latex polymer 中文意思是什麼
latex polymer
解釋
膠乳橡膠-
Studies on the stability of epoxy acrylate latex interpenetrating polymer networks
丙烯酸膠乳型互穿聚合物網路穩定性的研究 -
Synthetic rubber latex - preparation of dry polymer
合成橡膠膠乳.干聚合物的制備 -
Synthetic rubber latex - preparation of dry polymer iso 2028 : 1999
合成膠乳.干聚合物的制備 -
Standard specification for latex and powder polymer modifiers for hydraulic cement concrete and mortar
水硬水泥混凝土和灰漿用乳液和粉末狀聚合物改性劑的標準規范 -
The development in the adhesion between the polymer cords such as rayon, nylon, polyester, and aramid, to rubbers were reviewed from aspects of adhesion test and analysis, fiber and adhesives interface, dipped cord and rubber interface and the mechanical properties of resorcinol formaldehyde latex adhesives
摘要從測試與分析方法、纖維與粘合劑的界面粘合、浸膠簾線與橡膠的粘合、間苯二酚甲醛膠乳浸膠層的物理機械性能等方面總結了人造絲、尼龍、聚酯和芳香聚酰胺等聚合物簾線與橡膠的粘合方法及最新進展。 -
The new methods of toughening epoxy resins, including those of doing thermoplastic resin, thermotropoic liquid crystalline polymer, core - shell latex polymer, forming interpenetrating networks polymer, in - situ polymerization, are introduced, with their mechanisms discussed herein as well
介紹了環氧樹脂增韌改性的一些新方法，包括熱塑性樹脂增韌、互穿網路增韌、熱致性液晶增韌、原位聚合增韌、核殼結構聚合物增韌等，並對其中的增韌機理作了總結分析。 -
The different ratio and dosage of composite surfactants were researched about the polymer latex ' s stabilization and structure. afterwards, the emulsion polymerization of tris, mma, and p ( mma - co - ptris ) were carried out. some different monomer ratio copolymer latex and homopolymer latex are prepared by emulsion polymerization used self - made organosilicone monomer - [ tris ( trimethylsiloxy ) silyl ] propylmethacrylate and mma
用ir ， tem ， dma ，水滴接觸角測試等方法表徵所制備的均聚物和共聚物膜發現：採用有機硅表面活性劑與十二烷基硫酸鈉復配使用，用量在6 8 （相對單體量）可得到粒徑分佈均勻且穩定的均聚和共聚乳液。 -
The infrared spectroscopy, transmission electron microscopy, light scattering and x - ray photoelectron spectroscopy are used to characterize the polymer structure and the morphology of the latex particles. the results demonstrate that composite latex with core / shell morphology is indeed successfully prepared
利用紅外光譜、透射電鏡、激光粒度儀、表面能譜分析等手段對聚合產物的化學結構及乳膠粒粒子形態進行了表徵。 -
Concrete constituent materialspolymer - aggregates, cement, concrete, diagnostic tests, grout, gypsum, mineral filler, mortar, polymer latex, polymer modified mortar, pulverised fuel ash, repaired mortar and water
混凝土組成物料聚脂（砂石、水泥、混凝土、診斷測試、灌漿、石膏、灰漿、聚脂膠漿、修葺用砂漿、聚脂強力砂漿、煤灰、水） -
The organosilicone monomer - [ tris ( trimethylsiloxy ) silyl ] propyl methacrylate was synthesized by trimethylchlorosilane ( tmcs ) and - ( trimethyloxysilyl ) propyl methacrylate ( kh - 570 ), a improved synthetical method of organosilicone monomer tris with higher silicone content than raw monomer - ( trimethyloxysilyl ) propyl methacrylate ( kh - 570 ) was raised, and poly - - [ tris ( trimethylsiloxy ) silyl ] propyl methacrylate latex was prepared by emulsion polymerization, ir was used to study the polymer structure
然後，以此單體為原料用乳液聚合法制備了有機硅均聚物（ ptris ）乳液、有機硅丙烯酸酯共聚（ p （ mma - co - tris ） ）乳液和聚甲基丙烯酸甲酯（ pmma ）乳液。 -
The different ratio and dosage of composite surfactants were researched about the polymer latex ' s stabilization and structure. these copolymers and homo - polymer blend to prepare self - structure gradient film. to prepare the functionally gradient materials ( fgm ) of polysilane - polyacrylate, the method of emulsion mixture was performed
各種均聚物、共聚物膜的水滴接觸角顯示，單體tris的含量越高，膜的水滴接觸角越大，這也表明共聚物的表面能隨tris的含量呈梯度變化。 -
Preparation of acrylate polymer latex with hollow structure
多孔型乳膠粒子制備方法的的研究 -
The paper adopts such materials as common cement materials, mineral modified cement - based materials, polymer modified cement - based materials and epoxy resin and places emphasis on the polymer modified cement - based materials. polymers include np powder, sbr latex, acrylic acid latex, pure acrylic acid latex, chlorobutyl latex and epoxy latex
研究中採用的界面粘結材料有普通水泥基材料、礦物摻合料改性水泥基材料、聚合物改性水泥基材料和環氧樹脂，其中重點研究了聚合物改性水泥基材料，所用聚合物包括np粉末、丁苯乳液、丙烯酸乳液、純丙乳液、氯丁乳液、水乳環氧。
分享友人