injection of gas 中文意思是什麼

injection of gas 解釋
氣體注射
  • injection : n. 1. 注射。2. 注射劑，注射液，針藥，灌腸（藥）。3. 充滿，注滿。4. 【醫學】充血。5. 【機械工程】噴射。6. 【宇宙空間技術】（衛星等的）入軌，射入軌道，射入軌道的時間[地點]。
  • of : OF ＝Old French 古法語。
  • gas : n （pl gases ）1 氣，氣體，氣態 〈cf fluid; solid〉 2 可燃氣，煤氣，沼氣；【礦物】瓦斯。3 【軍事...
  1. Workplace air - determination of butanone - direct injection gas chromatographic method

    車間空氣中丁酮的直接進樣氣相色譜測定方法
  2. Workplace air - determination of butyl alcohol - direct injection gas chromatographic method

    車間空氣中丁醇的直接進樣氣相色譜測定方法
  3. Workplace air - determination of ethyl ether - direct injection gas chromatographic method

    車間空氣中乙醚的直接進樣氣相色譜測定方法
  4. Experimental studies on s1a - 02 gas turbine with water injection into compressor interstage / inlet as well as that on turbocharger self - loop test rig with inlet water injection are introduced. test results are in good accordance with simulation results, wet compression can lower compression work and increase engine power output so engine performance is enhanced, if engine power output is not changed, efficiencies of compressor and this engine become higher and turbine inlet temperature and fuel consumption become lower and if keeping t4 the same as that before wet compression is used, efficiencies become furthermore higher and engine power output increases greatly

    實驗結果和計算結果同樣表明：濕壓縮減少了壓氣機所消耗的壓縮功，增加了燃氣輪機的輸出功率，提高了燃氣輪機性能，如果保持發動機輸出功率恆定，濕壓縮可以提高壓氣機和整個燃氣輪機機組的效率，與此同時，渦輪進口溫度t _ 3 ~ *和燃油消耗率下降；如果保持渦輪排氣溫度t _ 4 ~ *恆定，壓氣機和燃氣輪機機組效率進一步提高，燃氣輪機輸出功率增加。
  5. Methods : fourteen patients with priapism were evaluated by cavernous blood gas analysis, color duplex ultrasonography, 8 cases of priapism resulted from intracavernosal injection of vasoactive agents, 2 from leukaemia, 1 from perineal trauma and 3 from unknown cause

    方法：回顧性分析陰莖異常勃起患者14例的臨床資料，其中血管活性藥物所致8例，白血病所致2例，會陰外傷所致1例，原因不明3例。
  6. Emission characteristics of direct injection natural gas engine using rapid compression machine

    用快速壓縮裝置研究直噴式天然氣發動機排放特性
  7. Global warming potentials gwps following the instantaneous injection of 1 kg of each greenhouse gas, relative to 1 kg of co

    表二：各種溫室氣體的全球變暖潛能溫室氣體留存期年
  8. Global warming potentials ( gwps ) following the instantaneous injection of 1 kg of each greenhouse gas, relative to 1 kg of co

    表二：各種溫室氣體的『全球變暖潛能』溫室氣體留存期（年）
  9. Cycle analysis of gas turbine with water injection into inter - stage of its compressor

    壓氣機級間噴水燃氣輪機循環分析
  10. Study of numerical simulation for gravity drive of crestal nitrogen injection in gas - cap reservoir

    氣頂油藏頂部注氮氣重力驅數值模擬研究
  11. The timing - and - quantitation precision injection of lpg was realized with high - speed lpg solenoid valve and a set of electronic control system, which was designed by the author and can flexibly control the gas supply system of lpg. based on the analysis of experimental data got by comparing the performances before and after the application of the set of equipment on lr6105q12 diesel engine, the effects of load, speed and replace ratio, etc on the emissions of smoke, hc and co of dual fuel engine were expounded. through optimization, the smoke emission was utmostly reduced and the emissions of hc and co were within the government restriction

    為此，本文通過對各個方案進行詳細比較，選擇了電控多點順序噴射的供氣方案；利用高速lpg噴射閥和自己獨立開發出一套電子控制系統對lpg供氣進行靈活地控制，實現了lpg的定時定量噴射，並把這套裝置應用到中國一拖生產的lr6105q12柴油機上，在對改裝前後的發動機進行大量試驗和分析的基礎上，闡明了負荷、轉速、摻燒比等因素對雙燃料發動機的煙度、 hc 、 co等排放的影響情況，並且通過優化，最大限度地降低了發動機的煙度排放，同時使hc 、 co排放限制在國家標準規定的范圍之內。
  12. Abstract : very excellent results have been achieved in injection of coaluniformlly by means of implementing three technical measures under the current conditions, thus laying a very solid foundation for raising the coal injection ratio, stabilizing the gas flow of bf, and gaining better economical efficiencies

    文摘:介紹了在現有的條件下，通過三種措施的實施，取得了煤粉的均勻噴吹，為進一步提高煤比，穩定高爐煤氣流，並獲得更好的經濟效益打下了基礎。
  13. At the same time, we improved a two - stroke fueled engine 1e40fm into the one also using the direct injection of liquid petrol gas. the electronic control system is developed whose core is m68hc11 single - chip computer which is produced by motorola ltd., and matched by other electronically - controlled circuits

    開發了以motorola公司生產的8位增強單片機m68hc11為核心，配以相應的外部電路構成摩托車發動機單片機控制系統，並以一臺二沖程1e40fm型化油器式汽油機為對象，將其改造為汽油、電控氣體噴射兩用發動機。
  14. Explorative study is made on several concrete problems in buildup of underground gas storage in daqing oil region, including building principle, determination of production - injection ability of gas well, operating mode of gas storage, gas well placement, developing index calculation and gas storage behavior monitoring etc., all these have important referential significance to the buildup of gas storage

    本文對大慶油區地下儲氣庫建庫中幾個具體問題進行了探索性研究，其中包括儲氣庫建庫原則、氣井注采能力的確定、儲氣庫運行方式、氣井部署、開發指標測算以及儲氣庫動態監測等，所涉及的內容對儲氣庫的建設具有重要的參考意義。
  15. The lpg - fueled engine is modified and optimized using electronic controlled fuel injection technology ; the comparison of engine performance with direct injection, intake liquid injection and gas injection has been done. the air fuel ratio, ignition timing and injection timing of the engine has been optimized and calibrated

    本文利用電控噴射技術對lpg發動機進行改造和優化，對比研究缸內直接噴射、進氣道液態噴射和氣態噴射的發動機性能，並對空燃比、點火提前角和噴射時刻等控制參數進行優化和標定。
  16. Fourthly, a new high pressure gas mixing apparatus is established, and experimental procedures for gas mixing and multicomponent gas adsorption test are suggested. tests of multicomponent gas adsorption of ch4 + n2 and ch4 + co2 on different coals are performed, and the predicting model for multicomponent gas adsorption is optimized, which can guide the enhanced cbm recovery process by injection of co2 or n2 gas

    研製出混配氣裝置並建立了多組分吸附實驗方法，進行了不同煤對ch _ 4 + n _ 2和ch _ 4 + co _ 2多組分氣體的吸附實驗，討論了多組分氣體吸附的變化規律並優選出多組分吸附預測模型，為注氣增產工藝提供了理論依據。
  17. Direct injection of solvent - reducible paints into a gas chromatograph for solvent analysis

    直接把溶劑稀釋的塗料注射到氣相色譜儀中進行溶劑分析
  18. The method is reasonable and correctly reflects output and injection of gas - injection - production well ' s perforated intervals, thereby providing first hand dynamic monitoring data for gasfield development

    研究出了一套適合此類井的注產氣剖面解釋方法，正確反映了注產氣井各射孔井段的產出注入狀況，為油田開發提供了第一手動態監測資料。
  19. It performs a large amount of physical simulation experiment using the multi - function displacement equipment which is imported from american temco company and summarizes the effecting rule of the injected alternating slug size on the displacement efficiency during the alternating injection of gas and liquid. it uses orthogonal method to study the set and type of pre - slug and post - slug and their effect on the displacement efficiency of foam flooding and optimizes the main and sub - slug size so as to decrease the cost while keeping a high displacement efficiency

    通過從美國temco公司引進的多功能驅替設備，所做的大量的物理模擬試驗，總結出了氣液交替注入時，注入交替段塞的大小對驅油效率的影響規律，利用正交設計法研究了前後段塞的設置與否及種類對泡沫復合驅驅油效率的影響程度，還對主次段塞的大小進行優化，在保證較高的驅油效率的前提下降低成本。
  20. Influence of gas injection into slab continuous casting mould on molten steel bahaviour

    板坯連鑄結晶器內吹入氣體對鋼液行為的影響
分享友人
分享到 Line

分享到臉書