jet exit 中文意思是什麼
jet exit
解釋
噴流出口-
At the moment the ejection seat whipped stricklin into that optimum position, it created an exit for him, blowing the canopy off the jet fighter
就在彈射座椅把斯特里克林固定在最佳位置的那一刻，座椅還會同時把駕駛艙頂蓋炸開，從而為他留出逃生出口。 -
According to rigorous procedures, an experimental study was carried out to investigate the effects of jet exit velocity, flow direction, fluid subcooling and nozzle diameter on hysteresis of boiling heat transfer with impinging circular submerged jets of highly - wetting liquids
摘要系統地研究了液體在圓形斷面噴嘴浸沒射流作用下沸騰熱滯后與射流沖擊速度大小、液體流動方向、液體過冷度和噴嘴直徑等因素的影響。 -
Analysis indicates the " low pressure closed reticular flow region " results in the non - equilibrium of pressure along the primary jet ' s orifice. to obtain as large vectoring angle as possible, the optimal ranges of angles, frequencies, velocity amplitudes, and distances from the microjet actuator to the primary jet exit were discussed. the relationship between the vectoring angle of the primary jet and the phase - difference of two adjacent actuators was analyzed
分析了「拉」模型單作動器模式下，微射流作動器的入射角度、驅動頻率、速度幅值及與主射流間的距離對主射流偏轉程度的影響，並確定了作動器工作參數的最佳范圍;分析了「拉」模型雙作動器模式下，不同的相位差對主流偏轉程度的影響。 -
For two up and down plunging jets, an optimization model is introduced according to maximum energy dissipation. in this model, the exit angle of jet is first considered actually. the optimal computation of the energy dissipation between two impinging jets in xiao - wan project demonstrates that this model is reasonable too ; 6
對于上、下雙股挑流水舌，以碰撞消能率為優化目標，首次考慮了出口水舌的坦化影響因素，建立了優化數學模型，並通過對小灣拱壩壩身表、中孔水舌的碰撞計算，認為所提出的數學優化模型是可用的； 6 -
The main work embodied as follows. ( 1 ) model a biowhig / suction type boundary for synthetic jet actuator, it considers the actuator cavity, exit nozzle and exterior flow field as a single computational region
（ 2 ）本文的主要工作之一是基於建立的激勵器簡化模型對合成射流流場進行二維、三維數值分析以探討合成射流流動機理。 -
Development and application of dust collector with impulse jet bag cleaner for kiln exit gas
橡塑用袋式除塵器的清灰及控制 -
Author has investigated the air - volume affect the pressure oscillation in piping system from converse viewpoint. when the structure parameters of the air - volume are some certain value, the pressure oscillation in the exit of the piping system is magnified. this idea makes us a new way to design the power source of high pressure water - jet
研究表明：當設計的空氣室結構參數（空氣室的容積，安裝位置等）取某組數值時，管道出口端的壓力波動幅值遠大於系統輸入壓力波動幅值，從而為設計高壓脈沖水射流的動力源提供了一條新的思路。 -
Furthermore, the horseshoe shape vortex system occurred to the upstream of the jet exit and the layer structure of vortexes occurred to the wake of the reverse flow region downstream of the jet are also investigated
另外，觀測到射流噴口上流的馬蹄渦系以及射流逆流區下游尾跡區旋渦的層狀結構形式。 -
Under different positions of a tripping wire or speeds of the side jet, the controlled experiments were made, including the receptivity of the shear layer near jet exit to acoustic excitations, the spatial development of fluctuating velocity and the profiles of mean velocity
在不同絆線位置或不同旁射流流速條件下，研究了射流出口臨近剪切層對聲激勵的感受性，脈動流速向下游的空間演化及平均流速剖面。 -
The ratio of mach number between lateral jet and free flow induce intensity degree of jet interaction. it has no obvious difference between two interactions with two types of nozzle exit configuration, rectangle and ellipse. the shock in front of jet results in increase of shock resistance and the jet ejection causes increase of base resistance
研究表明，側噴流與來流馬赫數之比是影響繞流場的重要因素，該值越大則側噴干擾越強烈，矩形和橢圓形兩種側噴口形狀對側噴流場干擾波系的影響並不明顯。 -
The piv technique is applied to visually measure the flow field in the vicinity of the exit of slot turbulent jet with limited width discharged into cross - flow from bottom
摘要本文應用piv流動顯示技術詳細測量了有限寬度窄縫射流從底部射入橫流的流場結構。
分享友人