initial angle 中文意思是什麼

initial angle 解釋
起始角
  • initial : adj 最初的,開始的;原始的;初期的,初發的。 the initial boiling point 【化學】初餾點〈第一滴餾物...
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角,隅,角落;棱,嬗角。2 【數學】角,角位,角的度數。3 【機...
  1. Through the special studies on impacts to atomizing and humidifying effect from such factors as the firing pin type, centrifugal structure, higher spraying pressure, less aperture, initial water temperature and original state of the air, some conclusions are obtained, such as : the centrifugal nozzle with firing pin type, high pressure and little aperture has bigger air eddy and atomizing angle. the spaying liquid has high velocity. the droplet is small, and the heat and mass transfer velocity is high

    通過對撞針型結構、離心式結構、較高的噴水壓力、較小的噴嘴孔徑、噴水初溫及待加濕空氣初狀態對霧化加濕效果的作用原理的重點分析,得到:撞針型高壓小孔徑離心式噴嘴具有較大的空氣渦與霧化角,噴出的液體流速高、液滴小、水與空氣傳熱傳質速率高,撞針型結構提高了霧化加濕效率,高壓小孔徑的特點為霧化加濕提供了較大的能量,而噴水初溫的升高會減小水的粘性力和表面張力,從而優化加濕效果。
  2. The present findings of semi - rigid connections, the method for design of beam - to - column connections in the codes from china and other countries, and the character about semi - rigid connections, were briefly introduced in this paper. the simulated method of the m - r relation curve of semi - rigid connections, the computing equations about the initial stiffness and moment capacities of two kinds of top - seat angle connections, with and without double web - angle, were discussed

    本文簡要地介紹了半剛性節點的研究現狀、各國規范樑柱連接的設計計算內容和方法、樑柱連接的類型和半剛性連接的特性,探討了頂、底角鋼、頂、底角鋼帶雙腹板角鋼兩種半剛性連接的m - _ r特徵曲線及其擬合方法,頂底角鋼連接、帶雙腹板頂底角鋼連接初始剛度以及彎矩承載力的計算公式。
  3. The basis of dynamics and simulation includes the iterative flyout angle algorithm to the solutions to lambert problem and battin ' s universal conic section state extrapolate method. then spacecraft ' s orbit roots, maneuver impulse and maneuver time are discussed as the following four part : first of all, the chaser ' s one orbit roots is selected as a variable to simulate its influence to the large scale orbital maneuver. the research reveals fact that the orbit roots both of chaser and target should be close to each other to achieve better maneuver and rendezvous " ability, moreover, the best orbit maneuver and rendezvous occurs when both chaser and target ' s initial phase angle are equal

    為了研究了交會機動中追蹤器和目標器的軌道根數、機動時限和機動能耗等因素對交會機動的影響,模擬和分析分為以下四個部分:首先,研究了追蹤器軌道單個參數為變量情況下兩航天器大范圍交會機動問題,研究表明,追蹤器的變化參量與目標器相應的參量在接近的情況下可以獲得良好的交會機動特性,而對于兩航天器軌道共面的情況下,初始相位角相等時則獲得最佳的機動效果。
  4. In this paper, taking the measured error sound velocity profile as the initial guess value, the sound beam travel times and beam angle recorded by the multi - beam system and the generalized linear inversion method are used to get a sound velocity profile close to the actual sound velocity profile, and the inversed sound velocity profiles have contributed to the reduction of sound velocity profile error

    摘要以測得的誤差聲速剖面作為初始猜測值,利用多波束記錄到的波束傳播時間和波束角等信息,通過廣義線性反演得到一個與實際聲速剖面比較接近的聲速剖面,這有助於減少聲速剖面的誤差。
  5. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電動勢類似正弦的準正弦波反電動勢無刷直流電動機,本文提出一種基於六個離散位置信號的自同步svpwm (電壓空間矢量法)控制方法,用以削弱電磁轉矩脈動,分析了實現這種方法的主要控制環節,包括起動時電壓空間矢量的初始定位,阻抗角與電流超前角的合理選擇以及連續轉子位置的估計等。
  6. The propagation of ultrashort laser pulse in air is analyzed with mechanics analogy by considering kerr effects and free electron defocusing. the equation describing the evolution of the laser spot is derived. it is shown that long distance focusing requires large initial beam and the propagation distance is very sensitive to the initial divergence angle of the laser beam

    考慮多光子電離效應和光學kerr效應,首次利用力學類比的方法研究了超短脈沖激光在電離氣體中的傳輸,詳細分析了傳輸距離與激光初始光斑、初始發散角以及激光功率的關系,提出了實現長距離傳輸的條件。
  7. Many cases of excavation and support of high rock slopes were symtematically analyzed, and some conclusions were drawn. there exists stress concentration in grading angle induced by excavation and obvious change of stress and strain on sloping surface, which reduce as the increase of distance to surface. initial stresses have important influence on excavation and support

    撇面上的應力應變的靴很大,隨著離坡面距離的增加而減小;初始地應力對邊坡的開挖支護產生很大的影響,隨著初始地應力的增加,開挖坡面回彈位移增大。
  8. For many given initial velocity, there is one particular angle of departure for which the horizontal range is a maximum.

    對于任一給定的初速度,有一特殊的發射角,以此角度發射,水平射程最大。
  9. With the increasing initial orientation angle and length - width ratio, the drifting distance, the fluctuation of the orientation angle, lateral drifting velocity and rotation velocity all increase, while the final settling velocity decreases with the increasing length - width ratio

    初始取向角和長寬比增大,則粒子的橫向漂移以及取向角、側向漂移速度和轉動角速度的振蕩幅度都增大;同時隨著長寬比的增大,粒子的沉降速度相應減小。
  10. In accordance with the occurrence behavior of roof strata and the fracture characteristics of key stratum in shallow seam longwall mining, studied post - buckling behavior of roof key stratum in the process of mining by using initial post - buckling theory, which derived a critical load and a breaking span of the main roof during the first weighting, determined the final subsidence and the maximum rotation angle for broken key stratum, and presented an application with the example of daliuta 1203 face

    摘要根據淺埋煤層頂板巖層的賦存特點和長壁開采時關鍵層的變形破斷特徵,應用初始后屈曲理論探討了開采過程中頂板關鍵層的后屈曲性態,得出了老頂初次來壓時頂板的臨界載荷和破斷步距,確定了頂板破斷后的極限下沉量和回轉角,並以神東礦區大柳塔1203工作面為例給出了工程實例。
  11. Firstly, the thesis studies the characteristic and the key of the design of the control system of short circuit test bench. secondly, we discuss the different ways to control the initial fault current angle, and give some different design projects based on pc

    然後對合閘角控制的不同方法進行了研究,並根據合閘角控制的方法不同提出了基於pc機的不同設計方案,並對各種方案進行了詳細說明,特別是windows和dos環境下精確短定時的實現以及在電力系統短路試驗控制系統中的應用。
  12. The small inclusions - in aluminum alloy can be detected according to this rule. 2. the initial phase angle of the highest spectral line mushrooms with the growth of volume percentage of inclusions while forward direction, but it goes down while negative direction. 3

    正向檢測(沿軋制方向)時,最高譜線的初相角隨夾雜物體積百分數的增加而迅速增加;逆向檢測時,最高譜線的初相角隨夾雜物體積百分數的增加而迅速減小; 3
  13. Based on the experiment of full - sized cshb walls under lateral and vertical loads, initial crack - resisting stiffen formula was deduced by considering the influence of concrete beams, concrete core columns, structural columns, vertical pressure and window ( or door ). the results calculated from the formula were fit well with the experimental results. by the analysis of displacement at initial crazing, probability statistical mode and its parameters of relative displacement angle were presented

    在介紹和總結本課題的室內足尺寸單片墻抗側力性能試驗的基礎上,考慮了圈樑、芯柱、構造柱和墻體正壓力、開門窗洞等因素對抗側剛度的影響,提出了綜合各種因素的初裂抗側剛度公式,與試驗結果具有很好的一致性;結合試驗的初裂位移分析,給出了層間相對位移角的概率統計模式及相應的統計參數,提出了小砌塊建築層間位移角的控制標準。
  14. This dissertation makes a systemic analysis on the issue of cross - culture in the process of enterprise internationalization, from the angle of risk management, and establishes an initial analyzing structure of cultural risk. with that the dissertation is developed based on solution to four basic theoretical and practical problems : first, what is the connotation of cultural risk and what are the influences of it on international operation ; second, how to identify the cultural risk ; third, how to evaluate the cultural risk ; fourth, how to control and manage the cultural risk. the dissertation is developed as follows

    本論文從風險管理的視角,對企業國際化經營的跨文化問題進行了系統分析,初步構建了文化風險管理研究的理論框架,在此體系指導下重點對下述四個基本的理論與現實問題進行深入研究:一是企業國際化的文化風險內涵及其對企業國際化的影響是什麼;二是企業國際化的文化風險識別問題;三是如何對企業國際化的文化風險進行評價與測度;四是如何對企業國際化的文化風險進行控制與管理。
  15. The settling behaviors of the rectangular particle were affected significantly by the initial orientation angle and length - width ratio

    粒子的初始取向角和長寬比對其沉降過程有較大影響。
  16. The principal initial hole factors influencing primary section trajectory, such as sidetracking position ( formation factors ), primary deviating angle and primary azimuth of the sidetracking position are analysed by spatial plane - tilted method

    文章運用空間斜平面法分析了對側?水平井起始段有重要影響的主要初始井眼條件,包括側?點(地層因素) 、側?點初始井斜角、側?點初始方位角等對起始段軌跡的影響。
  17. A parameter study on dynamics of the car and biomechanics response of occupant was carried out in terms of initial impact speed and impact angle of the car

    通過改變不同的模擬參數(碰撞條件) ,研究碰撞中汽車的動態響應和乘員的生物力學響應特性。
  18. Three characteristics that discribe a sinusoidal signal are the frequency, amplitude, and initial angle

    表示正弦量的三個要素為頻率、幅值(大小)和初相角。
  19. Based on frequency - spectrum - transformation, this algorithm first changes acceleration spectrum into displacement spectrum, then calculates its amplitude, angular frequency and initial angle related to every displacement spectrum, finally sums up all the displacement components and forms the time course of the measured vibration

    該方法採用頻譜轉換法,首先將加速度譜轉換成位移譜,再計算出位移譜中每個頻率分量對應的幅值、圓頻率和初相角,最後對各位移分量進行疊加得到振動位移的時間歷程。
  20. A mathematics model and its concrete approach are advanced which is an algebraic algorithm to determine the initial angle for resolving ballistic equation set and to determine the ballistic the coefficient and drift accurately and quickly

    提出了用代數的方法決定解彈道方程的初始射角的及快速、準確的決定彈道系數、偏流的具體方法和數學模型。
分享友人