辦公室。2 會議室，會場；議會，...
  1. For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas, the separated combustion chamber provided with low heat radiation structure was designed, meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up

    摘要為實現單一燃料天然氣的壓燃著火，針對天然氣自燃溫度高的特點，設計了具有低散熱結構的分隔式燃燒室，同時設置了進氣管空氣加熱裝置和分隔室內陶瓷電熱塞加熱裝置。
  2. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  3. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  4. Abstract : the forced state in key parts and their lifetime, the volume of high pressure chamber and ratio of pressure, the length of high pressure stroke and pressure stability, the relations between the deformation of high pressure chamber and temperature field and pressure field for three kinds of apparatus of making synthetic diamond under high pressure and high temperature were compared in this paper. the differences of these main apparatus were analyzed according to the degree of difficulty and ease in the technique, the choice of applicability and the cost and yield of them. it was emphasized that studying and developing the large sized belt - type press should be the way to make high quality saw diamond and change the state of making middle and low quality diamond in the diamond industry of our country, catching up with the international advanced level as well

    文摘:通過對高溫高壓合成金剛石3種主要裝備在關鍵部件受力狀況與使用壽命、高壓腔體積與壓力利用率、高壓沖程大小與壓力穩定性，高壓腔變形與溫場、壓場的關系等方面的比較，分析了3種主要裝備在技術難易程度、適用性選擇和投入產出比的差異；強調了我國金剛石行業要改變當前只能生產中低檔金剛石的現狀，向生產高品級鋸片級金剛石的方向發展，與國際接軌，應該走大型化兩面頂的道路。
  5. The forced state in key parts and their lifetime, the volume of high pressure chamber and ratio of pressure, the length of high pressure stroke and pressure stability, the relations between the deformation of high pressure chamber and temperature field and pressure field for three kinds of apparatus of making synthetic diamond under high pressure and high temperature were compared in this paper. the differences of these main apparatus were analyzed according to the degree of difficulty and ease in the technique, the choice of applicability and the cost and yield of them. it was emphasized that studying and developing the large sized belt - type press should be the way to make high quality saw diamond and change the state of making middle and low quality diamond in the diamond industry of our country, catching up with the international advanced level as well

    通過對高溫高壓合成金剛石3種主要裝備在關鍵部件受力狀況與使用壽命、高壓腔體積與壓力利用率、高壓沖程大小與壓力穩定性，高壓腔變形與溫場、壓場的關系等方面的比較，分析了3種主要裝備在技術難易程度、適用性選擇和投入產出比的差異；強調了我國金剛石行業要改變當前只能生產中低檔金剛石的現狀，向生產高品級鋸片級金剛石的方向發展，與國際接軌，應該走大型化兩面頂的道路。
  6. High - low temperature chamber

    溫度交變試驗箱
分享友人
分享到 Line

分享到臉書