interfacial complex 中文意思是什麼

interfacial complex 解釋
兩相界面絡合物
  • interfacial : adj. 1. 界面的,面際的。2. 界面角的。
  • complex : adj 1 復雜的,錯綜的。2 合成的,綜合的;【化學】絡合的。3 【語法】復合的;含有從屬子句的。n 1 復...
  1. 2. because the fracture mode of 3d braided cmc is the interfacial fracture of mode i and mode ii, energy release rate gc and complex stress intensity factor kc was designated as characterization parameters of fracture toughness in the linear fracture theories. 3

    根據三維編織c sic復合材料斷裂韌性的表徵問題屬于線彈性理論范疇以及材料斷裂模式是界面損傷破壞模式的實驗研究結果,提出了該材料的表徵參量應該使用與界面相關的型和型混合斷裂的能量釋放率g _ c ,或者使用復應力強度因子k _ c 。
  2. These include the single fiber pull out tests, single fiber fragmentation tests, etc. however, experimental work is time consuming and its outcomes are not always repeatable, while analytical solutions are not usually available for solving such complex problems as the characterizations of the interfacial mechanical properties of fiber reinforced composites

    目前在這一領域內常用的研究和分析方法有試驗、解析法以及數值解法。但試驗方法費時費力,結果的可重現性較差,而且對纖維增強復合材料的界面問題幾乎無法得到解析解。
  3. The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp

    結果表明:與純聚丙烯相比,納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度,力學損耗因子則降低,納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯;界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用,與聚丙烯相比,納米復合材料的流動活化能提高約15 % ,結晶峰溫度提高10k左右。
  4. The coupled effect is analyzed for an elliptical inhomogeneity under plane uniform loads and linear temperature change at infinity. the complex potentials are obtained for an elliptical inhomogeneity under plane uniform mechanical loading, uniform temperature change and uniform heat flow directed at any angle. the discussion is also given to the variation of the interfacial stresses with thermal parameters

    分析了無窮遠平面加載和線性溫變的耦合效應,獲得了橢圓夾雜體在無窮遠平面均勻加載和均勻升溫以及任意方向的均勻熱流共同作用下的復勢解答,並討論了界面應力隨各熱載參數的變化規律,發現基體導熱性能越好(與夾雜相比) ,界面應力幅值越大。
分享友人