insertion element 中文意思是什麼
insertion element
解釋
插入片段-
Surface transverse wave has the 1. 6 high frequency than rayleigh type surface acoustic wave ( using the same technology the frequency of devices of stw has about 1. 6 high frequency than rayleigh type surface acoustic wave ). the paper introduces the theory, design parament, technology and result expeiment of surface acoustic wave ( includes rayleigh surface acoustic wave and surface transverse wave, simple stw ) with low insertion loss, high q and researches the high frequency, low phase noise oscillator with 1ghz stw resonator as frequency element. and describes measurement method and finally experimantal result of the low phase noise surface acoustic wave oscillator
本文研究了以低損耗、高q值聲表面波（其中包括聲表面瑞利波- - rayleighsurfaceacousticwave ，和聲表面橫波等）諧振器的工作原理、設計參數、製作工藝及其實驗結果，並且研究了以1ghzstw諧振器為頻控元件的高頻率、低相位噪聲聲表面波振蕩器，以及低相位噪聲聲表面波振蕩器的測試方法和最終的測試結果。 -
At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db
本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素（ ql值）超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器，頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器，精心設計電路，優化設計布置印製電路板，用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件，製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。 -
Is specified, the insertion location is after the last element of the list indicated by expression2. if neither
，那麼插入位置就在表達式2所表示的列表的最後一個元素的後面。 -
Is a doubly linked list, so element insertion is fast at the head, tail, and at a known position
是雙向鏈接表，因此頭、尾和表中已知位置（
分享友人