low-temperature heat treatment 中文意思是什麼

low-temperature heat treatment 解釋
低溫熱處理
  • low : adj 1 低的；淺的，矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • treatment : n 待遇；作業；處理，處置；討論，論述；【醫學】治療，療法；（種子的）消毒（處理）。 preferential t...
  1. That is the premise of the bg / ha electrophoresis codeposition. the laws of the electrophoresis deposition of the bg and ha partic les were found by the study on each of their deposition under the different conditions. the electrophoresis codeposition of the bg and ha particles had been studied and the bg / ha graded coating, which is compact in the bottom layer and porous near the surface layer, had been prepared on the surface of the dental implant after the low temperature heat treatment ( about 740 ) and fast firing ( 50 - 80 / min, heat preservation time was 5 - 8min. )

    以bg微粉和ha微粉作為塗層原料，通過研究bg和ha微粉在非水介質中的分散情況和帶電特性，選擇冰醋酸為介質，使分散在其中的bg顆粒和ha顆粒表面均帶上正電荷，為電泳共沉積提供前提條件；通過對不同條件下bg 、 ha各自電泳沉積的研究，探索出了兩者電泳沉積的規律；通過對bg和ha在冰醋酸中電泳共沉積以及后續低溫（ 740左右）快燒（ 50 ? 80 min ，保溫5 ? 8min ）熱處理的研究，在鈦合金牙根種植體基體上成功制備出了底層緻密而表層多孔的bg ha梯度塗層。
  2. Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate

    Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。
  3. An integrated process of wastewater treatment and utilization is presented. the process is made up of heating the soft water of room temperature by high temperature printing and dyeing wastewater via heat exchangers, reusing the low level base decrement wastewater of water washing for dust control and desulphurizing of stack gas and anaeration - aeration biological treatment of printing and dyeing wastewater. this process has fair economical benefit on the principle of so called waste control by waste itself. this might be an ideal process for printing and dyeing wastewater treatment and disposal, the effluent of this process is quite enough to meet the requirement of urban sewer collector. additionally also many advantages are attractive such as the complete return of biological sludge to digestion, no chemicals dosage and free of secondary pollution

    介紹了高溫印染廢水通過熱交換加熱常溫軟水、低濃度堿減量水洗廢水用於煙道氣除塵脫硫、厭氧-好氧處理一般印染廢水等印染廢水綜合處理技術，該技術具有較好的經濟效益，達到了以廢治廢的目的，生物污泥全部迴流硝化，不加任何藥劑，無二次污染，處理后水質達到城市截污管網標準要求，是一種較為理想的印染廢水處理工藝。
  4. Weld and heat treatment of 3. 5ni low - temperature steel tower

    低溫鋼塔的焊接及熱處理
  5. Using the theory of environment isotope and deuterium excess ( d - excess ) parameter, we found the cause of formation of spring ground water in mianzhu area, including the water origin and transportation process and recharge and discharge relationship of various water bodies and hydrogeologic units ; 2. the type of terrestrial heat system is low - medium temperature system of convective type ; 3. this paper valued the si well ( including the scale of geothermal water, exploitation potential and evaluation of medical treatment mineral water ) ; 4

    論文以同位素地球化學和水文地球化學的理論、技術為基礎，結合綿竹三箭水s _ 1井及其鄰區溫泉地下水形成的區域地質構造背景、地層巖石組合特徵及主要水文地質條件，剖析了研究區內可能存在地熱溫泉水的「儲、蓋、通、源」基本條件，對該區各水體的氫、氧同位素、氘過量參數、氚含量以及水化學分析資料進行了系統地研究，取得了以下成果。
  6. The complexation approach applied with the addition of acetic acid complexing agent is used to synthsize dy2o3 / zro2 ceramic power under low temperature. the best heat treatment temperature is about 600

    採用乙醇酸作絡合劑的化學絡合法可以在較低的溫度下制備出氧化鋯和氧化鏑的復合氧化物，最佳的熱處理溫度為600左右。
  7. Plasma nitriding is an application way to metal surface and heating treatment based on the formed plasma by glow discharge. nitriding is a way of heating treatment, namely, metal accessory is put into activate nitrogen and the gas of low light pressure is ionized into energy electrons, high energy ions and high energy neutral atoms by the action of the electric field under a definite temperature and the time of the heat preservation

    等離子滲氮是利用輝光放電形成等離子體在金屬表面，熱處理方面的應用，滲氮是強化金屬表面的一種熱處理方法，是將金屬零件置於活性氮的介質中，在一定溫度和保溫時間下，低光壓氣體在電場作用下使之電離產生能電子、高能離子和高能中性原子。
  8. I. roles of dehydrins in plant tolerance to freezing and drought. accumulations of heat - stable proteins and dehydrins induced by dehydration, low temperature, osmotic stress, high salt or aba treatment were investigated in protocorm - like - bodies ( plbs ) ofdendrobium candidum. moreover, we described the relationship between these accumulations and the development of tolerance to stresses

    一、脫水蛋白對植物抗凍性和抗旱性作用研究以鐵皮石斛類原球莖（ plbs ）為材料，研究脫水、低溫、高滲、高鹽和外源aba處理與誘導熱穩定蛋白和脫水蛋白的關系，以及脅迫誘導蛋白的積累與各種抗逆性形成的相關性。
  9. 5. manganin thin films with low temperature coefficient of resistance were prepared by magnetron sputtering. the changes of tcr under difference deposition and heat treatment conditions were studied

    首次採用磁控濺射法沉積了低電阻溫度系數的錳銅薄膜，研究了在不同電子科技大學博士學位論文沉積及熱處理條件下薄膜tcr的變化。
  10. Preparation of film electrode is the base of micro battery and grotesque battery. limn2o4 got great attention for the reason of safety, low heat treatment temperature and low cost

    薄膜電極的制備是微型電池和異型電池制備的基礎， limn2o4由於其安全性、熱處理溫度低、成本低等特性引起人們極大的關注。
  11. The hexagonal barexfe, 2. xo, ( re denote la ^ nd > sm and gd ) ultrafine powders with m - type structure were firstly synthesized by a novel technique - - - - - - sol - gel combustion synthesis method which combines sol - gel method with low temperature combustion synthesis method. based on theoretical analysis and experimental study, the effects of the composition of the gel, the different kinds of intermediate, strength of solution, the amount of complexing agent, the different kinds of anions, the adding of dispersant, auto - propagating combustion and the condition in heat treatment of the gel on crystal phase, particle size, morphology and magnetic properties of bare ^ fe ^ o, ultrafine powders were firstly investigated systematically to clarify the optimum forming conditions

    本研究是在前人工作的基礎上，同時從制備方法和摻雜元素兩方面著手，以保證制備的粉體材料具有優異的性能，即首次利用溶膠?凝膠濕化學合成法和低溫燃燒合成法相結合的一種兼具二者優點的超細粉末新型合成技術? ?溶膠-凝膠燃燒合成法來完成稀土元素摻雜鋇鐵氧體bare _ xfe _ （ 12 - x ） o _ （ 19 ） （ re為la 、 nd 、 sm 、 gd ）超細粉末的制備。
分享友人
分享到 Line

分享到臉書