length and height 中文意思是什麼

length and height 解釋
長度和高度
  • length : n. 1. 長，長度，長短。2. （時間的）長短，期間。3. （賽艇的）一艇的長度；一馬的長度。4. 程度，范圍。5. 【板球】球程；投至適當距離的球。6. 【語言學】音長。7. 一段，一節。
  • and : n. 1. 附加條件。2. 〈常 pl. 〉附加細節。
  • height : n 1 高，高度；身高；海拔。2 〈常 pl 〉高地，山丘。3 高貴，卓越。4 絕頂，頂點；【聖經】天。5 〈罕...
  1. Measure the length, width and height of the cuboid

    量出指定的長方體的長、寬、高。
  2. The design point of the designed forebody / inlet is flight mach number m = 6 and flight attitude h = 25km. the three - ramp, mixed external and internal compression hypersonic / inlet is chosen as representative geometry to be designed. nine types of hypersonic / inlet model with difference forebody length and total turning angle are obtained that the incidence angle of the first ramp and height of isolator are given

    根據飛行任務要求，以飛行馬赫數6 ，飛行高度25km為設計點，給定前體預壓縮角、隔離段高度，對具有不同前體長度和不同總壓縮轉角的帶隔離段的前體進氣道進行了設計。
  3. The effect of groyne length and layout on water surface is analyzed in the paper. based on the results of simulation and experiment, the local energy loss of the flow due to the groyne is studied. consequently the surface variation and height of damming are also analyzed

    論文分析了丁壩長度與布置對水面線的影響，根據流場、紊動場模擬結果和實驗結果研abstract究丁壩造成的水流局部能量損失，並對水面變化和丁壩奎水高度進行了分析。
  4. Three factors, length, breadth and height of the habitable room

    三個因素，長度，寬度及高度的可居住空間
  5. Dim - ensioning system measures length, width, height and volume of parcels, even ir regular shaped parcels, as they travel on a conveyor belt at speeds up to 3 meters per second 600 feet per minute

    Metrologic公司的penta系列產品具有holotrak激光條形碼掃描儀的掃描和分揀功能，適用於當今最快最寬的傳送帶系統。由於其景深最長，因而可以掃描各種體積大小的包裹。
  6. Therefore we should choose length, width, height and interval of frames according to water height and demand of velocity. the results can be used for reference to the design of bank protection works

    隨著l h 、 b h 、 a h的增加，框架群后對應點垂線平均流速的減速率也逐漸增加，保護區長度、寬度也不斷增加，因此，應根據不同的水深和減速率要求拋投相應長度、寬度、高度、間距的框架群。
  7. Statistics of wave crests with different directional spreading parameters and different directional functions are obtained and discussed. jonswap spectrum and the directional function suggested by mitsuyasu, donelan and wen respectively are employed in the analyses. statistical distribution of wave crest characteristics such as crest length, crest height, and directional angles based on the above - mensioned numerical simulation of 3 - d random waves are analyzed

    以jonswap譜為頻譜，選取光易型方向函數（含三個參數） 、 donelan方向函數以及文氏方向函數等不同的方向函數進行模擬，對得到的波峰形式進行比較，分析了方向函數對波峰長度統計值的影響。
  8. The local geometric details considered include longitudinal length and height of access hole in beam web ; material nonlinearity and geometric nonlinearity are included in nonlinear analyses

    節點局部構造的變化主要考慮梁腹板上的焊接孔的長度和高度的改變，非線性分析包括了對材料非線性和幾何非線性的考慮。
  9. Textiles. tests of fibres. method for determining beard length and wool fibre height on reed apparatus

    紡織品.纖維試驗.在鋼筘裝置上對針溝長度和羊毛纖維高度的測定方法
  10. 1st, no matter your stature height, the choice and the knee chinese dress must be much lither than the length and the instep, also gives the attractive shoe more displays leeway

    不管你的個子高矮，選擇及膝的旗袍比長及腳面的要輕盈得多，也給漂亮的鞋子更多發揮餘地。
  11. A drawing to show length, width, height, and wheel span of the vehicle

    顯示車輛長度闊度高度及輪距的圖則
  12. When alfalfa were treated with aqueous extract from p. multisectum, the respiratory rate, activities of amylase and proteinase during seed germination and germination rate, root length, shoot height and fresh weight of seedlings were inhibited and this inhibition become stronger as the concentration of aqueous extract increased

    經水浸液處理后的紫花苜蓿萌發種子呼吸速率、澱粉酶和蛋白酶活性受抑，種子萌發率及幼苗根長、苗高和鮮重下降，並隨處理濃度提高而降低。
  13. The results revealed that the fresh legume total yield was con elated very significantly with the height of plants the number of node, the number of divarication, the length and the weight of per legume and the yield of per plant

    結果表明：鮮豆莢總產量與主蔓長、主蔓節位數、單株分枝數、豆莢長、單莢重、單株鮮豆莢重有極顯著的相關性；四棱豆塊根的總產量與單株塊根數、單株塊根重有顯著的相關性。
  14. Study of the mathematical model of the relation between one ' s foot - length and height

    足長與身高關系的數學模型研究
  15. With the increase of span - length and height, the wind effects on these more flexible structures have not been confined to static wind loading, and the dynamic wind effects due to various wind - induced vibrations must be considered

    隨著結構跨度和高度的增大，風對這些柔性結構的作用就不限於靜力風荷載，而必須考慮各種風致振動問題，以及由此引起的動力風效應。
  16. Desks, chairs, lockers ( 40. 5 cm in length and width, and 155 cm in height in principle ), lockable file cabinet for storage of documents, air conditioner and direct - dialing telephones shall be furnished in the office

    辦公室應備桌椅、衣櫃（其尺寸以長、寬、高各為四、四五及一五五公分為原則）及能加鎖存放報表、文件之檔案櫃、空調設施及直撥電話。
  17. The main content includes : in assembling analysis, three - line - one - row matrixes are obtained by getting the length, width and height of packing cases. any given packing cases are assembled by using pedigree assembling analysis, thus, we can obtain the number of the sorts and the length, width and height of each sort ; in loading a container, the input is any four kinds of them that are just sorted. the chanced packing cases are loaded by using tier up tier principle, side method and recursive method so that we can obtain higher space occupation ; in diagrammatic representation, the result of loading a container is shown in the screen by using simple one - dimension and tow - dimension diagrams

    本文圍繞這一主題進行了深入的理論和實踐研究，具體內容有：在聚類分析中，利用譜系聚類分析原理，提取包裝箱的長寬高作為三行一列矩陣，對給定的任意尺寸的包裝箱進行聚類分析，聚類后，得到聚類的個數和各類的長寬高；在方案生成中，選取了聚類后其中的任意四種作為方案生成的輸入，利用層疊原理，邊際方法，遞歸原理對選取的包裝箱進行裝箱，以達到佔有率較高的目的；在圖形顯示里，對方案生成結果作了一個簡單的一維和二維的示意圖。
  18. Gets the length and height, in pixels, that is specified as the default minimum size of a control

    獲取以像素為單位的長度和高度，此長度和高度被指定為控制項的默認最小大小。
  19. Gets the length and height, in pixels, that is specified as the default maximum size of a control

    獲取以像素為單位的長度和高度，此長度和高度被指定為控制項的默認最大大小。
  20. The productions include : 1. the investigation of crackss of masonry structures, the characteristic and the reason on cracks of wall ; 2. the limited element analysis about datum of brick - wall the relation between the maximal stress in wall and the relative sedimentation of foundations, the relation between the cracks form in wall and inner stress, the validity of limited element mode ; 3. the limited element analysis about the relative sedimentation of foundations, the influence of ratio of length and height, foundations rigidity, groundsill rigidity on the inner stress in wall ; 4. the limited element analysis about the influence of temperature on wall cracks and the influence of space between extension cracks, difference in temperature on the inner stress in wall ; 5. the analysis about the cracks rule because of temperature, the contrast between the result and the simulant result ; 6. the study about the influence of cracks of masonry structures because of constriction stress, the experience of dealing with constriction cracks in the domestic and the foreign ; 7. the advice of avoiding cracks because of the asymmetric sedimentation temperature, constringency in design and construction

    本研究結合實際工程中的砌塊建築普遍存在的裂縫問題，參照磚墻裂縫調查研究的成果，針對我省的砌塊應用狀況，進行了充分的調研，並查閱大量的文獻資料，總結了砌塊建築墻體裂縫的特點和規律，通過對溫度裂縫、沉降裂縫的有限元分析和經驗公式的對比，深入的探討了墻體開裂的影響因素，結合各地實際工程經驗，在對混凝土砌塊墻體在材料、設計、施工等方面進行系統的理論分析、綜合研究的基礎上，給出開裂的防治方法，促進混凝土砌塊在我省的推廣應用，為相關規范的編制提供理論依據和經驗分析，主要研究成果有： 1砌塊砌體開裂的調查研究，墻體開裂的特點和原因總結； 2有限元分析磚墻實測數據，揭示了墻體內最大主應力和地基相對沉降量的關系及墻體開裂形態與內部應力的聯系，並且驗證了有限元模型的有效性； 3
分享友人
分享到 Line

分享到臉書