inner conductor 中文意思是什麼
inner conductor
解釋
內層導管-
We adopt the positive temperature coefficient real core resistance wire as the heating body and xlpe insulator as the inner core to make the heating cable with pvc coating outside or hdpe sheath. metal screen heating cable has earth conductor and aluminum screen layer or copper web screen layer. the product has advanced tie - in technology and it is safe, reliable and convenience for operation. the performance indexes meet iec800 standard. 3. technology indexes
本公司生產的發熱電纜採用正溫度系數實芯電阻線發熱體，內芯採用xlpe絕緣，外包覆pvc或hdpe護套，屏蔽發熱電纜具有接地導線和鋁殼屏蔽層或銅網屏蔽層採用先進的接頭工藝，施工安全可靠方便性能指標符合iec800標準要求。 -
According to the experimental parameters of mpt, the main performance parameters of different propellants have been given by engineering performance computation under designed and working states, which has great importance for the experimental research and the future work. 2. for helium and argon, the factors which influence on mpt ' s vacuum steady work have been discussed such as the material of microwave tie - in, the distance between the probe and inner - conductor, the position of the inner - conductor, the input power of microwave, the mass flowrate of propellant and the vacuum pressure of environment, and the influence has been discussed of the microwave power and the mass flowrate of propellant on the pressure of the resonance cavity, thrust, reflected power and the temperature of the resonance cavity
論文的工作和新見解主要包括： 1在設計狀態和工作狀態下，根據mpt的實驗參數，對mpt使用不同工質時的性能進行了工程估算，這對mpt現階段的實驗研究和今後的研究有重要的指導意義； 2對于he 、 ar推進工質，討論微波的接頭材料、探針與內導體的間隙、內導體的位置、微波的輸入功率、工質的質量流量以及環境真空度對mpt真空啟動和穩定工作的影響，並探討微波的輸入功率、工質的質量流量對諧振腔壓強、推力、反射功率以及諧振腔溫度的影響； 3對于n _ 2 、 h _ 2 、 nh _ 3 、 h _ 2o推進工質，主要討論與he 、 ar工質不同的特性，並從長遠的眼光和工程應用的角度，認為其可行性不容置疑，潛在優勢不可忽略，是未來mpt應用的主流推進工質。 -
Finite difference time - domain method is used to calculate the reflection for these probes and absorbing boundary condition is used to deal with the singularity in the axis of the coaxial - line in the simulation. by comparing the reflection of different probes, the best probe has been selected according to sensitive requirement. the influence of parameters : such as thickness of protective film, length of protruding inner conductor of the coaxial - line probe to the measurement has been studied
通過時域有限差分法進行數值模擬分析，並採用吸收邊界處理同軸線軸心奇異點，計算出各種探頭測量相同溶液的反射系數，根據其測量的靈敏度，選出最優設計；並通過分析所選探頭的各種設計參數，如薄膜厚度、內導體伸出長度等的變化對測量結果的影響，找出該探頭各參數的最佳范圍，使其具有高度靈敏性，以適用於測量化學反應溶液的介電常數。 -
It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load
在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。 -
A coaxial transmission line faimly consisting of circular and n - regular - polygonal inner conductor
邊形內導體同軸傳輸線 -
A coaxial relativistic back - wave oscillator ( rbwo ) with inner sinusoidal corrugated conductor is investigated in this dissertation
本學位論文研究了一種新型的波紋內導體同軸返波管。 -
It is found that there is a competition among the modes such as tm _ ( 01 ), tm _ ( 11 ) and tm _ ( 21 ) because of their similar work frequency in the experiment of rbwo with a coaxial structure, then tm _ ( 01 ) mode couldn ’ t work steadily. after shaping rectangular slot in the inner - conductor, the space between modes is enlarged, tm _ ( 01 ) mode would work steadily
在同軸返波管的實驗中發現:模式tm _ （ 01 ） ， tm _ （ 11 ）以及tm _ （ 21 ）的工作頻率十分接近，存在模式競爭問題，使得tm _ （ 01 ）不能成為穩定的工作模式，但在同軸返波管內導體加矩形開槽后，發現模式之間的間隔增大，從而使tm _ （ 01 ）成為穩定的工作模式。 -
Exact solution to the characteristic impedance of the transmissionline of the square outer conductor - microstrips inner conductor
微帶內導體傳輸線特性阻抗嚴格解 -
The technical requirements and test methods of r. f. coaxial connectors with inner diameter of outer conductor 5. 6mm, 3. 8mm, 2. 8mm
外導體內徑為5 . 6mm 3 . 8mm及2 . 8mm射頻同軸連接器技術要求和試驗方法 -
0. 039in. 50 radio - frequency connectors - part 31 : rf coaxial connectors with inner diameter of outer conductor 1, 0 mm 0, 039 in with screw coupling - characteristic impedance 50 ohms type 1, 0
射頻連接器.第31部分:帶有螺套式聯接器和內徑1 . 0mm -
Coaxial inner conductor
同軸內導體 -
For tmon model in cylindrical resonant cavity, the influence of the position, material and thickness of the clapboard on electromagnetic field and resonant frequency was studied. for tem model in coaxial resonant cavity, the influence of shape and position of inner conductor on electromagnetic field, start - up and steady work was studied
對tm _ （ 011 ）模，分析了隔板對諧振腔內電磁場分佈及諧振頻率的影響；對tem模，分析了內導體形狀、位置對諧振腔內電磁場分佈的影響；以及它們對啟動和穩定工作的影響。
分享友人