initial viscosity 中文意思是什麼
initial viscosity
解釋
初始粘度-
The optimal preparing conditions were found to be as follows : the initial viscosity of cellulose xanthate ranging from 5, 000 to 8, 000 cst, the mixture of pump oil and chlorobenzene with a 6 : 1 mass ratio as disperse phase, the mass ratio of disperse phase to water phase at 6 : 1, the mixing speed at 350 ~ 400 rpm
詳細研究了一些影響復合微球形成的因素，得到較優的工藝條件為：纖維素黃原酸酯粘膠粘度為5000 8000cst ，分散相為6 : 1 （ w w ）泵油和氯苯混合物，攪拌速度為350 400rpm 。 -
On the basis of the analysis abovementioned, the quantitative relation between the compositional distribution of sediment body and initial experiment parameters including powder characteristics ( density, size and size distribution etc. ) and settling parameters ( density and viscosity of suspension, heights of suspension and liquid, etc. ) have been established corresponding to the physical model selected
在此基礎上，結合選用的顆粒共沉降的物理模型，通過理論推導，建立了粉末特性（粉末的密度、粒度以及粒度分佈等）和沉降參量（懸浮液的密度、粘度和高度以及清液的高度等）同沉積體組分分佈之間的定量關系。 -
The effects of all kinds of factors and additives on the viscosity of the pvc paste and blends were sysmetically examined. viscosities, flame - retardant properties, surface resistances, mechanical performances of all the improved recipes were investigated. the cost of the improved recipes was largely fallen down and the compositive properties were better than those of the initial recipes
對各種因素和添加劑對pvc糊和覆蓋膠粘度的影響，以及所有改進配方的粘度、阻燃性能、表面電阻和力學性能進行了詳細的分析，最終得到了即能夠大幅度降低成本又能夠提高產品綜合性能的配方。 -
According to the structure and some global estimates of the weak entropy solution, we derive the global l1 - error estimate for viscosity methods to this initial - boundary value problem by using the matching traveling wave solutions method
根據弱熵解的結構和一些整體誤差估計，使用匹配行波解方法證明了在l ~ 1 -范數下初邊值問題的粘性逼近方法的整體誤差估計。 -
If the inviscid solution includes the interaction that a central rarefaction wave collides with the boundary and the boundary reflects a new shock wave which is tangent to the boundary, or the inviscid solution includes some shock wave which is tangent to the boundary, then the error of the viscosity solution to the inviscid solution is bounded by o in l1 - norm ; otherwise, as in the initial value problem, the error bound is o
如果無粘解包含中心稀疏波與邊界相撞且邊界反射一個與之相切的新激波這樣的相互作用，或者無粘解包含與邊界相切的激波，那麼在l ~ 1 -范數下粘性解與無粘解間的誤差界是o （ ~ （ 1 / 2 ） + | ln | + ） ；否則，類似於初始值問題，誤差界是o （ | ln | + ） 。 -
The results showed that the 11 measured cooking and eating quality properties and taste value have manium significance genetic difference ; among the cooking and eating quality properties, varietal variation coefficent of gel consistency, peak viscosity, break down, setback is relatively large ; every cooking quality property has a different correlation with eating quality property, initial pasting temperature, finial viscosity, consistency and setback have significant or maximum significant inverse correlation with taste value, while peak viscosity, break down has a postive correlation with taste value, amylose content and protein content are inversely related to taste value, but gel consistency are positively related to taste value another, the correlation among varietal cooking and eating quality properties is significant or maximum significant ; in the analysis of principal components, the cumulative percent of 4 selected principal components reached 90. 58 %, initial pasting temperature of large second principal components is small, but amylose content and protein content is high, finial viscosity, consistency are large
結果表明，所測定的11項蒸煮食味品質特性及味度值在供試品種間均存在著極顯著的遺傳差異；在蒸煮食味品質特性中，膠稠度、最高粘度、下降粘度值、粘滯峰消減值的品種間變異系數較大；糊化開始溫度、最終粘度、回冷粘滯性恢復值、粘滯峰消減值與味度值呈顯著或極顯著的負相關，而最高粘度、下降粘度值與味度值呈極顯著的正相關，直鏈澱粉和蛋白質含量與味度值呈負相關，而膠稠度與味度值呈正相關；在主成分分析中，被入選的4個主成分的貢獻率達90 58 ，其中第二主成分大的品種，糊化開始溫度低，直鏈澱粉和蛋白質含量高，最終粘度和回冷粘滯性恢復值大。 -
Alkaline zinc - manganese battery is widely used all over the world it has good performance of storage ， low cost ， stable discharge and convenience of carrying the sealing of the battery is a crucial factor to the performance of the battery due to the disadvantages of present sealants ， leakage of electrolyte often happens what ’ s more ， the sealing capability affects the performance of the battery the way to raise the sealing capability is to search for a good additive ， which can improve the sealing capability through adding according to chemical principles ， this article picks out ptfe and nylon66 as additive adding ptfe or nylon66 into the pitch can improve the sealing capability of the pitch at the same time ， the temperature ， the time ， the amount of addictive ， the way to drop temperature and the time of churning all should be considered by testing the constitutions ， softening point ， moving degree and length of needle of various pitch samples ， we can compare the properties of different sealants can be studied by using of x - ray, the constitutions of the pitch can be indicated which can help us to explain these changes this article includes ： testing the constitutions ， soften point ， moving viscosity and needle penetration of various pitches ； raising the sealing capability by adding ptfe nylon66 into the pitches ； testing the constitutions ， soften point ， moving viscosity and needle penetration of raised samples ； analyzing and discussing the basic principles of this method it is showed that soften point ， moving viscosity and needle penetration of pitches are increased by adding ptfe nylon66 and the discharge time ， initial voltage ， capacity of battery with pitch raised by nylon66 are good and get to the requirement of gb t7 1 1 2 in a11 the method proposed in this article is available in practical industry use
通過測定改進瀝青的軟化點、運動粘度和針入度等指標參數來比較不同的添加劑及不同的添加條件對瀝青封口性能的影響。本論文的主要研究結果為：系統測試了多種瀝青樣品的組成、軟化點、運動粘度、針入度；對市售瀝青分別添加聚四氟乙烯乳液、有機硅樹脂和尼龍66進行改進，制備了改進產品；對改進瀝青的組成、軟化點、運動粘度、針入度進行了測試和比較；使用改進瀝青組裝成電池並對電池進行恆電流放電測試、短路電流測試和電池漏氣、漏液性能的測試；對瀝青改進的原理進行了分析和討論。實驗結果表明：在瀝青中添加尼龍66和聚四氟乙烯乳液對瀝青的封口性能有明顯的提高；通過對工藝條件的不斷改進，目前的工藝條件已完全可以用於實際生產操作；以添加尼龍66改進的瀝青為封口劑組裝成的電池完全滿足堿錳電池生產的需要，且電池電容量、短路電流等指標均達到gb t7112標準要求；本文提出的改進方案，通過驗證是一種效果好、實用性強的方法。 -
The finite difference method and matlab / simulink are used to simulate the pressure transients accompanying the growing and collapsing of gas bubbles and cavitation in low pressure hydraulic pipelines. a method using selector block in matlab simulink to solve the equations in spatial dimension is developed. the pressure transients under different conditions such as different initial flow rate, different viscosity and different initial gas bubble volume are simulated
採用有限差分及matlab / simulink模擬方法，提出了採用simulink中selector模塊求解空間域上積分的方法，對低壓液壓管路有氣泡和氣穴產生的瞬態壓力脈動過程進行了時間域和空間域上的求解，對不同起始流量、不同液壓油粘度和不同初始氣泡量等條件下的瞬態壓力脈動過程進行了模擬研究。
分享友人