input-output transformer 中文意思是什麼

input-output transformer 解釋
輸入
  • input : n. 1. 【電學】【自動化】輸入；輸入端。2. 輸入電路，輸入信號，輸入功率[電壓]。3. 放入物，投入的資金。vt. ,vi. 把（數據等）輸入計算機。
  • output : n. 1. 產量；生產，出產，產品。2. 【醫學】（糞便以外的）排泄物；排泄量。3. 【電學】發電力，輸出功率；供給量。4. 輸出信號。
  • transformer : n. 使變化的人[東西]；【電學】變壓器；變換器；互感器。 polarity of transformer 變壓器繞線方向。
  1. Then novel circuit structure of bi - directional voltage mode ( based on forward converter ) inverters with high frequency link, are proposed, which is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filter ; the circuit topologies family of this bi - directional voltage mode inverters with high frequency link include six circuit topologies, such as push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controlled bi - directional voltage mode inverters with high frequency link is introduced

    本文首先論述了dc / ac逆變技術的應用前景及發展現狀。基於正激forward變換器的雙向電壓源型高頻環節逆變器電路結構，由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成;雙向電壓源高頻環節逆變器電路拓撲族，包括推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式六種電路。
  2. The pwm control of duty cycles acts as an electric transformer which regulates the amplitudes of equivalent input voltage and equivalent output voltage, so that both positive and negative amplitudes of equivalent input voltage are equal to those of equivalent output voltage

    對器件占空比的pwm調節，相當于在電路中加入一個電子變壓器，使得輸入方波電源和輸出方波電源的正負電壓幅值分別匹配。
  3. Aimed at design index of input power 1. 5kw, most output rotate velocity 300rpm, and rating output rotate velocity 150rpm, considering factors of angle and ratio of transmission, on the basis of kinematics simulation, author optimized the kinematics parameters. in this paper, author has made some analysis and study to the primal assembly condition of transformer ' s sequential action in theory, designed structure dimension of the input and output transformer, and verified the corresponding strengthen. further, the structure, which is to key transmission components of velocity control system of the speed regulator, has been designed based on meeting operational sensitivity, precision and self - locking

    本文針對輸入功率為1 . 5kw ，最大輸出轉速，額定輸出轉速的無級變速器的設計要求，並考慮到傳動角及變速比等因素，在運動學模擬的基礎上，對運動學參數進行了優化；本文對變換器連續作用的初始裝配條件進行了理論分析與研究，對輸入、輸出變換器作了結構尺寸的設計，並進行了強度校核計算；本文還對變速器調速系統中主要傳動構件在滿足操作的靈敏度、精度、自鎖性的基礎上進行了結構設計；最後採用workingmodel3d軟體，進行虛擬樣機的計算機輔助模擬設計及運動學和動力學計算。
  4. The circuit structure of this kind of converters is constituted of input cycloconverter, high frequency transformer ( high frequency storage transformer ), output cycloconverter, input and output filter

    這類變換器由輸入周波變換器、高頻變壓器（或高頻儲能式變壓器） 、輸出周波變換器、以及輸入、輸出濾波器構成。
  5. A circuit or device that converts a dc input voitage to a regulated output woltage, the output voltage may be lower, higher or the same as the input voltage, switching - regulator dc - dc circuit most often require an inductor or transformer to achieve t - he regualted output voltage, wwitching fegulator circuits can achieve a higher level of power efficiency whec compared to non - wwitching techniques

    指一電路或儀器可將一直流輸入電壓換成一高速過的輸出電壓，此輸出電壓可為較低，較高或輸入電壓相同，互動式直流對直流調整電路通常需要一電感或變壓器以達到所要的輸出電壓，交換式調整電路和非交換式技術比有較高的功率效率。
  6. As the back - propagation neural network ( bpnn ) is adopted to diagnose the dissolved gases of transformer, convergence rate becomes slow, convergence precision becomes bad and even being out of convergence as more sampled data are trained and more complicated relation between input and output becomes

    根據電力變壓器油中溶解氣體分析（ dga ） ，採用反向傳播神經網路（ bpnn ）對電力變壓器進行故障診斷時，隨著學習樣本數目的增多，輸入輸出關系的復雜化，網路收斂的速度將變得緩慢，收斂精度不理想甚至不收斂。
  7. Map all parts from the input message to the corresponding part of the output message and save the transformer service

    將輸入消息的所有部分都映射到輸出消息的相應部分中，然後保存轉換器服務。
  8. Xmt series intelligence digital indicate controller and have advantanges of small size and high anti - interference. the products are manufactured according to the international standards and use transformer or 85 ? 264vac wide range input switch power. multiple installation dimensions allow for compatibility with most of the automatic industrial controlling / adjusting instruments in the world in respects of performance specificatons, input patterns, output functions and installation dimensions. therefore, the products are digital controllers at internationally advanced level

    Xmt系列智能數字顯示控制器，體積小，抗干擾能力強，產品按國際標準製造，採用變壓器或85 ? 264vac寬范圍輸入的開關電源，並有多種外型尺寸，能與世界大多數工業自動控制/調節儀表在性能指標、輸入方式、輸出功能、安裝尺寸上兼容，是具有國際先進水平的數字控制器。
  9. Furthermore, it was the first time to make a systemic analysis and study to the motion rule and affected factors of this kind of transformer. with the applications of relative polar method and equal view angle method, the transformer that satisfies the requirement of transmission rate and output motion is synthesized. thus, an original non - frictional stepless speed regulator with a 1. 5kw input power, a 1500 rotation speed, a constant150output rotation speed and a maximum 300 output rotation speed was achieved

    在此基礎上利用相對極點法和等視角法按傳動比及輸出運動的要求對轉換器進行了綜合，得出了輸入功率1 . 5kw ，輸入轉速1500 ，額定輸出轉速為150 ，最大輸出轉速300的新型的非摩擦式無級變速器的基本尺寸參數並應用adams軟體對其進行了優化；最後對該非摩擦式無級變速器進行了過約束分析，提出了新型的非摩擦式無級變速器無過約束分析的機構運動副的配置方案。
  10. According to the characteristic of nine - area diagram of substation vol / var coordinated control, this system gives the defination of fuzzy sets and the degree of membership of input / output variables, and designs corresponding control rules. the results of simulation demonstrate the system can satisfy the constrains of the day - adjusting times of the switching of on - load transformer and paralleled compensation capacitors, and ensure voltage quality, reactive power basical balance. considering the var requirement in different load time period and the control demand in load saltation, a improved control scheme is provided. the results of simulation show the improved scheme can meet the demand of vol / var in different load time period, protect the wrong operation when either voltage or reactive power appears saltation, and decrease the times of regulation of the switching of on - load transformer and paralleled compensation capacitors finally, a background software module of substation vol / var coordinated control is designed, based on the supervisory control and data acquisition system of substation

    模擬結果證明該系統能在各種負荷條件下確保電壓合格和無功基本平衡，且能滿足變電站對有載調壓變壓器分接頭日調節次數和並聯補償電容器組的日投切次數的限制。通過考慮不同負荷時段對無功功率的需求和負荷突變情況下的控制要求，對上述模糊控制策略進行了改進，模擬結果證明改進后的控制策略能滿足不同負荷時段對電壓和無功的要求、抑制電壓或無功突變情況下的誤動作，且有效地減少了有載調壓變壓器分接頭和並聯補償電容器組的調節次數。最後基於變電站scada系統設計了一后臺電壓無功綜合控制軟體模塊。
  11. A topology of asymmetrical half bridge soft switching is researched in this thesis, which has inherent zero voltage switching ( zvs ) capability and thus potentially higher efficiency by its resonating of the leakage of power transformer with the parasitic capacitances of the power mosft switches, whereas it does n ' t raise the expense of the converter these studies in the thesis have been done as follows : ( 1 ) the topology of asymmetrical half bridge is introduced, and its principle and the relation of duty cycle and input voltage and output voltage discussed, the method of eliminating the deflection magnetism is also brought forward

    雖然，軟開關技術能夠實現功率變換器的小型化、模塊化等，但是，電路變得更加復雜，使得中小功率的變換器的成本增加，往往不利於商業競爭。本文研究了一種零電壓的不對稱半橋拓撲結構，它可以在不增加電路成本的基礎上，利用電路自身的特點，實現軟開關。本文所做的主要工作如下： （ 1 ）對不對稱半橋主電路工作原理進行分析，給出了占空比與輸出電壓、輸入電壓的關系以及消除變壓器偏磁的方法。
  12. Abstract : the uni - polarity phase - shifted controlled voltage mode ac / ac converters with high frequency ac link based on forward converters are firstly proposed and deeply investigated. this kind of converters is constituted of input cycloconveter, high frequency transformer, output cycloconverter, input and output filters. it includes full bridge - full wave mode and full bridge - full bridge mode topologies, the former is suit for low output voltage field and the later is suit for high output voltage field

    這類變換器由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成，包括全橋全波式、全橋橋式兩種電路，前者適用於低壓輸出變換場合，後者適用於高壓輸出變換場合。
  13. The circuit structure which can transfer one unregulated sinusoidal voltage with high thd into another regulated constant frequency sinusoidal voltage with low thd is constituted of input cycloconverter, high frequency storage transformer, output cycloconverter, input and output filter

    該電路結構由輸入周波變換器、高頻儲能式變壓器、輸出周波變換器以及輸入、輸出濾波器構成能夠將一種不穩定劣質的正弦交流電變換成另一種同頻率穩定的優質正弦交流電壓。
  14. Then novel circuit structure and circuit topologies family of current source ac / ac converters with high frequency ac link, based on flyback converter, are proposed. the circuit structure which can transfer one unregulated sinusoidal voltage with high thd into another regulated constant frequency sinusoidal voltage with low thd, is constituted of input cycloconverter, high frequency storage transformer, output cycloconverter, input and output filter. the circuit topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits

    本文提出了基於反激flyback變換器的電流源高頻交流環節ac ac變換器電路結構及其拓撲族，該電路結構由輸入周波變換器、高頻儲能式變壓器、輸出周波變換器以及輸入、輸出濾波器構成，能夠將一種不穩定劣質的正弦交流電變換成另一種同頻率穩定的優質正弦交流電壓；該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式等四種電路。
分享友人
分享到 Line

分享到臉書