jet velocity distribution 中文意思是什麼

jet velocity distribution 解釋
射流的速度分佈
  • jet : JET ＝Joint European Torus 歐洲聯合核變實驗裝置。n 1 【礦物】煤玉，黑色大理石。2 烏黑發亮的顏色。...
  • velocity : n. 1. 迅速；快速。2. 速度，速率。3. 周轉率。
  • distribution : n 1 分配，分發，配給；分配裝置[系統]；配給品；配給量；【經濟學】配給方法，配給過程；分紅；【法律...
  1. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。
  2. Experimental study on velocity distribution of swirling jet with polyacrylamide fluid

    聚丙烯酰胺漿體旋轉射流速度分佈的實驗研究
  3. At last, three - dimensional mathematical model of gas - particle two phase turbulence was established, and it was adopted to study the gas - particle two phase rectangular jet as well. the distribution of the time - averaged velocity and turbulence intensity was studied, and some of the simulation results were compared with the experimental results ; the coherent structure of flow field was described in the three direction, the evolution and motion of the eddies was discussed too ; the dispersion of fine particles in the three dimensional space was also investigated

    全面地分析了矩形射流氣相時均流場的速度、湍流強度的空間分佈規律，並就部分數值模擬結果與實驗結果進行了對比研究;描述分析了氣相流場湍流擬序結構，對流向、橫向和展向三個方向旋渦的空間結構特點進行分析研究，並分析了流向渦隨時間變化的發展、運動規律。
  4. And then simulations of gas - particle two phase plane wake and gas - particle two phase plane jet were carried out by using this model. after numerical simulations of the two flow fields were finished, series of analytical work was done. first, the distribution of time - averaged velocity, turbulence intensity was analyzed, and some of the simulation results were compared with those of the experiments ; the coherent structure of vortices in the near wall region of the plane wake flow were studied by describing the evolution of the eddy structures, including the forming, developing and shedding from the wall of the vortices in the near wall region ; the coherent structure of vortices in the whole field was also studied, such as the forming, developing, moving, pairing and merging of the eddies etc.

    在對上述兩種流動形態的二維大渦模擬研究中，首先全面地分析了氣相時均流場的速度、湍流強度的分佈規律以及氣相速度的脈動規律等並就部分數值模擬結果與實驗結果進行了對比研究；分析了平面尾跡流場中近壁處旋渦擬序結構，全面和逼真地反映了近壁處旋渦的生成、發展和脫落的規律；描述分析了平面尾跡流和平面射流的全場流動旋渦擬序結構，從整個流場的角度反映旋渦的生成、發展、運動以及旋渦之間相互配對、合併的作用規律等。
  5. Velocity distribution of confined jet flows in a tank reactor

    釜內單相受限射流流動特性
  6. The influences of the inlet tube angle, backpressure and driving jet velocity on static pressure distribution in the gas - solid injector are calculated, and the effects of the inlet tube angle on particle bulk phase concentration and axial mean speed of particles in the gas - solid injector are analyzed firstly. the predicament caused by lack of measuring means on the particle velocity in experiments is solved

    分析了收縮角、背壓和氣體噴嘴出口速度對氣固噴射器內靜壓分佈的影響，以及收縮角對氣固噴射器內固體顆粒體積濃度場和顆粒平均速度的影響，解決了噴射器內固體顆粒速度試驗測試手段缺乏的困境。
  7. A simple model for primary breakup of energetic liquid jets was established using unstable wave theory. based on the jet - embedding method, the jet - core shape, the distribution of jet velocity and the primary distribution of liquid drops were computed

    使用不穩定波理論，建立了射流初始破碎的簡化模型，採用射流嵌入法（ je ）進行了數值計算，得到了hy911射流核形狀、速度分佈以及液滴尺寸的初始分佈。
  8. In this paper, the basic and important parts are studied. for example, the capacity of jet fan in tunnel, the flux distribution and resistance loss in the chimney. this approach is capable of modeling multi - dimensional, time dependent nature of fire in a road tunnel, this paper presents the critical ventilation velocity in various heat release rate and smoke release rate for jingfu highway

    以京福高速公路美菰林隧道的結構參數為依據，當隧道內發生火災時，對隧道煙霧隨時間的發展擴散過程進行了動態的模擬與研究，得出了不同的火災放熱率、發煙率的情況下，控制隧道煙霧迴流的臨界風速這一關鍵數據，為隧道突發火災時的緊急通風控制提供參考。
  9. Analyses theoretically the velocity distribution of the system, presents a layout method of inductive nozzles, expounds the calculation method of the jet parameters and the size of the nozzle, and provides a project example and some design data for reference

    摘要理論分析了地下車庫誘導通風的流場，提出了誘導送風口的布置方法，闡述了誘導射流參數及風口尺寸的計算方法，並給出了計算實例和設計參考數據。
分享友人
分享到 Line

分享到臉書