liquid-vapor flow 中文意思是什麼
liquid-vapor flow
解釋
液體-蒸氣流-
The results indicate that the position of sensitive plates is located at the section of middle or upper in tower but not near by feeding plate, and the smaller reflux ratio, the closer overhead of distillation tower. accurate calculation for flash is solved using matlab, and the result is correct and reasonable. complicated multi - components distillation and crude distillation are simulated using chemcad, and results are reasonable about profiles of flow for vapor and liquid as well as temperature in the tower
數值分析的結果表明精餾塔靈敏板位置並不在進料板附近，而是位於精餾段的中上部，且迴流比愈小，愈靠近塔頂;利用matlab實現了蒸餾過程的嚴格計算，與參考值比較，結果正確、合理;藉助于chemcad進行常減壓塔的穩態模擬計算，得出了流量和溫度在塔內的分佈，經過理論分析，結果合理，可為實際生產提供參考。 -
In the present experimental work i tried to learn some about the absorption phenomenon by allowing superheated ammonia vapor, which is existed in a cylinder, to flow into a test cell to be absorbed into ammonia liquid mixture with certain initial ammonia mass fraction
在本實驗研究中，首先在氨蒸汽罐中制備好過熱氨蒸汽，然後將過熱氨蒸汽注入到實驗件主體，在其中氨蒸汽被一定初始質量濃度的氨水混合液吸收。對該吸收現象現象進行了研究。 -
For improving the flow manner on the plate, the downcomer apron was modified from straight shape to trapezoidal shape. the hydrodynamics performance of the modified ctst tray, for example, the pressure - drop of dry tray and wet tray, liquid weeping and vapor entrainment etc were measured
對優化后的塔板流體力學性能進行了測試，分別測量了不同氣液流量下的干板及濕板壓降、霧沫夾帶量和漏液量等數據，並與改造前的塔板流體力學性能進行了對比。 -
To solve the mathematic equations, the method based on condensation degree was used. the distributions of temperature, concentration and mass flux on the film surface ; of temperature and concentration in the vapor ; of heat transfer coefficient in the vapor and in the liquid were obtained by applying the model in the flow field
採用冷凝度的方法對該數學模型進行求解，得出了汽相的濃度分佈和溫度分佈，界面處濃度分佈、溫度分佈和傳質速率分佈，以及汽相和液相的傳熱系數分佈。 -
The relationship of the heat transfer coefficient with tea liquid concentration, heat transfer different temperature, vapor temperature, liquid flow rate, particle volume percent and different particle were studied. and analyzed the effect of liquid flow rate, particle volume percent on pressure drop. based on the character of inert particle fluidized bed evaporator, used the theorem, a mathematical model of inert particle fluidized bed evaporator heat transfer was proposed
設計和建立了惰性粒子流化床蒸發實驗裝置，進行了傳熱性能和流體力學的理論分析和實驗研究；研究了物料濃度c _ e 、傳熱溫差t 、蒸發溫度t _ v 、液體流量i 、惰性粒子體積分率_ s等操作參數對流化床蒸發器傳熱性能的影響，文中還分析了液體流量i 、惰性粒子體積分率_ s等參數對床層壓力降的影響。 -
Experimental results show that : under the same conditions, the heat transfer coefficient of inert particle fluidized bed evaporator is about 1. 7 times that of the vapor - liquid flow heat transfer. the evaporator has the abilities of preventing and cleaning fouling. at the same time, it can reduce wall temperature
實驗研究結果表明，在相同操作條件下，惰性粒子流化床蒸發器傳熱管壁溫明顯低於兩相流蒸發器，其傳熱系數為兩相流蒸發器的傳熱系數的1 . 7倍左右，操作過程中惰性粒子具有良好的防、除垢效果。 -
For the liquid phase method, it is discovered that the optimal encapsulation is obtained at stalling ph equal 8. 5 by the analysis of the influence of ph on the compactness. for the atmospheric chemical vapor deposition, the optimal experimental condition of coating is determined by the analysis of the influence of different reaction temperature and different flow rate of o2 and different reaction time on the compactness of the coating and the luminescent performance of the phosphor in the experimental scope
對于液相包膜，通過分析陳化ph值對膜層緻密性能的影響，發現在ph值為8 . 5陳化能夠得到最佳的包覆；對于化學氣相沉積法，通過分析不同溫度、不同氧流速、不同時間對包覆膜層緻密性能和zns ： cu材料的發光性能的影響，找到了該實驗范圍內包覆的最佳條件。 -
The liquid - vapor two - phase flow pattern was visualized, along with simultaneous measurement of pressure and temperature
在對汽液兩相流流型進行光學可視化測量的同時，對壓力、溫度等信號進行了同步動態測量。
分享友人