mass transfer coefficient 中文意思是什麼

mass transfer coefficient 解釋
傳質系數
  • mass : n 彌撒；彌撒的儀式[禱告、音樂]；彌撒曲。 a high [solemn] Mass （有燒香、奏樂等的）大彌撒。 a low ...
  • transfer : n 1 移轉，轉送；調職；調任[轉學]證書；變換。2 （財產；權利等的）轉讓，讓與（證書），移轉，授受；...
  • coefficient : adj. 共同作用的。n. 1. 共同作用；協同因素。2. 【數，物】系數，率；程度。
  1. Finally, by studying the heat transfer coefficient and the mechanism of mass transfer through the membrane pores, a complete mathematical model was proposed for the removal of voc from dilute aqueous solutions by vmd

    根據對傳熱系數和膜孔內傳質機理的研究，最後得到了真空膜蒸餾脫除水溶液中voc全過程的數學模型。
  2. The hydrodynamic parameters and mass transfer coefficient are studied in the internal loop airlift bioreactor used in treating wastewater. the hydrodynamic parameters consist of gas holdup, liquid velocity and axial dispersion coefficient

    本文從流體動力學和傳質動力學兩個方面考察了用氣升式內環流生物反應器應用於廢水處理的性能。
  3. The investigation on the evaporation heat transfer characteristics in a horizontal micro - fin tube for r290 - 3gs mixture shows : a ) the average evaporation heat transfer coefficient of the mixture increase with the increasing of the mass flux

    R290含油混合物在水平微肋管內流動沸騰換熱特性的實驗研究表明： a ）隨著質量流率的增加，含油混合物微肋管內的沸騰平均換熱系數增加。
  4. At the same time, the intrapartical diffusion and liquid internal mass transfer can been enhanced by ultrasound field, owing to additional stirring, the increasing rate of intraparticle diffusion coefficient is enhanced, while that of the liquid film mass transfer coefficient is reduced under ultrasound field

    模型研究表明： freundlich ?兩相阻力模型計算得到濃度與實驗測定值非常吻合，超聲場能有效地強化浸取粒內擴散與液膜傳質，攪拌作用下超聲強化液膜擴散的的能力降低，強化粒內擴散的能力增強。
  5. In this research, through the test in geometric parameter and resistance performance, and comparison between random and other stacked packing, pvc screw thread oblique corrugated plate have more advantage. combined with test and theoretic calculate, determined the heat and mass transfer coefficient, obtained the influence relationship between inlet air flow rate, temperature and humidity, inlet liquid desiccate flow rate, temperature and concentration with outlet air humidity in dehumidifier, provided consideration for equipment design and production

    通過對除濕塔的現場測試並結合理論計算，確定其熱質交換系數，並分析得出採用pvc螺紋斜波紋板填料的一定結構的除濕塔，處理空氣的風量、入口溫度和含濕量及除濕溶液流量、入口溫度和濃度對空氣出口含濕量的影響關系，為除濕設備的設計和指導生產運行提供參考。
  6. On the basis of above theoretical derivation and analysis on experimental results, by correlating solvent ( water ) transfer with solute ( salt ) transfer on hot side and correlating mass transfer with heat transfer during vmd and introducing a contribution coefficient which can reflect the characteristics of mass transfer through membrane, a new model of mixed flow is presented

    在上述理論推導及實驗分析的基礎上，本文將熱側溶劑傳輸與溶質傳輸、膜蒸餾過程熱量傳輸與質量傳輸相關聯，並引入一個能夠反映膜內質量傳輸特徵的「貢獻系數」 ，將努森流模型與粘性流模型結合起來，從而提出了新的混合流模型。
  7. The calculation program using the matlab has been worked out to get the numerical solutions of the proposed models. the experiment has first been conducted in the laboratory to get the fundamentals thermal and moisture properties ( such as materials density, specific heat capacity and thermal conductivity ) and also the material moisture absorption isotherms of adobe building materials. the methods of measuring the surface mass transfer coefficient and material moisture content have been proposed

    首次對生土建築材料物性參數進行了實驗測試，得到了常用生土建築材料的密度、比熱和導熱系數等參數值，得到了生土建築圍護結構的等溫吸濕平衡曲線的擬合函數關系式；此外，研究了生土建築圍護結構表面質交換系數實驗測定方法，探索了利用電阻率測量生土建築圍護的安窪築科技人學博十學位論文結構內部含濕量的測試方法。
  8. Lewis relationship has been suggested to evaluate the surface mass transfer coefficient using the average surface convective transfer coefficient. in addition, a practical analytic technique for testing the surface mass transfer coefficient is proposed and the values of he surface mass transfer coefficient have been given for the particular desorption and absorption test and validated against lewis relationship results. indoor temperature and humidity evaluation equations of adobe buildings considering the moisture absorption and desorption by interior materials have been proposed based on the analysis of the indoor dynamic thermal and moisture process

    通過理論解析和實驗測試定量地研究了生土建築圍護結構表面吸放濕效應，首次提出了以空氣濕度（ kg / kg ）為驅動勢差的圍護結構表面吸放濕量計算公式，該公式較適用於工程計算，從而為使建築濕環境研究成果逐步應用到建築工程實踐中奠定了理論基礎和提供了簡便演算法；通過對國內外關于表面質交換系數確定方法的研究成果的分析，提出用lewis關系計算生土建築圍護結構表面質交換系數；在實驗室環境下，對生土建築圍護結構表面質交換系數進行了測試方法研究，測試結果和利用lewis關系得到的數值較接近。
  9. The influence of various waterpower and configuration parameters on heat transfer is analysed and the rules of convective heat transfer coefficient and the ratio of heat transfer enhancement with mass flux are obtained. at the same time, we gain important results as below : as for resonance chamber with certain configuration, self - oscillation can be generated under suitable configuration and waterpower parameters. for the same configuration resonance chamber, the intensity of the self - oscillation is changed by the waterpower parameters

    當流量及壓差降低至一定程度時，共振腔還可能削弱換熱；加熱功率的提高會增加流體（水）的溫度，流體的粘度會隨著降低，這會減少對流體脈動的阻礙，使脈動衰減得更慢，而脈動幅度的增加會增強換熱，故加熱功率對有脈動的對流換熱是有影響的；自振腔產生的流體脈動頻率是自振腔固有頻率或其整數倍，流體脈動頻率過高或過低都不利於對流換熱，存在一有利於強化換熱的頻率范圍。
  10. Based on the analysis of gas - solid multiphase catalytic reaction, the chemical reaction model is established. when the reaction is controlled by the chemical dynamic, the reaction rate is introduced by consideration of the adsorption and desorption effects. when the reaction is controlled by mass transfer, the diffusion coefficient is established which can present the flow rate increases in small reynolds domain ; for the internal diffusion, the internal diffusion coefficient is derived, and then the internal diffusion is coupled with chemical reaction to represent the phenomenon that the diffusion and the chemical reaction occur cocurrently

    本文在考慮催化轉化器載體內發生的傳熱傳質現象的基礎上，建立了催化轉化器的一維單孔道和三維多孔道傳熱傳質模型;在分析載體內以氣-固多相催化反應為特點的工作機理的基礎上，建立了催化轉化器的化學反應模型:當催化轉化處于化學動力學控制區時，引入了考慮吸附、表面反應和脫附的表面化學反應速率公式，當催化轉化處于質量輸運控制區時，引入了決定外擴散能力的擴散系數公式和和決定內擴散速率的內擴散系數公式，並與化學反應速率相耦合，得出由擴散過程決定的化學反應速率公式。
  11. The factors affecting the permeability coefficient are investigated, and the mass transfer model across the supported liquid membrane is established, by which the mass transfer is simulated

    考察了各因素對滲透系數的影響，並對傳質滲透過程進行模擬。同時建立了支撐液膜中的膜相流失行為的動態膜阻抗監測方法。
  12. Secondly, for the first time, by volume average concept and reynolds time - average method, a 3d quasi - single phase mass transfer model of distillation tray is deduced by considering the effects of velocity fluctuation, concentration fluctuation and volume fraction of gas and liquid on mass transfer. a source item sc for interphase mass transfer is considered. by applying conventional method of estimating the interphase mass transfer coefficient, a formula for sc is obtained

    其次，採用體平均概念、雷諾時均化方法結合塔板氣液相互作用的實際情況首次推導了考慮速度、濃度脈動項和氣、液相含率影響的塔板三維擬單相流湍流傳質模型，源相中考慮了氣液相間傳質項sc ，並運用化工中關于相間傳質系數計算的理論，推導了sc的表達式。
  13. The effectiveness of a membrane mass exchanger increases with the increase in the so solute mass transfer coefficient, ultrafiltration flux and dialysate flow rate, as well as with the decrease in the retentate flow rate

    薄膜質量交換器之效率隨溶質質傳系數、超過濾濾速、及透析液流量之增加，或隨保留液流量之降低而增加。
  14. In air - water system, the influence of gas superficial velocity on hydrodynamic parameters and volumetric mass transfer coefficient ( k, a ) is investigated. in order to simulate microorganism, a series doses of solid particle are added into water. in such an air - water - solid particle system, the influence of solid concentration on hydrodynamic parameters and volumetric mass transfer coefficient are studied

    在空氣-水體系研究了表觀氣速對流體動力學參數和傳質動力學參數的影響；以固體顆粒模擬生物相、以柔性填料模擬生物填料床在空氣-水-固體顆粒和空氣-水-填料體系中研究固含率對流體動力學參數和傳質動力學參數的影響；以cmc溶液模擬實際操作中的液相介質研究液相粘度對上述參數的影響； 4
  15. Mass transfer coefficient

    質量交換系數
  16. According to the theory of engineering thermodynamics and phase change, heat - transfer process of the special working fluid heat - pipe stove is analyzed. some hypotheses are postulated and with the help of equation of mass - conservation, energy - conservation, the dynamic concentrative parameter model is built, the change of each parameter is prescribed at any stage from starting to stopping. with the thermodynamic calculation of burnable process, the parameter of device, such as heat - transfer coefficient / thermal efficiency etc, are achieved under steady state ; based on theoretic calculation, observing the actual running circumstance of the heating stove in person, with some performance comparison between the new and the old, the high efficiency and reliability of heat - pipe stove is proved, the project which expend it in the oil - filed is feasible

    對充入該工質的熱管加熱爐，本文根據工程熱力學和相變傳熱學及相關知識，對其進行了傳熱分析，經過適當假設，運用質量守恆和能量守恆定律，建立了裝置動態集中參數模型，描述了加熱爐從開機到穩定運行這一動態過程各參數的變化情況，同時對燃燒過程也進行了熱力計算，最終得到了穩態工況下裝置的換熱系數、熱效率等熱力參數；在理論計算的基礎上，親赴現場觀察該爐的實際運行情況，通過與原有的加熱爐的各項性能進行對比，最終證明新爐的高效性和可靠性，為其在油田中推廣的可行性提供了依據。
  17. The investigation of gas - liquid mass transfer coefficient in cyclone reactor

    旋流反應器的氣液傳質系數的研究
  18. 5. the increasing of liquid phase viscosity undermines the volumetric mass transfer coefficient

    隨液相介質粘度的增加容積氧傳質系數減小。
  19. In the air - water - solid system the value of volumetric mass transfer coefficient is larger than that in air - water system. and when cs = 1. 0 %, the volumetric mass transfer coefficient get to the highest value

    在液相介質中加入固體裝填物提高了容積氧傳質系數，並且在固含率為1 . 0時容積氧傳質系數最高； 5
  20. The numerical simulation result obtained by taking the dimensionless mass transfer coefficient as the input parameter of the mathematical model is consistent with the 73 groups of the experimental data and the discrepancies of the enthalpy efficiency and regenerative efficiency are mainly within 15 %

    以實驗得到的量綱一傳質系數作為數學模型的輸入條件，數值計算結果與73組實驗數據吻合很好，全熱效率和再生效率的偏差均集中在15 %以內。
分享友人
分享到 Line

分享到臉書