leakage flow 中文意思是什麼

leakage flow 解釋
漏泄流
  • leakage : n. 1. 漏,漏出。2. 泄露。3. 漏出物,漏出量。4. 【商業】漏損率;漏損量。
  • flow : vi 1 流,流動。2 (血液等)流通,循環。3 流過;川流不息;(時間)飛逝;(言語等)流暢。4 (衣服、...
  1. Technical features, main requirements and process flow of sleeve valve barrel grouting method are described with the field cases of the method in grouting injection reinforcement, permeability proof and leakage treatment in china

    介紹了袖閥管注漿工法的特點、主要技術要求和施工工藝流程,以及該方法在國內注漿加固、防滲、堵漏施工中的應用實例。
  2. Abstract : technical features, main requirements and process flow of sleeve valve barrel grouting method are described with the field cases of the method in grouting injection reinforcement, permeability proof and leakage treatment in china

    文摘:介紹了袖閥管注漿工法的特點、主要技術要求和施工工藝流程,以及該方法在國內注漿加固、防滲、堵漏施工中的應用實例。
  3. The vortex simulated in this article include the shedding vortex induced by the vane trailing edge boundary layer, the endwall vortex generated by the endwall boundary layer interaction, the passage vortex generated by the rotor rotation, and the leakage vortex generated by the tip clearance flow

    渦輪級內的渦運動包括:導向器葉片尾緣附而層引起的脫落渦;轉子通道內轉子的旋轉運動產生的通道渦;根腳區兩個端壁附面層干涉,形成的根腳渦;存在葉尖漏流時,出現的漏流渦。
  4. Based on an engineering background, through numerical simulation of the flow field in the hp turbine of the energy efficient engine ( e3 ), the article research the unsteady flow in a transonic turbine stage, the unsteady phenomena in the stage include the shockwave, wake, shedding vortex, endwall vortex, passage vortex and leakage vortex, etc. there are two shockwaves generated on the vane the tailing edge, one on suction side is named moving shockwave, and name another on pressure side steady shockwave

    本文首先對于研究的意義和國內外研究的現狀做了簡要的介紹,再從某工程背景出發,通過對e3發動機高壓渦輪內流場的數值模擬,研究了干涉的周期性的問題,以及渦輪級內常見的非定常現象:激波、尾跡、脫落渦、根腳渦、通道渦、漏流渦。導向器尾緣會出現兩道激波,在吸力面的激波可稱為「運動」激波,壓力面的激波可稱為「定常」激波。
  5. Leakage magnetic flow detector

    漏磁探傷儀
  6. The effect of leakage flow due to the upstream hub axial gap on the rotor performance and the mechanism of interaction between the hub leakage flow and the rotor blade passage flow were studied based on the numerical simulations of the flow fields of a transonic compressor rotor with upstream hub leakage

    摘要為研究壓氣機轉子上游葉根軸向間隙泄漏流對轉子性能的影響程度以及泄漏流與轉子流場之間的相互作用機制,對帶有葉根泄漏流的跨聲壓氣機轉子流場進行了數值模擬。
  7. Water shutoff agent dsz - a is composed of inorganic particle. its specialities are low cost, easily flow, high strength and long valid period. the agent suits non - selective water shutoff in sand formation. dsz - a not only can plug high water - bearing formation, but also can plug case leakage. dsz - a has been applied on site and gotten good effect. it is a agent which has wide prospect

    井下護泵除砂裝置主要用於產液氣量高,出砂能力大,利用常規裝置、常規方法很難治理的井.它的設計是建立在丟手封隔器卡封的基礎上,將液體攜砂能力由地層進入泵管轉變為先過濾(雙層激光割縫篩管部分) ,再在除砂器內靜態沉澱、由單流閥排入井底等一系列除砂護泵優點.本文著重介紹了井下護泵除砂裝置的工作原理與應用情況
  8. Ptfe is one of the most corrosion - resistant materials in the world. however it has defects such as the hot expansion and cold contraction rate is10 times larger than that of steel and the original cold fluidity ( creeping ) etc. therefore, as temperature increases, ptfe extends so excessively that it would collapse and then block the flow of media ; as temperature decreases, ptfe contracts so excessively that it would be ripped and then cause leakage

    Ptfe是當今最耐腐蝕的材料之一,可它被製造成襯里的時候,會存在熱脹冷縮比鋼鐵十多倍及固有的冷流性等缺陷,致使ptfe襯里管道、設備,在使用過程中,溫度高時, ptfe襯里層會伸長過多而內癟,阻塞了介質流通;溫度低時, ptfe層會收縮過大被拉裂而泄漏。
  9. In the simulation of close water test, varied profiles of velocity of flow are obtained at different leakage location along the detected pipe, the variety values of the water level in the check well are acquired with time, consequently the location of the leakage can be judged

    在閉水試驗時,通過模擬沿管道長度方向上不同滲水點的流速的變化,以及得出窨井出口處的水位隨時間的變化值,來判斷管段中最有可能出現滲漏點的位置。
  10. A labyrinth seal is a non - contacting circumferential seal utilizing a tortured path for flow between the stationary and rotating ( or reciprocating ) parts. the design utilizes a series of pressure drops to reduce the leakage

    迷宮密封是一種通過曲折通道增大流動阻力來實現封嚴的非接觸密封,通常用於密封氣體,廣泛應用於航空、能源、流體等領域的動力機械中。
  11. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模,並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究,主要針對影響系統特性的主要參數變化,動態分析系統的輸出特性,在上下行工況中,分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響;最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  12. In the three models of calculating the leakage quantity of karst water, on account of the linear and non - linear seepage model are accord with the movement of darcy flow and non - darcy flow coexists with the practical instances in zhong - liang reseviour, so the calculation result of leakage quantity of karst groundwater with this model is more reasonable

    在上述三種計算庫區巖溶水滲漏量的模型中,由於線性?非線性滲流模型同時考慮了與中梁水庫區實際情況相符合的達西流和非達西流區域並存的地下水運動,因此,利用該模型計算出的庫區巖溶水滲漏量更合理。
  13. It is found that the hub leakage flow leads to an increased flow blockage near the hub, resulting in drop of rotor performance

    結果表明:葉根泄漏流可使葉根附近流動堵塞增大,造成轉子氣動性能的惡化。
  14. Additionally, the larger the circumferential velocity component of hub leakage flow, the greater the deleterious effect of hub leakage upon the rotor flow

    另外,葉根泄漏流的周向速度分量越大,泄漏流對轉子流場的不利影響也越大。
  15. The derivation of the leakage flow rate formula of the special annular clearance between the piston and cylinder under condition of variable viscosity in the axial piston pumps was carried out. at same time, considering the questions of the eccentricity and the variable sealing length of piston friction pair, the modified coefficient of the calculation formula of the flow - rate of the leakage was given

    在變粘度、柱塞偏心以及變密封長度條件下,對軸向柱塞泵中柱塞與缸孔之間的特殊圓環縫隙的泄漏流量公式進行推導,得到了該計算公式的修正系數; 6
  16. Meanwhile it retains evenness on lift force to prevent leakage of residue that is caused by installation clearance error or changes in welding criteria, flow off molten iron as well as break - over welding, so that the ideal fosion depth and finishment have been fulfilled

    在需原動力的條件下,該機利用彈性夾角變化,隨著筒體轉動,使墊層焊劑始終緊貼筒體外側環向焊接區,並保持托力均勻防止因裝配間隙誤差或焊接規范變化而引起漏渣,鐵水下淌及焊穿現象,達到理想的熔深度和光潔度。
  17. Inview of the leakage of some mine efflent retention dams in china, the characteristics of the engineering constructions, the causes for the leakage and the leakage flow route are analyzed and engineering control measures are suggested in combination with the engineering practice

    針對我國有關礦山截污庫壩滲漏的情況,分析研究了工程構築物的特點、滲漏原因及滲流途徑,結合工程實際,提出了工程治理對策。
  18. Abstract : inview of the leakage of some mine efflent retention dams in china, the characteristics of the engineering constructions, the causes for the leakage and the leakage flow route are analyzed and engineering control measures are suggested in combination with the engineering practice

    文摘:針對我國有關礦山截污庫壩滲漏的情況,分析研究了工程構築物的特點、滲漏原因及滲流途徑,結合工程實際,提出了工程治理對策。
  19. Based on the comparison made among the characteristics of different kinds of the blade materials, the relationship between the material characters and the flow attack angle is explained, and then the breakage mechanism of the combined effects from both the clearance - cavitations and the erosion of leakage flow are expounded comprehensively

    通過對不同材料的特性比較,解釋了材料特性與沖角之間的關系,綜合闡述了泄漏流動所引起葉片正面頭部空蝕與磨損聯合作用產生破壞的機理。
  20. In the leakage characteristic test, the problem of small leakage flow automatic test is solved with the method of usage of an ellipse gear flow meter and a self - made interface circuit. in the dynamic state characteristic test, frequency sweeping and statistic methods are used and their results are compared with 1250 frequency response analyzer

    在電液伺服閥動態測試實驗中,採用了掃頻法和統計法這兩種不同的方法進行測試,並對實驗結果與1250頻響分析儀所測的結果作了對比,發現二者基本一致。
分享友人