mass flow ratio 中文意思是什麼

mass flow ratio 解釋
質量量比
  • mass : n 彌撒；彌撒的儀式[禱告、音樂]；彌撒曲。 a high [solemn] Mass （有燒香、奏樂等的）大彌撒。 a low ...
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. 3 the design theories of cooling pipe of play down internal temperature of mass concrete about diameter, length, arrange method, rate of flow, current velocity, reduce heat time, temperature disparity to in and out, reduce heating result etc. 4 the theory of influence about concrete internal temperature and concrete crack because of transform of mixture ratio and pulverized fuel ash sophisticate quantity

    西安建築科技大學博士生論文一;一;一一『一一一3降低大體積混凝土內部溫度常用的冷卻水管的管徑、長度、布置方法、水流量、流速、降溫時間、進出水口的溫差、降溫效果等的設計計算理論。 4配合比及摻加料對混凝土內部溫度和混凝土開裂的影響理論。
  2. Much works has been distributed to the development of a vacuum system to simulate the outer space and a measurement system to test the arcjet performance. ignition experiments in various operational modes have been done with argon as propellant. macroscopical working parameters including thrust, mass flow rate, voltage, current, inlet pressure and vacuity are obtained by the test measurement system and actual performance parameters including specific impulse, thrust efficiency, ratio of thrust and power and ratio of power and mass flow are calculated

    以氬氣作為推進劑，在不同工況下進行點火實驗，測量獲得了其工作推力、電弧電壓和電流、推進劑流率和弧室壓力等宏觀參數，得到了不同實驗條件下其工作的實際比沖、推力效率、推力/功率比以及比功率等性能參數，分析了推進劑質量流率、電弧功率、電弧加熱發動機電弧室結構尺寸等因素對其性能的影響，為數值模擬研究和實際的低功率電弧加熱發動機優化設計及研製提供了實驗基礎。
  3. Four conclusions were obtained : 1 ) the ideal maximum performance of rbcc engine is basically determined by the match of rbcc " s basic operating parameters such as the ratios of primary / secondary mass flow rate, total pressure, total temperature and the ratio of overall oxidant / fuel mass flow rate, etc

    主要獲得如下結論： 1 ）基本工作參數的匹配，如引射比、總壓比、總溫比，決定了引射發動機最大可能獲得的性能。
  4. The experimental results indicates that the secondary mass flow increases with increasing of primary mass flow rate, but the bypass decrease because the primary mass flow rate increase more rapidly than secondary mass flow. the expansion configuration shows low thrust property due to low pressure in flow path. the secondary nozzle changes the pressure distribution in ejector combustor, and decreases bypass ratio, but obtain more completely mixing

    結果表明：二次流流量隨著一次流流量的增加而增加，由於二次流流量的增加速度低於一次流，引射系數減小；在純擴張式結構實驗中，引射燃燒室壓強很低，難以實驗推力增強；二次噴管改變了引射燃燒室的壓強分佈，降低了引射系數，改善了混合狀況能；對于本文的實驗結構，存在一個最優的二次噴管出口面積，使引射火箭推力最大，同數值模擬結果相吻合。
  5. The characteristic of combined heat and mass transfer by natural convection has been the focus of researches for a long time. numerical analysis is conducted for combined heat transfer and mass transfer by natural convection on inclined surface. effects of the inclination angle and the ratio of buoyancies due to heat diffusion and mass diffusion on fluid flow and heat and mass transfer characteristics have been investigated for pr = 0. 7 and sc = 0. 05 - 5. 0

    本文採用數值計算方法研究了傾斜平面上的傳熱傳質復合自然對流，求解了動量、能量及質量的完整方程，考察了熱質擴散共存時傾斜平面上的流動和傳熱特性，著重分析了熱浮力及物質擴散浮力之比b和傾斜角度對流體流動和傳熱傳質特性的影響。
  6. Measuring the mass flow rate in relation to outlet pressure, the critical pressure ratio is defined as the criterion for whether the choking phenomenon takes place

    此時，其流速和流量將保持一致且不受后續管路條件不同的影響，從而可起到均化噴煤量的作用。
  7. This paper compares the computing results of the one - way coupling method and two - way coupling method, and the result indicates that the one - way coupling method is applicable when the mass and momentum ratio of the discrete phase in the turbulence flow velocity field is small in the chamber

    文中對採用單向耦合和雙向耦合計算方法的計算結果進行了比較，結果表明爐內離散相在流場中的質量及動量承載率較低時，單向耦合計算方法適用於研究對象的冷態流場計算。
  8. It is shown that when the exit area of secondary nozzle and the fuel / oxidizer ratio is fixed, the increase of mass flow rate of secondary flow lead to the decrease of velocity of mixed flow, and increase of total mass flow rate. the synthetical result of these two phenomenon cause the increase of thrust of rocket ejector, but the increasing magnitude is relatively small, indicating that these is no necessary to claim large bypass ratio in rocket ejector design. in the comparison between two configurations, the typical one has better performance, indicating the importance of pressure ratio

    結果表明：在固定二次噴管出口面積和氧燃比的條件下，二次流（引射空氣流）流量的增加引起混合氣體出口速度的下降和總流量的增加，二者綜合作用使發動機推力增加，但增幅不大，表明在設計發動機結構和工作參數時，不必過分追求大的引射系數；兩種結構的性能對比分析表明了增壓比對引射火箭性能的提高具有重要意義；對引射火箭的熱力循環分析同樣表明，增壓比對于提高發動機性能非常關鍵。
  9. The mass flow rate coefficients increase and achieve a constant at last with increasing blowing ratio. the influence of blowing ratio on the heat transfer coefficients and film effectiveness is complex

    流量系數隨吹風比的增大而增大並最終趨于某個定值，但吹風比對氣膜孔下游換熱系數和冷卻效率則較為復雜。
  10. The distribution of the mass flow rate, the heat transfer coefficients and the film effectiveness of cylindrical holes was measured. the influence of mainstream reynolds number, blowing ratio and the position of holes on flow rate, the heat transfer coefficients and the film effectiveness was studied greatly

    測量了氣膜孔的流量系數、氣膜孔下游換熱系數和冷卻效率的分佈，重點研究了主流雷諾數、二次流吹風比以及孔排位置對氣膜孔的流量系數、氣膜孔下游的換熱系數和冷卻效率的影響。
  11. Mass flow ratio

    質量流量比
分享友人
分享到 Line

分享到臉書