interfacial film 中文意思是什麼

interfacial film 解釋
表面層
  • interfacial : adj. 1. 界面的，面際的。2. 界面角的。
  • film : n 1 薄層，薄膜；薄霧，輕煙；細絲狀的東西。2 【攝影】感光乳劑，照相軟片，電影膠片；影片。3 〈 pl ...
  1. Within the framework of the tim ( transverse field model ), using the eft ( effective field theory ) and the mft ( mean field theory ), considering the long - range effects and the interfacial effect, we studied the transition properties of the ferroelectric thin film, pyroelectric coefficient and dielectric susceptibility and triple hysteresis loop of the ferroelectric bilayer structure theoretically

    我們應用平均場、有效場等方法，在橫場伊辛模型框架內，考慮贗自旋間長程相互作用和界面效應，對鐵電薄膜、雙層薄膜的相變、熱釋電、介電，以及電滯回線等性質進行了較深入的研究。
  2. The binding principle in pelletizing covers a comprehensive model of interfacial reaction among particles inside green pellets, the formation of binding film during hardening of green pellets by baking to obtain enough strength for a volumetric catalyzed reduction model for cold - bound pellets bearing composite binder and corresponding high temperature reduction system in rotary kiln

    提出了含復合粘結劑的生球強度界面作用力綜合模型，冷固球團礦強度的粘結膜機理，含復合粘結劑的冷固球團礦催化還原體積反應機制及全窯高溫快速還原熱工制度。
  3. In order to investigate the interfacial reaction of high - k thin film on si substrate, the high - k samples were studied by xps as a function of annealing temperature

    為了考察high - k物質與si基底的界面反應，以溫度為函數，對樣品進行xps光電子譜線測定。
  4. It was suggested that the difference in the tribological performance between mos2 nanoparticles and common mos2 particles was attributed to the surface and interfacial size - effect of nanoparticles and the formation of molybdenum trioxide thin film on the rubbed surface

    由於納米二硫化鉬顆粒具有納米粒子的表面與界面效應等特性，表面易於發生摩擦化學反應，生成含有氧化鉬的表面膜而起潤滑作用，因而有著比普通二硫化鉬更優良的摩擦學性能。
  5. Oil film life, rate of oil film thinning, water - oil interfacial properties and their effects on demulsification of model petroleum emulsions ( o / w ) in the presence of demulsifiers are studied

    摘要研究了破乳劑存在下油膜壽命、油膜薄化速率以及油水界面性質與破乳效果的關系。
  6. The effects of demulsifiers on interfacial tensions and membrane strength were studied for the model and effluence systems from the three - compound - combination flooding field. the interfacial tensions owned by the two - compound - combination system decreased but those owned by the three - compound - combination system increased with increasing the demulsifier concentrations. membrane strength decreased with the increase of demulsifier. the demulsification mechanism of demulsifier is suggested that demulsifier partially replaces the stabilizers and greatly decreases the intensity of interfacial film

    針對模擬采出液和三元復合驅礦場采出液，研究了破乳劑對復合體系界面張力和膜強度的影響.破乳劑濃度增加，二元復合體系界面張力降低，而三元復合體系界面張力升高.破乳劑分子部分頂替乳化劑分子並顯著降低了界面膜強度
  7. The influence of interfacial shear on laminar film condensation in a vertical tube

    液界面切應力對冷凝過程的影響
  8. Owing to the interfacial cracking which occurs under higher applied load conditions, the composite with high content of tib _ 2 phase exhibited a transition from mild wear to severe wear over the applied load range from 10 n to 80 n. under moderate applied load, increasing the sliding speed caused a decrease in wear rate and friction coefficient of the in - situ composites because the formation of a protective oxide film occurred on the sliding surface and the hardness of the subsurface layer was maintained due to reinforcement of tib2 nanoparticles in the cu matrix

    隨著載荷的增加， cu -納米tib2原位復合材料的磨損率和摩擦系數增加；由於在較高載荷下發生表面開裂，高含量的tib2相增強原位復合材料發生了由輕度磨損向嚴重磨損形式的轉化。在中等載荷下由於表面保護性氧化膜的形成和基體中納米tib2相的存在使復合材料具有良好的抗軟化能力， cu -納米tib2原位復合材料的磨損率和摩擦系數隨著滑動速度的增加而下降。
  9. The results indicate that the interfacial elasticity decreased with the addition of demulsifiers, resulting a decrease of both the strength and the thickness of the oil film, and hence leading to a shorter film life

    結果表明，破乳劑使油水界面彈性降低，導致油水界面強度減弱，界面膜壽命變短，界面膜厚度變薄。
  10. The fracture energy of cu / - aiodiffusion - welded joints was greatly increased by the introduction of the thin film nb interlayer whereas diffusion welding can be performed at a relatively low temperature ( 900 ). the increase in fracture energy of the joints with nb film interlayer was attributed to the strong abhesion of nb to - aio combined with larger plastic deformation in the metal side during fracture tem observations showed large amounts of dislocations existing at the interfacial regions

    本文主要內容就是概括地介紹了國內外關于擴散連接接頭行為數值模擬的發展現狀；主要包括界面孔洞消失過程、接頭元素擴散與反應層的形成、接頭變形與應力行為的數值模擬，以使人們能夠定性或半定量的分析擴散連接因素對接頭性能的影響。
  11. In order to suppress the formation of silicide interfacial layer, a zro2 thin film was deposited as a barrier layer between hfo2 and si. the samples with barrier layer exhibited better leakage and c - v character than the directly deposited ones

    作為阻擋層抑制hf和a的互擴散反應，減小了界面層厚度，並提高了界面層的氧化效率，與無阻檔層的樣品相比電學性能得到了顯著的提高。
分享友人
分享到 Line

分享到臉書