laminar low 中文意思是什麼
laminar low
解釋
層流-
The main equipment here should be : pipette, refrigerator, balance, low speed centrifuge, vortex mixer, mobile uv lamp, etc. it can use laminar flow cabinet for the reagent preparation
儀器設備主要應有加樣器、冰箱、天平、低速離心機、混勻器、可移動紫外燈等。可使用超凈工作臺作為試劑配製操作臺面。 -
In the thesis the low drag - low noise optimization of the vehicle main form design is realized, main accomplishments are as follows. researched the knowledge of drag and flow noise, the parameters of the boundary layer are calculated by the hess - smith method and boundary layer momentum integral method. the calculation of the length of transition zone and change in boundary layer displacement thickness between laminar and turbulent states in the transition is improved, then the drag coefficient and self - noise from the transition zone are calculated as the objective functions of the optimization
主要研究內容和成果如下：對航行器繞流流場進行分析，深入研究了阻力和流噪聲產生機理，建立了阻力系數和自噪聲的評估數值計算模型；採用物面分佈源匯法和邊界層動量積分法對繞流流場的流體動力參數進行計算，改進了轉捩區長度和邊界層位移厚度的計算，應用於航行器頭部駐點自噪聲的計算；最後設計了阻力系數和自噪聲數值計算程序模塊。 -
Firstly, when the pipe flow was laminar, the movement of fibers was computed in the 2 - d force formulae that were deduced from the slender body theory and in 3 - d integral method. results revealed that angles between fibers " axis and the orientation of flow would concentrate gradually on a low number as the re numbers increased. that is, the axis of fibers would rotate toward the orientation of flow
首先，當管道內流動為層流時，分別利用從細長體理論出發得出的纖維二維受力公式和三維分段積分計算方法模擬了大量纖維在流場中的運動，然後在最終時刻統計了纖維的偏角分佈，並得出相同的結果：隨著re數的增加，纖維粒子的偏角逐漸集中於小角度，即纖維軸線方向越來越集中於流向，此結果與實驗吻合較好。 -
Numerical simulation of laminar separation bubble over 2d airfoil at low reynolds number
翼型低雷諾數層流分離泡數值研究 -
4 were calculated in curved tube with permeable arterial wall and effects of parameters, such as shear stress, mass flux of arterial wall, on mass transfer were studied. it was found that steady laminar flow become unsteady with the increase of de. the concentration in inner section of transverse section of the tube is higher than other areas, and with the increase of de and pe, the concentration there increase obviously. it indicates that for the permeable arterial wall, the macromolecules are likely to gather in the areas where axial velocity and shear stress are relatively low, thus indicates why location of atherosclerosis frequently occurs at inner side of curved tube
4 ，在可滲透邊界條件下彎曲血管內的濃度場分佈，並分析了諸如壁面剪應力及跨壁流量等參數對傳質的影響。計算表明隨著dean數的增加，定常層流開始失穩。血管截面內側區是濃度分佈較高區域，並且隨著dean數和peclet數的增加，內側區濃度明顯增大。
分享友人