mass surface 中文意思是什麼
mass surface
解釋
質量面-
A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate
對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎 -
The bacilliform cell penetrate into interior of the fibre to degrade the cellulose strongly and produced a mass of sticky polysaccharides. after cultured 48 hours, the bacilliform cell ' s surface of sporocytophaga have a great change. at this stage the bacilliform produce a lot of sticky polysaccharides. these sticky polysaccharides associated with the sites where the filter paper was decomposed intensively and form thorns on the surface of the bacillium. at the same time, the filter - paper weight loss is the greatest and decomposing rate is the fastest, so we think that the sticky polysaccharides are produced during the cellulose degradation
培養48小時，桿狀細胞的表面結構發生很大的變化，此時的菌體表面已產生大量的粘性多糖，這些粘性多糖因菌體在纖維素表面滑動而在菌體表面形成突起，即在纖維素被旺盛降解部位的菌體表面產生了大量突起；而產生突起的菌體深入到纖維素分子內部，纖維素表面可以清晰地看到由於菌體嵌入纖維素分子內部而留下的凹陷。 -
Construction of a mass concrete is in the construction process, because of cement let out in large quantity hydration heat and surface of a mass concrete let out heat, make its temperature, humidity cause to ascend and descend, and it causable constringency transform will be unavoidable
大體積混凝土結構在施工過程中，由於混凝土中水泥熟化時放出大量的水化熱及其隨后的表面散熱，使其溫度、濕度出現升降變化，並由此而引起的收縮變形將是無法避免的。 -
It is found that this qcm technique is not only to be comparable to the surface plasmon resonance ( spr ) in response characteristics, but also more simple, cheap and reproducible in its equipments. the fourth part, an amplified by peg mass piezoelectric immunoassay has been developed to detect the ceruloplasmin in human serum
將之用於測定了人血清白蛋白（ hsa ）抗體的活性，並與文獻報道的表面等離子體子共振法（ spr ）進行了比較，發現該傳感系統的響應性能可與spr法媲美，而且較之具有儀器簡單廉價、再生簡便等優點。 -
In cold region, crevices emerged on the surface of mass concrete because of cold waves
對于嚴寒地區寒潮是大體積混凝土產生裂縫的主要原因。 -
Abstract : in cold region, crevices emerged on the surface of mass concrete because of cold waves
文摘:對于嚴寒地區寒潮是大體積混凝土產生裂縫的主要原因。 -
Because of the mass displacement of material from the earth's surface, a crater is formed.
由於在地面上掀起了大量的物質，因此留下一個彈坑。 -
Fundamental of laser 40ar / 39ar dating method : our laboratory has successfully set up the laser microprobe 40ar / 39ar geological dating method. our works include adjustment of the high - gain electron multiplier in mass spectrometer and correction of mass discrimination, adjustment of the laser, test for absorption ability of minerals to laser, designing and manufacturing high - vacuum sample chamber, sample preparation and irradiation, research on the variability of j values on the surface of rock chips, measuring atmospheric argon, determination and correction of blanks and ages, etc. the laser microprobe technique is particularly effective for some geological samples. it can be used, for example, for research of distribution of the components in extremely small samples that are very difficult to be separated and purified and those which contain excess argon
本文首先從常規~ （ 40 ） ar ~ （ 39 ） ar階段升溫定年實驗室的改進入手，進而建立了激光~ （ 40 ） ar ~ （ 39 ） ar定年實驗室，利用這兩種先進同位素地質定年方法，結合其他手段，對青藏高原腹地和北緣的阿爾金斷裂系多期地質事件進行了詳細的同位素年代學研究：一、參照國際先進實驗室的流程，對我們的常規~ （ 40 ） ar ~ （ 39 ） ar階段升溫實驗室在樣品的預處理、樣品的照射條件和系統空白測量及校正等方面進行了改進，使之產出的同位素年代數據更可靠並為國際同行所承認。 -
On the uneven surface of the pond, all one could see was a mass of leaves all interlaced.
曲曲折折的荷塘上面，彌望的是交織在一起的葉子。 -
The carbon nanotubes ( cnts ) are attractive materials for electrodes of supercapacitors due to their superb characteristics : chemical stability, low mass density, low resistivity, and large specific surface area
納米碳管導電性好、比表面積大、微孔集中在一定范圍內，從理論上講是製作超級電容器的理想材料。 -
Lower mass it would be like our moon, unable to keep any gases around its rocky surface. if earth were of greater mass then all gases would be trapped in the atmosphere, creating volatile conditions unsuitable for life
這可是非常重要的，因為假如質量小些的話，它就會好像月球嶙峋表面一樣，無法把空氣抓住，相反，假如質量大一些，就會把所有氣體都困在大氣層中，使環境變化無常，生物難以適應。 -
Figure 7-12 shows a body of mass m on a level surface.
圖7-12表示水平面上質量為m的物體。 -
Boundary conditions were obtained by energy, mass balance relationship on insulation surface
邊界條件通過燒蝕界面上的能量、質量守恆關系得出。 -
At recent decade, accompany with surface mount technology printed - circuit board to produce fly of automation degree to soon develop, as to it ' s correspond of mass defect the inspection also put forward higher request, from in brief shoot to be like system to complicated " 3 - d " x optics to examine system, the automatic optical inspection is in great quantities adopt by the each production factory house
摘要在最近十年，伴隨著表面貼裝印刷電路板生產自動化程度的飛速發展，對其相應的質量缺陷檢查也提出了更高的要求，從簡單的攝像系統到復雜的" 3 - d " x光檢測系統，自動光學檢測系統大量被各生產廠家採用。 -
Piezoelectric sensors, commonly known as quartz crystal microbalance, are sensitive to multiple signals such as the surface mass and the viscosity, density, dielectric effect, conductivity of the liquid
壓電傳感技術則是一種比較成熟的傳感技術，可響應石英晶體表面的質量變化及溶液粘度、密度、介電常數、電導率等參數。 -
The mass of the pendulum bob does not change from one location to another on the earth's surface.
擺錘的質量在地面各處都一樣。 -
In this thesis, based on pershing ii surface to surface missile, a new kind of ballistic missile was designed with an additional rocket engine, which can be ignited twice. firstly, aerodynamic computational models of missile body and warhead which reentry with supersonic are built according to the task requirements ; secondly, the propulsion system model of missile is built whose first two stages are solid rocket engines and the third stage is liquid - solid combined rocket engine. the nozzle and the shape of the engine are designed to meet the needs of the populsion project ; thirdly, the trajectory model of the mass point is built and a wavy trajectory is designed & optimized ; finally, the ability of a missile ' s breaking through defence is analyzed
以美國潘興導彈為原型，增加可兩次點火的末級發動機，改裝成具有跳躍能力的地地彈道導彈；首先，根據任務需求，建立了導彈的氣動模型，並建立了彈頭再入時高超聲速氣動模型；其次，建立了導彈推進系統模型，前兩級採用了固體火箭發動機，第三級採用了固?液組合火箭發動機，並在總體方案要求下，對發動機噴管和外形進行了設計；第三部分，建立了導彈質點彈道模型，設計了一條跳躍式彈道，並對跳躍式彈道進行了優化設計；最後，對導彈進行了突防能力分析，從分析的結果可以看出，跳躍式彈道的突防能力比常規的拋物線彈道要強。 -
It provides a new thought for modifying and immobilizing mass recognizing film on the surface of qcm sensors when the substance is difficult to deposit or the performance of the membrane is not steady. so the plasma technique can be widely used to make qcm sensors, the qcm sensor is steady, easy to regenesis and has tong lifetime
在「等離子體qcm化學傳感器」一章中，詳述了另一種重要的化學傳感器?三乙醇胺塗膜qcm傳感器的傳感特性與器件性能，並對處理前後的性能做了對照，等離子體表面改性處理后的三乙醇胺qcm傳感器對烷烴類的i性率高o00 ） 。 -
This experiment focuses on the characteristic of green refrigerant r600a in a small parallel flow aluminum closed two - phase thermosiphon and measures all the quantity of injected mass and heat dissipation, the speed of air and the difference of temperature of the electronic element ( cpu simulate chip ) surface and environment
處理速度達到g數量級，功率消耗更達幾十瓦。如何解決cpu散熱問題，成為關注的焦點。本實驗首次研究了綠色環保工質r600a在一種鋁質重力熱管中的工作特性。 -
Molecules which are torn from the surface of the water bear a negative charge ( small negative ions ) whereas large drops of the entire mass of water are positive
勒納德（ 1915年）發現：當水變成霧狀（例如水滴的碰撞）時，就會分割出正負電荷。
分享友人