interfacial test 中文意思是什麼

interfacial test 解釋
界面試驗
  • interfacial : adj. 1. 界面的，面際的。2. 界面角的。
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. It is expectative because of both its eminent performance and simple construction technology, and its economical preponderance. through the test of the six fibers and three gradations, the asphalt mixture of different combination, this paper analyses the fibers influence on the pavement performance, expatiates the strengthening mechanism of the fiber asphalt concrete pavement with theory of composite material and the interfacial chemistry

    本文通過六種纖維和三種礦料級配的瀝青混合料大量室內試驗研究，全面分析了纖維對瀝青混合料路用性能的影響，結合復合材料理論和界面化學知識，較系統的闡述了纖維對瀝青混合料路用性能的改善作用機理。
  2. Standard test method for interfacial tension of oil against water by the ring method

    採用環法測定油水界面張力的標準試驗方法
  3. Standard test methods for surface and interfacial tension of solutions of surface - active agents

    表面活性劑溶液的表面張力與界面張力的標準試驗方法
  4. Test method for interfacial tension of electrical insulating oils of petroleum origin against water by the drop - weight method

    滴重法測定石油制電絕緣油耐水界面張力的試驗方法
  5. The anion surfactant nals was the most efficient in the process and was selected as collector by orthogonal method. the interfacial tension and cmc of nals ( cmc 6. 5 10 - 3m ) in the solution was measured by hanging ring test, the function relationship between interfacial tensions and nals concentration was : = - 0. 9523 in 2c - 24. 534 in c - 81. 411. the relation of interfacial adsorption equilibrium in the solution system was respectively tested and calculated with gibbs equation and dynamic method. the conclusion showed that ( 1 ) the experiment result of dynamic method with was highly in coordination with the value which from theoretical calculation. ( 2 ) the surfactant molecule was in arrangement of monomolecular layer at the gas - liquid interface

    用吊環法測定了十二烷基硫酸鈉水溶液不同濃度與其界面張力的關系，擬合得到的回歸方程為= - 0 . 9523ln ~ 2c - 24 . 534lnc - 81 . 411 ，同時還測得其臨界膠束濃度值（ cmc為6 . 5 10 ~ （ - 3 ） m ） ，運用吉布斯等溫方程和動態法分別計算和測定了該溶液系統的界面吸附平衡關系，結論表明： （ 1 ）動態法測定結果基本吻合吉布斯方程的理論計算； （ 2 ）表面活性劑分子在氣?液兩相界面是以單分子層形式定向有序排列的。
  6. 4. based on the sensitivity analysis by a step - perturbation test for several most important parameters, the effective interfacial area is found the most sensitive parameter, which affects the separation efficiency in structured packing column significantly

    4 .基於階躍攝動測試，對非平衡模型主要參數進行了靈敏度分析，結果表明模型中的有效相接觸面積的靈敏度最大。
  7. Connectors for electronic equipment - tests and measurements - part 14 - 6 : sealing tests - test 14f : interfacial sealing iec 60512 - 14 - 6 : 2006 ; german version en 60512 - 14 - 6 : 2006

    測量和控制數字數據通信工業控制系統用現場總線類型3 ： profibus規范第4部分：數據鏈路層協議規范
  8. Bi - material interfacial fracture theories are researched with a phenomenon that cracks extend along interface. a gradient invading model of interface crack at the crack tip can gain stress fields along interface. so a formula of energy release rate for 3d braided cmc is deduced and the corrected formula of the energy release rate is examined with test results

    研究了裂紋沿界面擴展的雙材料界面斷裂理論，利用傾斜侵入界面的裂紋模型解析了裂紋尖端沿著界面的應力場，推導了表徵三維編織cmc復合材料斷裂韌性的能量釋放率公式g _ c ，並且用試驗結果驗證了能量釋放率公式的正確性。
  9. Based on analysis and comparison of existing test data applied to existing ultimate strength prediction models, interfacial stress at the end of plate is deduced. after formulas for calculating the effective moment of inertia for frp - strengthened beams being revised and adjustment coefficient related to nominal main steel reinforcement ratio and curtailment length ratio being put forward, strength prediction formulas of compound beams under plate end debonding failure are established. in analysis of strength of compound beams under intermediate crack induced interfacial debonding failure mode, several bond strengths and their relation are introduced

    對于板端剝離破壞，在總結現有承載力模型的基礎上，利用已有試驗數據對各承載力計算公式進行了分析比較，進一步採用分階段分析法，推導了板端界面應力的計算公式，在此基礎上，採用加固復合梁有效慣性矩的修正公式，建立了考慮名義配筋率和板端偏移比影響的板端剝離破壞梁承載力的計算公式；對于跨中受彎裂縫導致的粘結破壞，闡述了常見的幾種粘結強度之間的區別和聯系，並基於拉剪粘結強度，提出了跨中受彎裂縫導致粘結破壞的承載力計算公式，並利用現有試驗結果確定了模型中的一些參數；最後，利用試驗數據對本文建立的兩種粘結破壞承載力計算公式進行了檢驗，結果基本吻合。
  10. The main contents of this paper are as follows : 1. the fracture test results of 87 adhesive specimens of new and old concrete are presented. the failure patterns and main influencing factors of the specimens are discussed and analyzed, such as interfacial roughness, types of adhesive agent, size of the aggregate, adhesive ages of new and old concrete

    進行了四組24水平共計87個新老混凝土粘結試件的斷裂試驗，討論了新老混凝土粘結的斷裂機理及影響斷裂性能的主要因素，如老混凝土界面的粗糙度、界面劑類型、混凝土粗骨料最大粒徑、粘結齡期等。
  11. With mortar being separating matrix, from aspects of theories and test - methods of workability - design, separation mechanism of water - reducer for cement paste, relation between properties of interfacial zone and concrete durability etc, this work focused on sample index for durability evaluation, saturation dosage of water - reducer, test for rheological properties of mortar and test on concrete workability etc, achieved following main conclusions. 1

    本研究以砂漿為分散體系，對混凝土的工作性設計從理論到測試方法、從減水劑對水泥漿體的分散機理、從混凝土界面性能與耐久性的關系等不同角度，對砂漿流變性能的測試方法和混凝土工作性的測試、減水劑飽和摻量、耐久性簡要評價指標等方面進行了研究，得到以下主要結論。
  12. The test results showed that two methods effectively improved both macrostructure and microstructure of interfacial layer, and therefore, significantly improved bond performance

    研究結果表明，兩個設想均能有效地改善新老混凝土粘結界面層的宏觀與微細觀結構，使力學性能顯著提高。
  13. Moreover, when the filaments are treated for 12 minutes, the interfacial shear stress will be lower than that treated for 6 minutes. izod pendulum is used to test the influence of the fiber / matrix bond strength on the low velocity impact responses of the composites. the curves of energy - time, force - time and velocity - time are obtained by a data acquisition system

    用擺錘低速沖擊儀對界面粘結強度不同的材料進行沖擊試驗，藉助數據採集系統得到沖擊過程中材料吸收的總能量、承受載荷、擺錘速度等參數與時間的關系曲線，並通過pc機處理，將載荷?時間曲線轉化為載荷?位移曲線。
分享友人
分享到 Line

分享到臉書