mass transfer theory 中文意思是什麼

mass transfer theory 解釋
質量傳遞理論
  • mass : n 彌撒;彌撒的儀式[禱告、音樂];彌撒曲。 a high [solemn] Mass (有燒香、奏樂等的)大彌撒。 a low ...
  • transfer : n 1 移轉,轉送;調職;調任[轉學]證書;變換。2 (財產;權利等的)轉讓,讓與(證書),移轉,授受;...
  • theory : n. 1. 理論,學理,原理。2. 學說,論說 (opp. hypothesis)。3. 推測,揣度。4. 〈口語〉見解,意見。
  1. In the model the film thickness in the passage was obtained at first using two phase flow theory ; then, similar analysis solution of concentration distribution of the pollutant in liquid phase and biofilm was obtained through mass component equation of pollutant in gas - liquid phases combined with the biochemical kinetic equation of mass transfer in biofilm and dismission of oxygen limited ; at last, the distribution of pollutant along the filter height and the waste gas purification efficiency were obtained

    該模型首先運用兩相流理論獲得了通道內液膜厚度,然後通過污染物在氣相、液相的質量組分方程,結合生物膜內的傳質與不?慮氧限制的生化反應動力學方程,獲得了污染物在液相和生物膜中濃度分佈的近似分析解,最終得到污染物在氣相中沿塔高的濃度分佈及廢氣凈化效率。
  2. The mass transfer model of the foam was established on the basis of the penetration theory, and the mass transfer model of the compound tray was obtained according to the mass transfer model of the foam and frb model in packing

    以溶質滲透理論為基礎,建立了泡沫層的傳質模型,根據泡沫層的傳質模型和規整填料的fbr傳質模型,獲得了預測復合塔板傳質效率的模型。
  3. As to the work about theory analysis, at first, the paper describes the atomizing and humidifying process of the centrifugal nozzle with firing pin type, high pressure and little aperture and liquid physical properties. later, combining with the structure characters of this kind of nozzle, the paper studies on the theory of the atomizing and humidifying process by three phases, which is water film forming phase, water film falling into pieces phase, and heat and mass transfer between water and air phase in turn

    理論工作方面,首先描述了撞針型高壓小孔徑離心式噴嘴的霧化加濕過程和液體的物理性質,然後結合撞針型高壓小孔徑離心式噴嘴的結構特點,將其霧化加濕過程分三個階段進行機理上的研究,這三個階段依次為液膜形成、液膜初次破碎及二次霧化、水與空氣的熱濕交換。
  4. In this thesis, studies are focused on as follows : ( 1 ) based on analyzing the general transfer - matrix, the conception of the generalized double layer soil model is proposed, and the transfer - matrix ( r ) of half - infinite elastic mass is introduce - d to the analytic expressions of stress and settlement under the uniform circular, rectangular and strip vertical loads in multi - layered soil ; ( 2 ) according to the analytic expressions of the additional stress and settlement under unifo - rm circular in multi - layered soil, rectangular and strip vertical loads, the programs are develop - ed to resolve and debugged. the results show that the programs are correct ; ( 3 ) through calculating the coefficient of additional stress on the central axis of uniform circ - ular vertical loads, under the corner point of the uniform rectangular vertical loads, and on the central axis of uniform strip vertical loads, and the settlement on the center of uniform circular vertical loads and uniform rectangular loads in double - layered soil, the characters of stress and settlement are discussed ; ( 4 ) a case, as an example, is studied with different calculation methods, such as traditional theory, fem. the results obtained are compared

    本文在已有研究成果的基礎上進一步開展了以下幾方面的研究: ( 1 )在對層狀地基傳遞矩陣法中的總傳遞矩陣分析的基礎上,提出了廣義雙層地基模型的概念,並把半無限體的傳遞矩陣r引入到多層地基在圓形垂直均布荷載、矩形垂直均布荷載及條形垂直均布荷載作用下附加應力與沉降的解析式中; ( 2 )根據多層地基在圓形荷載、矩形垂直均布荷載及條形垂直均布荷載作用下附加應力與沉降的解析式,編制了程序,調試通過並驗證了其正確性; ( 3 )通過對雙層地基圓形垂直均布荷載中心軸線上的附加應力系數和荷載中心沉降,矩形垂直均布荷載角點下的附加應力系數和荷載角點沉降及條形垂直均布荷載中心軸線上的附加應力系數進行的計算,探討了雙層地基中的附加應力與沉降特性; ( 4 )應用本文的層狀地基體系理論對一個工程實例進行了計算分析,並與傳統的計算方法的計算結果和有限單元方法的計算結果進行了對比分析,結果表明利用層狀地基理論計算更能反映地基中附加應力分佈的實際情況。
  5. Theory calculation and derivation demonstrate that the heat conduction of membrane exerts little influence on performance. the characteristics of mass transfer through membrane are mixed flow including knudsen flow and poiseuille flow, which moreover, vary with operational variables

    理論推導與計算表明:膜的導熱性對真空膜蒸餾過程的影響可以忽略,膜蒸餾過程膜內質量傳輸機制是努森流與粘性流共同作用的混合流機制。
  6. Abstract : on the basis of the general chromatography rate model, the effects of bi number, number, mass transfer pel number, particle diameter, injection and ratio of solute diameter and pore diameter on the chromatographic peak of taxol and the separation of taxol and cephalmonnine were simulated with computer. the essential factors affect on the chromatographic process of taxol and cephalmonnine were obtained and a more useful theory was provided to direct the chromatography separation of taxol and cephalmonnine

    文摘:根據建立的液相色譜普遍化速率模型,模擬了比渥數、數、傳質彼克列數、粒徑、進樣量和溶質分子直徑同多孔粒子孔徑比對紫杉醇色譜峰峰形和紫杉醇和三尖杉磷堿色譜分離度的影響,獲得了控制紫杉醇和三尖杉磷堿色譜過程的主要影響因素,從而為紫杉醇和三尖杉磷堿的色譜分離提供了更好的理論指導。
  7. In this paper, based on my experiments, the mechanism of pneumatic defrosting of air cooler was studied through the application of thermodynamics, heat and mass transfer, classical theory of nucleation, boundary - layer theory, the theory on gas dynamics

    本文在對氣動除霜進行了實驗研究的基礎之上,應用工程熱力學、傳熱傳質學、晶體成核理論、邊界層理論、氣體動力學等有關知識,從系統的觀點出發,探討了氣動除霜的機理。
  8. Analyses experimental results with classical heat and mass transfer theory, and indicates that when these parameters change, the latent heat efficiency changes much more than the sensible heat efficiency

    利用經典傳熱、傳質理論對實驗結果進行了分析,指出當上述因素發生變化時,全熱交換器潛熱交換效率受到的影響大於顯熱交換效率。
  9. ( 1 ) the cfd model for the pulse combustion spray drying process. the computational fluid dynamics ( cfd ) based on the two - phase flow theory was employed in this paper, which used the standard k - e model and the particle trajectory model to simulate the gas - particle flow in the drying chamber. the momentum, heat and mass transfer regarding both gaseous and particulate phases during the spray drying inside the drying chamber was also revealed

    為解決這一難題,本文利用氣體一顆粒兩相流理論和計算流體力學( cfd )技術,建立了更符合實際噴霧乾燥過程的數學模型即噴霧乾燥的cfd模型,並進行了脈動燃燒噴霧乾燥過程模擬,其主要內容如下: ( 1 )建立了脈動燃燒噴霧乾燥的cfd模型該數學模型建立在氣體一顆粒兩相流基礎之上,用標準k -模型預測乾燥室內的氣體湍流運動過程,顆粒軌道模型追蹤乾燥室內顆粒群的運動軌跡,熱質傳遞模型描述空氣和液滴的熱質傳遞過程。
  10. The primary problems existing in industrializing large - scale distillation equipments are pointed out, the magnifying & energy saving distillation technology developed by tianjin university, such as low liquid - level gradient technology, uniform liquid - vapor distribution technology, anti - clogging technology and a series of tower internals technology, on the basis of modern mass transfer theory hydrodynamics calculation hydrodynamics & process system engineering theory, axe introduced

    針對蒸餾裝置大型化過程中面臨的問題,本文提出了蒸餾過程大型化理論和節能策略,開發出了低液面梯度技術、氣液均勻分佈技術、抗堵塞技術以及與此配套的一系列塔內件技術,形成了關鍵技術的系統集成,顯著降低了過程能耗。
  11. According to the theory of engineering thermodynamics and phase change, heat - transfer process of the special working fluid heat - pipe stove is analyzed. some hypotheses are postulated and with the help of equation of mass - conservation, energy - conservation, the dynamic concentrative parameter model is built, the change of each parameter is prescribed at any stage from starting to stopping. with the thermodynamic calculation of burnable process, the parameter of device, such as heat - transfer coefficient / thermal efficiency etc, are achieved under steady state ; based on theoretic calculation, observing the actual running circumstance of the heating stove in person, with some performance comparison between the new and the old, the high efficiency and reliability of heat - pipe stove is proved, the project which expend it in the oil - filed is feasible

    對充入該工質的熱管加熱爐,本文根據工程熱力學和相變傳熱學及相關知識,對其進行了傳熱分析,經過適當假設,運用質量守恆和能量守恆定律,建立了裝置動態集中參數模型,描述了加熱爐從開機到穩定運行這一動態過程各參數的變化情況,同時對燃燒過程也進行了熱力計算,最終得到了穩態工況下裝置的換熱系數、熱效率等熱力參數;在理論計算的基礎上,親赴現場觀察該爐的實際運行情況,通過與原有的加熱爐的各項性能進行對比,最終證明新爐的高效性和可靠性,為其在油田中推廣的可行性提供了依據。
  12. Mass transfer theory

    質量轉移理論
  13. Upon the concentration distribution of the ammonia water mixture in liquid bulk during absorption, two analysis methods were established. one is based on optical fundamental theory of the interference fringes phenomenon. the other is based on the calculation of mass transfer equation

    一種方法是利用光學基本原理,通過對干涉圖像的解析得到液體內部濃度分佈;另一種方法是通過對定常和非定常邊界條件下的質擴散方程求解,得到液體內部濃度分佈。
  14. The fractal theory of heat and mass transfer in porous material

    多孔介質傳熱傳質分形理論初析
  15. In this dissertation, the influences of the irreversibilities of heat and mass transfer, the irreversibility inside a cyclic working fluid, heat leakage and otlier irreversible effects on the performances of three - source thermodynamic cycles are studied. by using the methods of finite - time thermodynamics and optimal control theory, the fundamental optimal relations and a series of performance bounds for the concerned thermodynamic cycles are derived

    本文研究傳熱不可逆性、傳質不可逆性、工質內部不可逆性及熱漏等不可逆因素對三源熱力循環性能的影響,應用有限時間熱力學和最優控制論等方法,導出相關熱力循環的基本優化關系和一系列性能界限。
  16. The heat and mass transfer theory in the porous media and wood fields was studied, and introduced in detail to find a promising method in the process of particles drying with convection

    摘要詳細介紹並歸納多孔介質與木材領域內的傳熱傳質理論研究概況,從中尋找出適合研究刨花對流乾燥過程傳熱傳質的方法。
  17. A theory study of heat and mass transfer in wet porous media by high - intensity heating

    多孔介質高強度傳熱傳質的理論研究
  18. On the basis of chemical transfer theory, the transfer mechanism was studied for the process of adsorptive bubble separation and the mathematical model describing the axis diffusion in continuous foam column and basic equation about the rate of mass transfer are set up

    以化工傳遞理論為基礎,研究了吸附泡沫分離過程的傳質機理,建立描述該傳質過程速率的基本方程及軸向擴散連續泡沫分離塔數學模型。
分享友人