in-line alignment 中文意思是什麼
in-line alignment
解釋
共軸線-
However, the moon s path is tilted about 5 to the ecliptic, making the alignment of the sun, the earth and the moon in a straight line a relatively rare case. only when the sun and the moon are close enough to the nodes crossing points of the ecliptic and the moon s paths during full moon, a lunar eclipse can occur
要注意的是，由於太陽和月球在天空的軌道稱為黃道和白道並不在同一個平面上，而是有約5度的交角，所以只有太陽和月球分別位於黃道和白道的兩個交點附近，才有機會連成一條直線，產生月食。 -
Paragraph styles are used to define indentation, line spacing, and text alignment in a paragraph
段落樣式用於定義段落的縮進、行距和文字對齊方式。 -
A common recognized method for the shaft alignment, is to set up a physical model, and appropriately locate each bearing in compliance with the required bearing load, stress and shear force and slop etc, so as to fix the shaft with the curve line as required and obtain a right distribution of bearing load
對于軸系校中計算，國內外比較通用的方法是對軸系相關的要素進行處理，建立物理模型，按照規定的軸承負荷、應力，轉角等限制條件，確定各軸承的合理位置，將軸系安裝成規定的曲線狀態，以達到使各個軸承上的負荷合理分配。 -
At the heart of slcad is a sophisticated three - dimensional engineering model. this model includes the terrain, the structures and all the wires. the model can be viewed in plan profile sheets. the slcad model is much more than just a picture or cad drawing since slcad understands the relationship between these elements. when you drag a structure off the current alignment slcad will update wire positions. the effects of this structure move will be instantly visible in the plan profile sheet view. in slcad you concentrate on designing your line instead of wasting your time drafting
有時控制尺寸會有所調整，有時節點板設計會變化一下。傳統繪圖時，面對修改，面對審圖人員發現的錯誤，繪圖人員往往只能夠手工一筆一劃地修改dwg圖形，工作量非常大。雖然有自動成圖軟體的支持，但是對待修改圖的工作，依賴自動成圖軟體重新從頭再生成一遍圖形既麻煩又可能帶來其它意想不到的問題。 -
Test results show that spur dikes aligned along a single bank in the deep water zone have more effects on the adjustment of the bed topography of the wide - shallow river than in the shallow water zone ; alignment of spur dikes along both banks can effectively adjust the planimetric position of deep - water zone ; and a reasonable widening rate of the regulation line in the estuary can readjust the variation of the average water depth along the river
試驗結果表明，在深水區的單側丁壩群對寬淺河床地形的調整作用大於淺水區；雙側丁壩群的聯合作用能調整深水區的平面位置；合理地選擇治導線的放寬率，能有效地調整深槽平均水深的沿程變化。 -
Abstract : for building a long - span concrete - filled steel - tube ( cfst ) arch bridge with an integrated installation tower, one of the key technologies is to control the arch rib alignment of the bridge. based on the theoretical analysis and the measuring results, the designed arch rib alignment of a being built bridge can be guaranteed quality by adjusting the length of the cables on - line. the engineering application shows, by using the on - line adjusting cable technology, that it is economical and in safety for building a long - span cfst arch bridge
文摘:在大跨度鋼管混凝土拱橋塔架/扣架一體化纜索吊裝施工中，其關鍵技術之一是主拱線形控制.在理論分析和現場測試的基礎上，動態調整扣索長度，可保證鋼管拱肋的設計線形.工程實踐表明：將扣索動態調整技術應用於大跨度鋼管混凝土拱橋的吊裝施工中，可降低工程造價，保證施工質量 -
Severe protests from local residents living along mrt routes during the route alignment coordination caused a two - year delay to the proposed schedule for the hsingchuang line. therefore, to reduce the extent of tunneling is a key consideration in the long - term planning of mrt routes. other downsides to the single tunneling method are that it requires longer construction time, and that two break throughs from the tunnel to the work shaft involve a higher construction risk
另因採用單孔潛盾隧道須鉆掘上、下行隧道，除施工時程較長外，且兩次破鏡將增加施工之風險，故有鑒于潛盾機之技術日新月異，國外已有採用多圓形潛盾工法（ mf工法）之成功案例，此除可減少用地徵收補償之困擾外，且可減少隧道開挖面積進而減少棄土所造成之問題。
分享友人