identified data 中文意思是什麼

identified data 解釋
被標識的數據
  • identified : 經鑒定的
  • data : n 1 資料，材料〈此詞系 datum 的復數。但 datum 罕用，一般即以 data 作為集合詞，在口語中往往用單數...
  1. Hamada and wu ( 1991 ) identified important location effects by imputing the censored data. and bihua has considered identification of both location and dispersion effects from unreplicated factorial experiment with right - censored data

    對于這樣的截尾數據， hamada與wu （ 1991 ）通過對截尾數據補值，給出了模型選擇以及鑒別和估計位置效應的方法。
  2. In order that the recorded block of data be identified, a header and trailer are added.

    為了辨別所記錄的數據塊，還要加上頭標和尾標。
  3. Individual data items or records can be identified by a key or ordinal.

    單個數據項或記錄可用關鍵字和順序號識別出來。
  4. The rule of loads and settlement is concluded from numbers of settlement observation points ’ data. and in actual construction, this rule could be used to prevent immediate settlement under the accelerated load, and also, the serious result of the soil destruction could be avoided. at last, a proper method of settlement computing is derived from the identified rules, which can be used to guide the practical construction work, of course, meeting the compulsory standards of the settlement control well

    採用逆作法施工，現實地解決了樁、土與筏板接觸面的變形協調關系;通過對樁、土受荷過程的實際測試，得出了樁、土分擔荷載比例和變化過程，從而為樁、土的荷載計算提供實際依據;從設置的大量沉降觀測點中所得到的沉降資料，得出荷載、沉降變化規律，從而指導在實際施工中，防止加載過快而導致速沉，避免由此帶來的土體破壞的嚴重後果;通過沉降規律分析，得出了適用於軟土地區的樁基沉降計算方法，用於指導實際施工，以滿足沉降控制的強制性標準。
  5. Transcription of tape - recordings of 17 courtroom trials amounting to more than 900, 000 words was used as data, of which questions and responses were identified and then studied and analyzed within a framework which draws insights from speech act theory, discourse analysis, conversational analysis and corpus linguistics, with focus on qualitative description supported by quantitative analysis

    結論是： （ 1 ）問答是法庭審判的主要進行方式，因此從問答著手研究法庭話語具有重要價值。 （ 2 ）問的最多的是法官，因此，研究中國的法庭審判不能不重視對法官話語的研究。
  6. Since there is few core data and logging data in this area, the lian - 150 well is selected as the standard well that has imaging logging data which is combined with few core data to establish the fracture identified mode with bp neural network and gray system theory. it makes the satisfied effect of the muti - well interpretation and solves the problem of the absence of the exceptional well data and the difficulty of fracture identification

    本論文在該地區巖心資料少，測井資料不全的情況下，選取有成象測井資料的聯150井作為標準井，運用成象測井資料結合少量的巖心資料建立起該地區bp神經網路和灰色系統理論裂縫的識別與評價模型，用於該地區的多井解釋取得了滿意的效果，解決了該地區特殊測井資料缺乏、裂縫測井識別較難的現狀。
  7. During its lifetime, the xd recorded a total of 664 triggers. the research team identified and recorded lightcurves of near one hundred solar flare events data taken during half of the orbit when the shenzhou - ii orbiter faces the sun and 30 candidates of gamma ray bursts. many of these observations were verified by similar results taken by other orbiting satellites

    探測器在運作期間，共錄得664次撞擊，研究小組由此識別並記錄了近百次太陽耀斑的變光曲線當神舟二號在軌道上面向太陽時和約30次伽瑪射線爆發，大部分觀測結果跟其他人造衛星所測得的類似。
  8. Linnan sub - depression which is mesozoic and cenozoic faulted lacustrine basin is located in the southwestern part of huimin sag, depression of jiyang. it is dominated by lacustrine - fill sub - depression. based on well logs, three - dimension seismic profiles, cores and other basic data, 10 horizons including 6 turnaround surfaces and 4 maximum flooding surfaces are defined from es3 to the lower part of es2 formation, and 1 long - term and 5 intermediate - term base - level cycles which are named from c5 to c1 could be identified, and then the chronostratigraphic framework of the sub - depression is built

    本文以巖心、鉆井、測井、地震資料為基礎，在下第三系沙三段沙二下的一個長期基準面旋迴（二級層序）內部識別出10個有時間地層對比意義的界面，包括6個基準面下降到上升的轉換面（層序界面） ， 4個基準面上升到下降的轉換面（湖泛面） ，劃分出c1 - c5五個中期基準面旋迴，建立了等時地層格架地層格架。
  9. That is firstly establishing the body characteristic image and character data - base of every breed at the newly - hatched silkworm stage by anatomical microscope and photography equipment, and then comparing the body characteristic of the silkworm breed to be identified with the corresponding characteristics of every breed having known in the data - base, and making a statistic deduction on the inspectional results in the light of probability distribution theory and sample deduction method

    不同蠶品種具有不同的蠶體顏色、斑紋、斑紋顏色和形狀、體型等形體特徵，這種形體特徵與4 、 5齡大蠶的形體特徵不同，據此發明了一種根據蟻蠶期形體特徵檢驗蠶種雜交率的方法。
  10. Detailed description of the data items of each data entity is provided, and the primaryalternateforeign keys are also identified and documented

    本文件亦會詳盡描述每個數據實體的數據項目，並認定及記錄其主關鍵碼備用鍵碼外鍵碼。
  11. According to the geological data which was gained by exploration investigation, establishing a geological model which can reflect rock mass characteristics ; with analyzing the internal and exterior factors synthetically, the deformation and possible failure mechanism and mode of the cut slopes was confirmed which combines with stereoic projection and other techniques ; the stabilities of the 14 high slopes are estimated synthetically by applicable design codes and guidelines. with the estimate result and some other analysis methods, the rock mass mechanical parameters of slope are identified ; as a results, 14 high slopes fall into 4 categories based on rockmass characteristics and discontinuities. the stability and deformation of some typical slopes was analyzed with distinct element method by udec ; the safety factor of some dangerous slopes are calculated by rigid limiting equilibrium method for comparison

    首先著重研究影響邊坡穩定性的內在因素，主要是通過地質勘探、測量、現場觀測等手段取得研究區地質體的基礎地質資料，建立起能夠反映地質體結構特徵的地質模型;隨后綜合分析潛在的內外部影響因素，並結合赤平投影對邊坡可能的失穩模式或破壞機製作出判斷;運用已有巖體質量分類方法對沿線14個高陡邊坡穩定性進行初步的評價，並結合試驗研究、經驗判斷、工程類比等手段確定了坡體的巖體力學參數;根據穩定性初步評價結果將研究區14個高陡邊坡按開挖方式分為4大類，並利用離散元程序udec對各類典型高陡邊坡進行了穩定性計算分析;對潛在危險邊坡利用剛體極限平衡法求出了不同工況下的安全系數。
  12. This paper combines model identification of batch cooking process with process monitoring. state - space model of batch process are identified directly from process data using subspace identification method, which are developed originally for identifying continuous processes

    將過程的模型辨識和質量監控結合起來，把連續過程建模中提出的子空間辨識方法應用到間歇蒸煮過程。
  13. Then a low pass filter is designed to filter high - frequency noise in data. and smooth data again by means of central interpolation algorithm ; helicopter model with multi input single output are identified respectively in ls method and ml method

    （ 2 ）剔除並補正了飛行實驗數據中的野值；設計了一個低通濾波器來濾除數據中的高頻噪聲；用中心插值演算法對數據二次平滑。
  14. Uploads a data buffer to a resource identified by a uri

    將數據緩沖區上載到由uri標識的資源。
  15. The " collaboration " will become a main problem enterprise faced in the global digital economy. so along with this clue, some problems as following are studied in this paper : 1 ) collaborative manufacturing environment, collaborative manufacturing network and operation center are proposed, and base on these concepts, some problems relate to production control are identified ; 2 ) the framework for collaborative manufacturing environment is constructed by using agent and multi - agent, the framework conducts scheduling and controlling functions among production entities, as well as within them, using autonomous agent and weighted functions for distributed decision - making, while simple index values, instead of detailed data, are used for information exchange among agents ; 3 ) finally, resource promises model are proposed, based on the model, resource control collaborative mechanism is developed for collaborative manufacturing environment ; 4 ) collaborative contingency management is introduced

    本文沿著「協作」這一線索對以下問題進行了研究： 1 ）提出了協作製造環境、協作製造網路及運營中心的概念，並以此為基礎進一步界定了協作製造環境下的生產控制問題； 2 ）構建了協作製造環境下基於多agent的生產控制框架，並在這一框架基礎上，應用自治agent和分散式決策的權重函數，建立了協作製造環境中製造實體間或實體內生產調度與控制模型； 3 ）以資源承諾模型為基礎，建立了協作製造環境下的資源控制協作機制； 4 ）給出了協作製造環境下緊急事件的管理策略。
  16. By using it, the section mapping drawings of multi - types & complex pipeline system can be automatically generated through the entity crossing operation. this method composes of the following three key steps. in the first, different graphic entities are identified from the complex pipelines drawing in terms of the layer information they owned, then the correspondent information is to be encapsulated to keep the spatial data completeness of the graphic symbols

    該方法通過管線系統設計圖中的圖形實體的分層處理與信息封裝，首先實現了復雜管線實體的自動識別並確保了圖形實體具有對應管線實體對象的完備空間信息；在此基礎上，根據用戶給出的任意位置截切線，構造隱式描述的截切面並與隱式描述的管線實體進行求交運算；最後通過對求交結果的坐標變換，生成能夠直觀反映出多類型復雜管線系統空間分佈信息的截切面映射圖。
  17. From the data obtained in this research, four dimensions were identified for delimiting and defining tb of teaching : the teachers " conceptions of students " learning, the content of teaching, evaluation and teachers " conceptions of treating students. if the score is less than 3, he / she is regarded as disagreeing with the related beliefs

    本研究以489名中小學在職教師為對象，採用利克特式六點量表，本研究假設，教師信念與教師的工作投入、反思智力、批判思考傾向、工作滿意度及教師的教學效能感有關。
  18. It was identified to be swainsonine by physicochemical properties and spectral data analyses

    經理化常數測定和波譜分析鑒定為苦馬豆素。
  19. Since the ldm is developed to reflect the structure of the data, not all of the relationships identified may be required for functional purposes

    由於發展邏輯數據模型的目的是反映數據的結構，因此並非所有認定的關系在功能上都是必要的。
  20. 6. 5 earthquake in the west of beijing in 1730 together with the data of drills, electromagnetism and gravity, the qinglongqiao - qiliqu and shahe active faults are identified for the first time. although at present all aspects of the earthquake are not fully known, the authors consider that the two active faults are responsible for the earthquake and the first one plays the leading role

    在前人研究1730年北京西郊6 . 5級地震的基礎上，綜合井孔電磁和重力資料，經分析初步確定了青橋七里渠活動斷層和沙河斷陷南緣活動斷層的存在及其位置規模和基本特徵，認為這兩條活動斷層是此次地震的發震構造，其中青橋七里渠斷層在此次地震中起主導作用。
分享友人
分享到 Line

分享到臉書