loop control 中文意思是什麼

loop control 解釋
環路控制
  • loop : n 1 （用線、帶等打成的）圈，環，匝，框，環孔，線圈；【醫學】（常 the loop）宮內避孕環。2 環狀物，...
  • control : n 1 支配，管理，管制，統制，控制；監督。2 抑制（力）；壓制，節制，拘束；【農業】防治。3 檢查；核...
  1. Block diagram of voltage - type closed - loop control

    電?形閉
  2. Closed loop control of position for the underactuated robot

    具有非驅動關節機器人的位置閉環控制
  3. Closed loop control system for gas assisted injection molding equipment

    氣輔注塑裝置閉環控制系統
  4. Drift angle position closed loop control system is achieved with 80c31 as controller, step motor as transact organ and absoluteness coder as measure organ. a large number of dada are obtained in all kinds space circumstance experiments

    設計和實現了以80c31作為偏流角控制器，以步進電機為執行元件，以絕對式編碼器作為偏流角測量元件的偏流角位置閉環控制系統。
  5. Appling closed loop control strategy in the power factor dynamic compensation system. then the key techniques, for example, the fashion of real time sampling idle current and the fashion of compensation capacitor connected with, the time when the compensation capacitor are thrown up, are researched

    針對本系統的應用對象，確定了本系統中所應用的無功電流實時檢測理論和方式、補償電容器接線和分組方式、補償電容器投入時刻的選擇等關鍵技術；並對can技術應用於功率因素動態補償系統進行了研究。
  6. This low time constant is consistent with the stability requirements of close-loop control systems.

    這低時間常數是符合閉迴路控制系統中穩定性的要求的。
  7. The main results and conclusions of this study are as follows : 1. the cn2006 bioartificial liver supporting device realized computer - based closed - loop control

    主要研究結果及結論如下: 1 . cn2006型生物人工肝支持裝置的主要操作，均在計算機平臺上實現閉環控制。
  8. For the purpose of boosting voltage, because of the effect of the load r on q, the proposed close - loop control method is the best choice to ensure the stable output voltage

    當利用諧振網路提升整機輸出電壓時，由於負載r對q值的影響，因此必須採用所提出的閉環控制方法才能保證良好的穩壓功能。
  9. Based on the study of transferring characteristics of the lcc - type resonant voltage, the parameter combinations, which make widths and magnitudes of voltage pulses of resonant network adjustable, arededucedo when the following requirements are met : fn > 3, k > 3 or cp / cs > 8, the above circuit is of natural voltage - stabilized characteristics, thus open - loop control method for bucking voltage is presented and the experimental results verify that the method is feasible.,

    實測整機在額定負載時效率達到88以上。在研究lcc諧振網路電壓傳輸特性的基礎上，推導出滿足可變寬度和幅度的諧振網路輸出電壓脈沖列的參數組合。設計f n 3 、 k 3或c _ p / c _ s 8時，諧振網路具有自然穩壓特性，因此本文提出並實驗驗證了一種整機為降電壓時的開環控制策略。
  10. This thesis make a study on vector - contorl wvf system of asynchronous motor. in the course of study, making use of the mathematical model of asynchomous motor in mt axes. then both open - loop control system and close - loop vector - control system are respectively simulated with simulation block simulink in matlab

    本文對異步電動機變頻調速系統進行了研究，利用異步電動機在二相同步旋轉mt坐標系下的數學模型，使用matlab中的模擬工具箱simulink分別對開環控制系統和閉環矢量控制變頻調速系統進行了模擬。
  11. Current - mode dc / dc converter adds a current feedback loop on the base of voltage - mode control, achieving both current and voltage feedback loop control

    電流模式dc / dc變換技術是在電壓模式控制的基礎上，增加了電流反饋環，實現了電壓和電流的雙環反饋控制。
  12. Designed the dual - loop control circuit based on optimized psm, which realize to select the suitable duty ratio to make output stable by utilizing voltage and current feedback loops

    3 ）設計基於優化psm調制模式的雙環控制電路。採用電壓、電流雙環路控制，根據負載情況選擇合適占空比來實現穩壓。
  13. On basis of the development of modern control technology and apply of the network technology and locale bus - mastering technology ， this text analyzes the essential element for produce of wire - roll mill : principle of assign for speed ; expatiates in detail on the network structure and communication protocol of ethernet and profibus - dp ; concretely describes the forms of control system configuration ， the function and features of its software and hardware designs ; also, introduces mainly control function of control system, ， for example ， sequence control 、 loop control 、 fly shear control and operation and monitor function etc

    基於現代控制技術的發展、網路技術以及現場總線技術的應用，本文分析了線材生產的基本要素：速度的分配原則；分析了工業以太網ethernet和現場總線profibus - dp的結構和通訊協議。主要說明plc控制系統的組織結構形式，系統的軟硬體設計的功能和特點。同時，詳細介紹了控制系統的主要控制功能，如邏輯控制、活套控制、飛剪控制以及操作監控功能等等。
  14. Thus, an open loop control scheme and a closed loop control scheme based on chopper system are introduced. lastly, a hardware and software design based on m icro - controller is presented

    本文最後對基於斬波方式的三相交流異步電動機的軟起動方法給出了基於遠程監控的具體實現方案。
  15. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換，建立了系統較精確的數學模型，編制了系統動態及穩態運行的模擬計算程序分別計算系統的動態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究，實驗和模擬結果進行比較，說明實驗和理論較為一致，並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電動機組成的變頻調速系統加以比較。在此基礎上，對兩相逆變器供電-異步電動機系統使用諧波抑制pwm控制進行了研究，由於減少了低次諧波，改善了系統性能。
  16. Comparing and analyzing the synchronous control strategy, which brings up the new method to control the double un - symmetry jars proceed synchronously with the combination of proportional valve and servo valve, which forms closed loop control ; basing on the above methods, models are made to get mathematics models of position control system and to analyze system model theoretically by using pid controller, we can realize regulating parameters, minimizing synchronous errors and enhancing the dynamic performances ; the simulink tool box in matlab software is used to imitate the system according to the model, which not only makes the result visual and easy to adjust the parameters in interactive way but also lets us understand the effects of different parameters and optimizes the dynamic properties. the theory of plc control in dshp is discussed after advanced understanding of the system movements. hardware design and general regulation are given on the base of siemens company products s7 - 200 plc

    本文根據大量的國內外文獻，對研配液壓機的工作原理及設計結構進行了簡介；對位置同步的控制方法進行了比較分析，提出比例閥和伺服閥復合控制的閉環結構來對非對稱雙缸進行同步控制電液比例同步控制方案；在此基礎上著重對比例閥控非對稱缸建模，最後得到位置控制系統的總體數學模型，從理論上對同步系統動態特性進行了分析，並用pid控制器進行參數整定，減小雙缸同步誤差、提高系統的動態響應性能；其中控制性能的分析藉助于matlab軟體中的simulink工具箱，由已建立的數學模型形成模擬模型，得到可視化的模擬結果，從而利於交互方式下調整參數，了解不同的參數對系統的影響，優化同步系統的動態性能；在深入了解系統的動作特性后，對plc控制研配液壓機的原理進行了探討，針對siemens公司s7 ? 200型plc給出了硬體設計的總體規劃，編制出研配液壓機動作控製程序，在編程中著重研究位移傳感器與plc的通訊、雙缸同步運行的pid控制在plc上的實現及bcd碼撥盤輸入程序的植入問題。
  17. Loop control variable

    循環控制變量
  18. Finally, the prototype of closed - loop control system of mc has been designed. a seris of experiments have been made, and the results show that the closed - loop control of mc presented here is correct. also, the mc closed - loop systems based on the method can be applied to the variable frequency power supplies

    最後，製作了輸出電壓有效值控制矩陣變換器閉環系統的原理樣機，進行了一系列實驗測試，結果表明採用雙空間矢量策略矩陣變換器實現輸出電壓有效值閉環控制是正確有效的，輸出電壓有效值控制矩陣變換器閉環系統作為變頻電源設計也是切實可行的。
  19. ( 3 ) the theory of morden optimal control is used for the controller design of the active vibration isolation system. two algorithms, instantaneous optimal control and linear quadratic gauss optimal control, have been discussed and compared. an instantaneous optimal closed - loop control algorithm in structural space is derived by using the newmark scheme

    （ 3 ）應用最優控制理論設計控制器，對瞬時最優控制和線性二次型gauss （ lqg ）閉環控制方法進行研究和對比，並導出構形空間內的瞬時最優閉環控制演算法。
  20. While tv signal is switched, scm outputs volume adiusting code with refference to default volume in a certain period to realize closed loop control of tv accompanyind sound, afterwards back to open loop control

    當信號切換操作時，在一定時間內以默認音量值為參照，由單片機發出電視接收機音量調節編碼，實現電視伴音音量閉環調控，調控結束后恢復開環形式。
分享友人
分享到 Line

分享到臉書