induction curve 中文意思是什麼
induction curve
解釋
感應測井曲線-
The analysis results show that : the frequency characteristic curve assumes the downtrend, so the electrical energy measurement of the induction meter will produce biggish error when the content of the harmonic is big, no matter taking the whole energy as measurement standard or basic wave energy
研究分析結果表明：感應式電能表的誤差頻率特性曲線呈迅速下降趨勢，因此在電能計量中，不管是以全能量為計量標準還是以基波能量為計量標準，當諧波含量較大時對感應式電能表的電能計量將會產生較大的影響。 -
Compared with the induction meter, the electronic meter ' s measurement error is affected diminutively by the change of the frequency, that is to say, the electronic meter has a wide frequency respond characteristic and its error - frequency characteristic curve is flat. therefore, taking the whole energy as measurement standard, the measurement error of electronic meter is less than that of induction meter very much ; while the measurement error of electronic meter is bigger than that of induction meter when taking the basic energy as measurement standard
和感應式電能表相比，電子式電能表的計量誤差受頻率變化影響較小，具有較寬的頻率響應，誤差頻率特性曲線較為平坦，因此，在諧波存在下以全能量為計量標準時，電子式電能表的計量誤差遠遠小於感應式電能表的電能計量誤差，而以基波能量為計量標準時，電子式電能表的計量誤差比感應式電能表的計量誤差大。 -
Finally, the rules used to design the induction motor and set the inverter v / f curve are summarized to improve the stability of the system movement in the forth part of the dissertation, three measures are brought forward to eliminate the system low frequency oscillation. the first measure adopts pulse based dead time compensation to suppress the oscillation. as second measure, considering the motor and inverter as an integration, the discontinuous space vector modulated strategy named dpwm3 is proposed for the first time to suppress the oscillation
措施一是在總結常用死區補償方法的基礎上，提出脈沖為基礎的死區時間補償法（ pbdtc ）對死沈陽工業大學博士學位論文區進行補償，抑制系統的低頻振蕩;措施二是從逆變器與電機的機電一體化配合更加完善的角度，首次提出採用不連續空間矢量調制策略dpwm抑制系統的低頻振蕩;措施三是通過對系統中電機參數的調節，達到抑制系統低頻振蕩的目的;最後進行了實驗驗證。 -
Based on the torque - speed characteristic curve of induction motors, analyses were done on changes in slip with an variation in frequency when an induction motor drives different kinds of loads, including those with constant torque, constant - maximum torque, variable torque ( except fans and pumps ) and constant power, as well as fans and pumps, the formulas to calculate the slip and the speed under different frequencies and loads were presented
摘要以異步電動機機械特性曲線為基礎，分析了變頻調速異步電動機在拖動恆轉矩負載、恆最大轉矩負載、變轉矩（非風機和泵類）負載、恆功率負載以及風機和泵類負載時，轉差率隨頻率變化的規律。
分享友人