leakage transformer 中文意思是什麼

leakage transformer 解釋
磁漏變壓器
  • leakage : n. 1. 漏，漏出。2. 泄露。3. 漏出物，漏出量。4. 【商業】漏損率；漏損量。
  • transformer : n. 使變化的人[東西]；【電學】變壓器；變換器；互感器。 polarity of transformer 變壓器繞線方向。
  1. Phase - shifted zero - voltage - switching pwm full bridge converter can realize zvs for the power switches with the use of the leakage inductance of the transformer and the intrinsic capacitors of the power switches, so it is used widely for medium and high power applications

    移相控制零電壓開關pwm全橋變換器利用變壓器的漏感和開關管的結電容可以實現開關管的零電壓開關，在中大功率的場合應用廣泛。
  2. Abstract : based on principle of minimal leakage magnetic field energy for current distribution of parallel coils in the primary side of transformer and also on finite element method, the method for calculating the current distribution of parallel coils in the primary side is studied and solved

    文摘:以變壓器一次各並聯線圈的電流分配一定滿足漏磁場能量最小原理為基礎，結合有限元方法研究了計算一次各並聯線圈電流分配的方法。
  3. The auxiliary switch conducts when the two main switch turn off, and it also operates at zcs conditions. this switch not only helps the main switches achieve zvs, furthermore, it eliminates the oscillation between the transformer leakage inductance and the junction capacitance of two switches

    輔助開關管為主開關管實現zvs創造了條件，同時輔助開關管在主開關管關閉期間實現zcs導通，大大減輕了變壓器漏感和主開關管結電容之間的振蕩。
  4. A lcc multi - resonant ( mr ) network is added to the traditional three - level converters to realize zvs. the unique arrangement of a multi - resonant network results in absorption of all major parasitic components hi the resonant circuit, such as transistor output capacitance, diode junction capacitance and transformer leakage inductance, which can eliminate parasitic oscillation in the converter

    它的優點在於諧振電容吸收了開關管和續流二極體的結電容，諧振電感吸收了變壓器的漏感，使得開關管和續流二極體都能在軟開關的條件下完成導通和關斷過程，消除了電路中的寄生振蕩。
  5. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  6. Msl power source produced by us, is able to control two high voltage transformer in a order, and can stop power supply when meet trouble at starting or meet abnormal extinguishment. thus, microwave leakage can be controled

    我們做的微波硫燈電源能夠控制兩臺高壓變壓器先後啟動，能夠在微波硫燈啟動異常和突然熄滅的時候自動斷電，從而有效地控制了微波泄漏。
  7. In chapter 4, considering the features of high voltage transformer and the difficulties to make it, a reasonable design scheme with src was proposed, which efficiently reduced negative influence of distributing parameters of transformer on switching power supply and could completely utilize leakage inductance as resonant inductance

    第四章中分析了高頻高壓變壓器的特點及難點，提出了合理的串聯諧振變換器的設計方案，能夠完全利用變壓器的漏感作為諧振電感，有效地降低了分佈參數給高壓大功率開關電源所帶來的不利影響。
  8. A novel cycloconverter - rype three - phase hf link inverter topology for soft - switching based on phase - shifted full - bridge mode is proposed, whose main advantages are as follows : under the conditions of d < i < and overlap - d, the switches of the leading leg are turned on at zvs and the switches of the lagging leg are turned off at zcs and all switches of the cycloconverter circuit are commutated in the overlapping mode in the interval of zero voltage, which makes the circuit realize soft switching to the utmost extent and reliably solve the problem of peak voltage caused by the storing energy of leakage inductance of hf transformer

    論文提出一種新型移相全橋軟開關周波變流型三相高頻鏈逆變器，電路的主要優點是：前級移相全橋的移相角控制在_ d _ i和_ （ overlap ） - _ d條件下，超前橋臂零電壓開通，滯后橋臂零電流關斷，並使周波變流器所有開關在零電壓期間重疊換相，使整機開關最大程度地實現了軟開關，並可靠解決了高頻變壓器漏感儲能引起的電壓尖峰問題。
  9. After the installation of the transformer, the sealing points will be guaranteed without leakage and the correct readings of every instruments until the handover is up to the grade

    6變壓器安裝完畢后，保證各密封點焊縫無滲漏，各表計準確無誤，各項交接試驗合格。
  10. Traditionally, the resolving - transformer consists of former windings and vice windings. but the resulting output voltage will have aberrance owing to the existence of winding resistors and reactance leakage

    傳統上的旋轉變壓器常採用原副線圈來組成，由於線圈電阻和漏抗的存在，將使最終輸出電勢出現畸變。
  11. Study on simulation of the core magnetic field and leakage field in power transformer based on ansys

    的電力變壓器鐵芯磁場與漏磁場分佈的模擬研究
  12. Some important practice formulae and conclusions are made only because the distribution of leakage flux of transformer is complicated

    由於變壓器漏磁場分佈相當復雜，本文結合理論分析，重點給出用於工程設計中便於實用的公式和結論。
  13. The engineering research and test result for stray losses and temperature rise on metal parts caused by leakage flux of transformer is very useful for transformer design and improving reliability of transformer operation

    本文關于變壓器漏磁場及其金屬件溫升的工程研究和試驗結果對于工程設計以及提高變壓器運行可靠性具有十分重要的指導意義。
  14. The analysis of ppf ’ s operation principle is introduced in detail in this paper. further more, the effect on the circuit operation is also analysed, which caused by clamping capacitance and different transformer leakage inductance value

    本文首先深入研究了推挽正激變換器的工作原理，分析了穩態條件下的工作模態，同時分析了箝位電容與變壓器原邊漏感的大小對于工作模態的影響。
  15. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  16. Current sensors play a very important part in the on - line insulation monitoring of electric power transmission. generally they are used to measure leakage current of ground wire. at present, use current transformer as insulation monitoring current sensor mostly

    電流傳感器在電氣設備絕緣在線監測系統中佔有重要的位置，它一般通過檢測設備接地線電流來監測泄漏電流，目前多採用電流互感器作為絕緣監測用電流傳感器。
  17. How to research stray losses and temperature rise on metal parts caused by leakage flux is difficult task for transformer design

    如何研究由於漏磁引起的附加損耗以及在金屬構件中的溫升是變壓器設計的難題。
  18. ( 2 ) each state of the total switching period has been studied in detail, in which the voltage of block capacitor and current of leakage inductance of main transformer and keeping time of each state have been discussed, then the condition of zero voltage switching is attained, which gives theory guidance for setting reasonable dead time, finally, the possibility of zero voltage switching is proved by simulation of saber software

    （ 2 ）對不對稱半橋在一個完整的開關周期內各個狀態分析，描述了隔直電容電壓和變壓器漏感電流的變化規律，各個狀態的持，然後得出實現zvs的條件，從而為設置合理的死區時間提供了理論指導，最後用saber軟體進行了模擬，驗證了零電壓開關實現的可能性。
  19. The effect of the primary and secondary winding widths on the power loss and energy storage are analyzed for the pcb winding pattern by using 2d - fem, it is demonstrated that when the primary and secondary have the same winding width, the transformer has the lowest ac - resistance and leakage, this suggests ways the designer can modify the winding arrangement to minimize the loss of transformer

    利用ansoft電磁場模擬軟體和本人開發的一維平面變壓器的繞組損耗計算程序對pcb繞組的並聯繞組的設計問題和pcb板繞組原副邊寬度相等問題進行了研究，提出了減少pcb板繞組的高頻損耗的設計方法。
  20. 1 ) the transformer leakage inductance will cause surge voltage across the switches. two clamp circuits are combined to solve this problem : lcd clamp circuit, in which the voltage across clamp capacitor is no reverse ; flyback clamp circuit, which consists of an additional flyback winding coupled with the boost inductor and a diode connected to the output terminal

    本文綜合了兩種箝位電路: 1 ） lcd箝位電路，箝位電容上電壓不反向; 2 ）通過增加一個與升壓電感耦合的反激線圈和一個連接到輸出電容的整流二極體，構成反激箝位電路。
分享友人
分享到 Line

分享到臉書