margin distance 中文意思是什麼

margin distance 解釋
邊界距離
  • margin : n 1 邊緣;邊緣部分;范圍,限界;【軍事】圖廓。2 (版心外)空白;欄外,欄外註解。3 【商業】原價和...
  • distance : n 1 距離,路程。2 遠隔,遠離;遠處,遠方。3 (時間的)間隔,長遠,長久。4 懸殊。5 隔閡,疏遠。6 ...
  1. For this problem, a separating hyperplane is designed with the principle of maximizing the distance between two class centers, and a novel support vector machine, called maximal class - center margin support vector machine ( mccm - svm ) is designed

    為了解決這個問題,本文以兩個類中心距離最大為準則建立分類超平面,構造一個新的支持向量機,稱作類中心最大間隔支持向量機。
  2. Various anatomical structures were dissected. the distance between these structures and the underlying venous sinus was measured on the cadaveric heads. using 4. 5 loupes magnification, the occipital condyle was dilled to the intracranial end of the hypoglossal canal from posterior laterior margin according to the procedures of far lateral approach, then the length of remainder was measured

    對15個10福爾馬林固定的成人屍頭標本進行解剖:測定橫竇、乙狀竇、竇匯顱骨外表面標志,自后外向前內磨除枕髁至顯露舌下神經管內口,測量所需磨除的枕髁范圍。
  3. The juridical continental shelf of a coastal or island nation consists of the seabed and subsoil of the submarine areas that extend beyond its territorial sea to the outer edge of the continental margin, or to a distance of 200 nautical miles from the baseline used to measure the territorial sea where the continental margin does not extend to that distance

    書上的翻譯:沿海國或者島國法律上的大陸架包括延伸到其領海以外直到大陸邊緣外部界限的海底區域的海床和底土;如果從測算領海寬度的基線起到大陸邊緣的距離不到200海里,則應擴展到200海里的距離。
  4. To make use of the maximum signal margin with the maximum scanning distance tolerance, the switching threshold should be set at the mid - way point between the background and mark signals

    在使用具有最大掃描距離偏差的最大信號邊限時,轉換門限應該設置在背景與標識信號的正中間?
  5. In contrast, a margin is the distance separating the adjoining edges of two adjacent ui elements

    相反,邊距是分隔兩個相鄰ui元素鄰接邊緣的距離。
  6. The snapline defining the sum of the margin values is longer and that the control snaps to a greater distance from the other control. change the

    定義邊距值之和的對線變長,該控制項對時與另一控制項之間的距離變大。
  7. Margin property defines the space around the control that keeps other controls a specified distance from the control s borders. the

    屬性定義控制項周圍的空白,以使其他控制項與該控制項的邊界保持指定的距離。
分享友人